Brief Introduction Fired Brick Autoclaved Brick §6.2 Wall Bricks.

Slides:

Advertisements

Similar presentations

Enzyme Stabilized Mud (Earthen) Construction using DBV-1

Advertisements

Euro-Zel th International Symposium Advanced Composite Materials for the Railroad cars Presented by Irina Garustovich Moscow State University of.

Outline CH1.Introduction CH2.Preliminary Design CH3.3D Model.

R1.3 RESP1.3 RESPONSE OF CIVIL ENGIONEEONSE OF CIVIL ENGINEERING PROJECT 1.3 RESPONSE OF CIVIL ENGINEERING PROJECT 1.3 RESPONSE OF CIVIL ENGINEERING PROJECT.

Graduation Project Thesis: Structural Analysis & Design of “Al-Mansour Mall”

2.2 STRUCTURAL ELEMENT Reinforced Concrete Slabs

An-Najah National University

Design of Concrete Structure I

Lecture 9 - Flexure June 20, 2003 CVEN 444.

FOUNDATIONS. Components Footings Trench Formed Keyway Stepped Fireplace.

CHAPTER 9 MASONRY.

Commercial Wall Systems If a building looks better under construction than it does when finished, then it's a failure. -Doug Coupland.

Masonry Design. 2 MASONRY WALLS CONSTRUCTION TYPE Single Wythe Cavity Prefabricated Barrier Masonry Veneer Masonry Bonded Hollow Wall.

Lecture Goals Slab design reinforcement.

Foundations and Footings

ONE-WAY SLAB. ONE-WAY SLAB Introduction A slab is structural element whose thickness is small compared to its own length and width. Slabs are usually.

Chp.12 Cont. – Examples to design Footings

Masonry Masonry refers to construction by stone or brick “masonry units” with mortar, and is divided into two types: Exterior and Interior.

Common Architecture Terms. Fenestration The design and placement of windows in a building.

Bricks Introduction Structural member Load transfer medium

PPT-Lecture Example Here below is a short example how I use Powerpoint for lecture presentation. Sometimes music and animation are used to invoke a better.

Barrios Laura Bigott Dairet Vertical structure Solid Defines an area Delineates a building Types of walls: Load-bearing wall: supports.

Topic C1 Superstructures - walls

BEAMS,COLUMS AND LINTELS

COLUMNS. COLUMNS Introduction According to ACI Code 2.1, a structural element with a ratio of height-to least lateral dimension exceeding three used.

Structural Systems CM 105. Precast Concrete Framing Offer exceptional strength and resistance to seismic stresses and high degree of fire safety Concrete.

Types of Mortar Types of walls Qualities of different mortar types Where you would use different types of mortar Mixing ratios for mortar types.

1 HVACR116 – Trade Skills Plan Views Elevations Plan Views Elevations.

© 2010 Delmar, Cengage Learning Instructor Resources for Lesson C Material Basics.

BUILDING CONSTRUCTION 2014 / 2015 SESSION SS2. TOPIC : WALLS Walls are vertical erected structure of a building, the width i.e length exceeds four times.

Chapter 5 Construction Mortar.

FOOTINGS. FOOTINGS Introduction Footings are structural elements that transmit column or wall loads to the underlying soil below the structure. Footings.

Introduction Small-size Hollow Block Fly Ash and Silicate Medium- size Block §6.3 Wall Blocks.

Chapter 6 Wall Material. Introduction  Wall plays roles of load-bearing, enclosure and separation  Wall material is very important in buildings for.

© 2006 ITT Educational Services Inc. CD230 Architectural Design & Drafting: Unit 4 Slide 1 Unit 4 Brick, Stone, Steel, and Concrete Construction.

Chapter 9.  Technical Requirement Technical Requirement  Technical Index Technical Index Chapter Technical Standard of Bituminous Mixture §9.5.

Earthquake Load Some Basic Definitions:

Technical requirementsTechnical requirements –Resistance to corrosion –Frost-resistance –Thickness protective layer of marine reinforced concrete –The.

Eurocode 1: Actions on structures – Part 1–2: General actions – Actions on structures exposed to fire Part of the One Stop Shop program Annex A (informative)

Design of Recuperative Heat Exchanger Presented by -- Jinying Zhu.

Chapter 4 Ordinary Concrete. Binding material Concrete Portland cement concrete concrete Gypsum Concrete Asphalt Concrete In Portland cement concrete,

Air Hardening Inorganic Binding Materials Binding Materials Chapter 2.

