ELECTRONIC IDEAS UPS INNOVATIVE ALTERNATE POWER TECHNOLOGY DAWN – ELECTRONIC IDEAS INNOVATIVE ALTERNATE POWER TECHNOLOGY ELECTRONIC IDEAS INNOVATIVE ALTERNATE POWER TECHNOLOGY

Eskom has always been the only power supplier to our industry, the export market and municipalities who in turn resell to our domestic consumers. Over the last 5 years the power generated in Gig watt-hours has been increasing massively each year. With the increased demand for power by the growth of our economy we project the demand based on the average generation over the next five years to far exceed the savings as requested by Eskom – the amount generated not being sufficient to cover projected demand _______ The present 10% savings would, in fact, result in an increased demand over the next few years. This will directly influence businesses and there will be an increase in the time factor to offset the 10% demand. This is how we see it based on a 2 hour saving: _______ 2 hours 25 Hours 2.5 to 3 Hours 3 to 3.5 Hours 4 Hours

YOUR ELECTRICITY PROBLEM SOLVED O ur solution is based for the industry as our product has the following value added benefits: Pure Sine Wave This means clean and stable power in which all electrical items would function normally There are modified sine wave inverters but these would not guarantee that all equipment would work as there are some items that are not compatible with this kind of wave, and over time this would damage the equipment. Switching over from electrical power to UPS in under 4 milliseconds This ensures that computers and all the other equipment function normally when the lights go out due to load shedding or any other electrical occurrences, thereby protecting the equipment from unnecessary loss of data or even complete failure. Automatic reset load switch In the event that the unit is overloaded it would switch off, and once the load is within operating range, would automatically reset and supply power to all the equipment for which it was originally intended. This is to protect the batteries and the unit from unnecessary malfunctions

UPS sizes vary according to work loads Every office/work environment will be measured at the Distribution Board to determine Its electrical consumption and a unit will be installed to handle the measured workload. AVR – Automatic Volt Register This controls all the surges that occur in our power supply and keeps a control so that the equipment will not be subjected to any power surge. This is beneficial when the normal power is on, as this will create a buffer for any surge from Eskom, thus extending the lifespan of the equipment Solar Power Enabled In the event of the consumer choosing to be environmentally friendly, a solar panel based on the size of the equipment can be installed to have power to recharge the batteries. When the batteries are fully charged the power will filter through to the equipment, thereby not using the batteries at all. The new price increase will make this type of electricity very affordable.

Cold Start This means that in the event where all the units are switched off and the power was load-shed, you can start the equipment on the UPS and the power consumption from cold start can be handled by the UPS. Most UPS’ will not allow you to switch anything on if they weren’t operating before the power failed. Short Circuit and Overload Protection Since we install the unit to the distribution board, short circuits will be handled at the distribution board, and as a protection we also have short circuit and overload protection built into the UPS unit. Recharging is quick and stable (recharging 20 amps) The recharging time, based on the size and number of battery banks is usually fast and clean as the unit can be personalized to each customers requirements. The norm is between 20 and 35 amps therefore allowing the unit to charge in the shortest time and be in readiness for the next shutdown.. No noise, no fuel, no expensive service Our unit is unlike a generator as there is no irritating loud noise, there are no expensive fuel bills and, guaranteed, no expensive services or unnecessary downtime due to breakdown or maintenance.

SCOPE OF APPLICATION / USAGE: YOUR ENTIRE BUSINESS AS IF LOAD SHEDDING DID NOT OCCUR

Maintenance There is a choice of maintenance agreements available to suit the customer Warranty A warranty of 3 years will be issued with every unit BATTTERY SPECIFICATIONS We are currently using an AGM or starved electrolyte battery. This was invented by Concorde Battery Corporation in the USA and was classified for a number of years as it was used in the US Defense force for the F/A-18, F-117A (Stealth), and C-130 and later for the Learjet, Citation. This battery has a life span of between 5 and 15 years, and has a cycle life of over 600 cycles based on the usage.

Installation The UPS will be installed into the DB by a qualified wireman and a certificate of compliance will be issued for insurance purposes. This will avoid unnecessary electricity cables being in walking isles and corridors, avoiding electrocution and the possibility of falls. All UPS warning labels will be correctly displayed on the distribution board cover to avoid accidents.