Mega Meet 2014 Calibrating for Performance and Competition.

Slides:



Advertisements
Similar presentations
OBJECTIVES After studying Chapter 2, the reader will be able to:
Advertisements

Engine Control Units A look at technology in the Automotive Industry.
An Introduction to EV Wiring By Charlton Jones Gateway EV Washington, MO.
Diagnostic procedure Training for the future. So, where do we start? Diagnostic Procedure.
The Smart Battery Assembly Process
ECG ELECTRON COMBUSTION GRAPH FOLLOW THE BOUNCING ELECTRON
Engine Electronic Controlled. Ignition systems THE CONSTANT ENERGY IGNITION SYSTEM DIGITAL (PROGRAMMED) IGNITION SYSTEM DISTRIBUTORLESS IGNITION SYSTEM.
Case Study – Application of Sensors in measuring torque and thrust produced by propellers in small unmanned quad-rotor helicopter.
Lecture 251 DC Measurements. Lecture 252 DC Measurements DC Measurements include current, voltage, resistance, and power. Section 2.8 should be titled.
Engine Team Status Update February 17, 2009 Jimmy HreskoMike Lin Scott KunzSamihan Yedkar Arianna GoldenMike Velez Costas Akrivoulis.
Fuel Evaporation in Ports of SI Engines P M V Subbarao Professor Mechanical Engineering Department Measure of Useful Fuel …..
5 Gas Analysis Another Rainharbor Production 1997.
Components, Quantities, and Units
What is a scope? Essential tool for automotive diagnostic and fault finding. Ideal for viewing and testing most automotive sensors and circuits. Captures.
1 Advanced D-TAC Testing. 2 D-TAC testing – Part 2 This presentation is meant to be viewed after the introductory presentation ‘D-TAC testing – Batteries.
2013 NATEF Task Area A-8 Engine Performance A. General Engine Diagnosis & Testing B. Computerized Engine Controls C. Ignition System Diagnosis &
Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.
INGAS 6 months Meeting, Prague, May, 2009 INGAS INtegrated GAS Powertrain 1 CVUT-JBRC Scope Experimental Facilities – General Features – InGAS Customizing.
Ignition Systems Purpose: to produce a high voltage surges, delivered at the correct time and the correct spark plug for different operating conditions.
Automotive Engine Performance, 3/e By James D. Halderman Copyright © 2010, 2007, 2003 Pearson Education, Inc., Upper Saddle River, NJ All rights.
CS-EE 481 Spring Founder’s Day, 2006 University of Portland School of Engineering Electric Vehicle Drive System Authors Steven Arlint Abdullah Binsaeed.
Engineer Training RTRun – Real Time Software TJ8300 / TJ8500 RTRun – Real Time Software.
ADVANCE IN AUTOMOBILES HYDROGEN FUELLED ENGINES BY C.SUBRAMANIAN, 10MECH50, III-MECH, VCET,MADURAI.
Scope Richard Crowder. E 3 AN  Electrical  Electronic  Engineering.
INGAS meeting, Naples, Nov INGAS INtegrated GAS Powertrain 1 Continental Automotive GmbH Advanced development (AD) at INGAS SPA2 Meeting
Automotive Engine Controller with PC User Interface Jason Dougherty.
Engine Management Systems and Calibration
GEN1 Fuel Mapping Overview Engine RPM Throttle Opening % Active Cell Active Cell RPM Active Cell Throttle Position Active Cell Map Compare ( See “Map Comparing”
ENHANCED AUTOMOTIVE TECHNOLOGY (a division of M. D’Sylva Consulting) Performance software for Motronic ECU’s, and custom dyno tuning 500 hp inertia dyno.
Hydrogen IC Engine Conversion Project. Project Aim/Brief Design, build and implement a simple engine management system to allow an otherwise unmodified.
PHSAUTOMOTIVESALSPHSAUTOMOTIVESALS Tune-up Procedure.
Some Problems and solutions related to Lecture 1 Problems related to scientific notation Lecture 3 Q 1.
Electronic Instruments
Electrical Testers Basic test equipment used in today’s shops may include an analog type meter, a VAT (Volt-Amp-Tester), DMM (Digital Multimeter),
