hotEx Radius Manager Installation

hotEx RADIUS Manager Network Diagram

Client PC

Connect client PC connection diagram XX

Note: Use WAN IP Address (Public Static IP), when you configure the Hotspot Client Gateway

Note: If the ‘hotspot location’ does not have a Public Static IP number or domain name, you may enter “ /0 ”.

HotSpot Client Gateway Installation

HotSpot Client Gateway Network Diagram

 You are now going to convert Linksys router as a hotspot client gateway, using the Laptop/PC.  Switch On the Linksys router.  Ensure the WiFi network adapter of the Laptop/PC is enabled and working, and set it in DHCP Mode (i.e., ‘Obtain IP Address automatically) as shown below. After Setup the Linksys, Open the browser (e.g.: Internet Explorer) and enter the ip “ ”. You will see the login prompt. Type the User name and Password (default password is admin) and Click Ok. Installing hotspot client gateway

After 3-4 minutes, you will see the message “Upgrade Successfully”. (It is very important to wait for this message. Do not go further until you see this message), Click Continue.

Note: After installing the configuration files the Hotspot client Gateway will be automatically rebooted.

Enter your hotEx RADIUS Manager Server IP address. Preferably, this would be a Public Static IP

The shared key highlighted in this screen, must be the same, with the menu of "hotEx RADIUS Manager -> HOME -> ADD NAS - > NAS Client Location -> SECRET"

Enter your hotEx RADIUS Manager Server IP address. Preferably, this would be a Public Static IP

When the hotEx RADIUS is ready, you would have assigned an IP from it. To confirm, please go to Start  Run  Type “cmd”  Type “ipconfig”. To make double-confirmation on the IP assignment, you can use the dos commands “ipconfig /release” and “ipconfig /renew”

Now, you are logged in successfully and you can start using Internet

To logout, please enter “ ” or “ ” in the browser.