FSAE Engine Management System Adolfo Pereira Donald Zucaro Lee McDade Jeremy Belge Sun-Jet Liu Marcin Trelinski Advisor: Dr. Alan Nye Sponsor: FSAE Formula.
Coil on Plug: The Wired Differences 2011 ICAIA Fall Conference Ranken Technical College, St. Louis, MO Matt Dixon, Assistant Professor, SIUC.
Re-Engineering a 2015 Polaris Indy 2016 SAE Clean Snowmobile Competition Presented by: Pryce McDaniel, Josh McCoy, Mike Waloch 3/7/16.
Flow Characteristics of Port Fuel Injection System P M V Subbarao Professor Mechanical Engineering Department Matching of Injector with Engine Requirements.
 A multimeter is tool that measures electrical currents. It is a combination of many different measurements in one tool.
Using a Mulitmeter A digital multimeter is a test tool used to measure two or more electrical values—principally voltage (volts), current (amps) and resistance.
Iowa State University Clean Snowmobile Club Iowa State University 2016 Clean Snowmobile Challenge.
Advanced Engine Performance Diagnosis, Fourth Edition James D. Halderman Copyright ©2009 by Pearson Higher Education, Inc. Upper Saddle River, New Jersey.
MGT 311 Week 1 DQ 2 What type of assessments and evaluations might you use to determine the characteristics of your employees? Does the type of tool used.
Diagnostic Equipment and Special Tools
Diagnosing & Repair Late model vehicles (OBD II) can be checked with the scan tool for the following problems: Crankshaft Position Sensor Crankshaft Speed.
A diesel truck equipped with a JWAC (Jacket Water Aftercooler) has low power under load. Which of the following could be the cause? A Leaking JWAC (Jacket.
·QUALITY·COVERAGE· ·AVAILABILITY·
Ethanol: the Need for pHe Controls in the New Millenium
Components, Quantities, and Units
ECE 3301 General Electrical Engineering
Re-Engineering a 2015 Polaris Indy
Figure 15.1 Many fuel-control oxygen sensors are located in the exhaust manifold near its outlet so that the sensor can detect the presence or absence.
Oscilloscopes and Graphing Multimeters
Progressive Shift Parameters Worksheet
Clarkson Winter Knights
Electronic relay ER/U 1.1 contact TU/W 1.1 US/U 4.1 ER/U 1.1
Electromagnetic Induction
GTO, Mustang and Charger bring back the Big-3's war of horsepower.
CHAPTER 49 On-Board Diagnostics.
Inverters Converting dc to ac
Computers Chapter 17 Lesson 4.
University of Wisconsin-Platteville CSC CI Team
Actuators Chapter 17 Lesson 5.
Reg 85: Measurement of Net Power
Electromagnetic Induction
Automotive Technology Principles, Diagnosis, and Service
Oscilloscopes and Graphing Multimeters
Automotive Technology Principles, Diagnosis, and Service
Automotive Technology Principles, Diagnosis, and Service
Automotive Technology Principles, Diagnosis, and Service
Presentation transcript:

Mega Meet 2014 Calibrating for Performance and Competition

Scott Clark Calibration Engineer (Tuner) Custom engine mgt. 10 years MS experience 20+ systems

Successful Racing: Time Talent Resources

TOOLS & SKILLS Multimeter – Continuity – Voltage – Resistance – RPM, DC Oscilloscope – Crank/Cam Position signals – Actuators (Injectors, Ignition)

Project Roles Electronics and Tuning Chassis Engine/Mechanical Project Management / Crew Chief Driver (if absolutely necessary) You might be all of these but the responsibilities are the same!

Testing Bench – JimStim! Dynamometer – Ignition – full RPM and load range – Fuel system – leaks, weird behavior, heat soak, etc. Limited testing – Datalogs – prior runs or ECUs

Examples EMC 2012 – 385ci Early Hemi YOUTUBE LINK HEMI EMC 2013 – 428ci Pontiac YOUTUBE LINK PONTIAC

Examples 2 LSR Charger Daytona YOUTUBE DAYTONA

Charger Bonneville Data

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.