Integrants: Arliss Delgado Ricardo Uzcategui Universidad Simón Bolívar Ingles para arquitectos y urbanistas II.

Chapter 6 Wall Material. Introduction Small-size Hollow Block Fly Ash and Silicate Medium- size Block §6.3 Wall Blocks.

HVACR116 – Trade Skills Plan Views Elevations. Plan Views.

Chapter 5 Construction Mortar. There are two methods to design mix of mortar  Consult table–based on experience  Calculation–consult with JGJ

1 Presentation 16: WALL TYPE IDENTIFICATION. 2 Walls versus Partitions Walls –A general term for a vertical building component used to support loads and.

DESIGN OF SINGLY REINFORCED BEAM

Practical Design of PT Buildings

Tushar Deshmukh Vishal Makwana Vaibhav Kanadia Jigar Soni Guided by:-

Foundation Failure. Foundation movement may result from a wide range of factors, which can include: Shrinking or swelling of clays caused by changes in.

Strength and Stability Questions

BUILDING CONSTRUCTION 1

Commercial Wall Systems

الجزء الثالث دراسة السوق.

Building Construction

Outline CH1.Introduction CH2.Preliminary Design CH3.3D Model.

Arch205 building construction wall systems

By :Dr. Aeid A. Abdulrazeg

2.2 STRUCTURAL ELEMENT Reinforced Concrete Slabs

" multifunctional building design"

Chapter 13 Concrete Form Design.

Presentation transcript:

Brief Introduction Fired Brick Autoclaved Brick §6.2 Wall Bricks

Fired Brick Fired Common Brick Fired Hollow Brick Fired Porous Brick

Limit to use small size heave weight energy inefficiency lots of soil consumption Fired Common Brick Fired common brick is small size, heave weight, energy inefficiency and lots of soil consumption. So, it is used under strict regulations now.

Technical standard: GB Appearance, size, strength, weathering- resistance must meet its demands Strength Grade It can be divided into five grades according to f ave and f k or f min f k= f ave -1.8S Fired Common Brick

Formula variable coefficient standard deviation Fired Common Brick

Permit to use Fired Hollow Brick Fired Porous Brick light- weight Contain less clay Fired porous brick and hollow brick are light weigh and contain less clay. So, they are permitted to use now.

It is fired, mainly made up of clay Hole rate is 15% at least It has  many tiny holes  hole and pressed side are vertical

By appearance, size, Strength grades, durability Top-rate First-rate Qualified-rate Technical standard: GB By appearance, size, strength grades, durability It is classified into: top-rate, first-rate and qualified-rate

By compressive strength, flexural load Mu30Mu25Mu20Mu15Mu10Mu7.5 By compressive strength and flexural load It is classified into 6 strength grades(Tab.6.2.1)

Tab Strength Grades of Fired Porous Brick product grades strength grade compressive strength （ MPa ） flexural load （ KN ） the minimum of average value the minimum of minimum value of single the minimum of average value the minimum of minimum value of single top-rate first-rate qualified- rate

Applications Fired porous brick can be used in load-bearing structure below six floors.

Fired Hollow Brick  The process and material are the same with the above one.  Hole rate is 35% at least  It has  little big holes  hole and pressed side are parallel

1-Tip Side, 2-Large Side, 3-Bar Side, L-Length, b-Width, d-thickness 4-Rib, 5-Concave-line Slot, 6-Ektexine

Apparent Density Technical standard: GB By apparent density It is classified into: 800, 900 and 1100

Strength Grades Technical standard: GB By compressive strength average value of large side, bar side and minimum value of single It is classified into three strength grades: 5.0, 3.0 and 2.0.

Product Grades Technical standard: GB By appearance, size, strength grades, durability It is classified into: top-rate, first-rate and qualified-rate(Tab.6.2.2)

Tab Strength Grades of Fired Hollow Brick Product Grades Strength Grades Compressive Strength of Large Area （ MPa ） Compressive Load of Bar Area （ MPa ） the minimum of average value the minimum of minimum value of single the minimum of average value the minimum of minimum value of single Top-rate First-rate Quanlified- rate

Applications  Fired hollow brickcan be used in non-load-bearing wall, such as  Fired hollow brick can be used in non-load-bearing wall, such as  interior partition of multi-layer structure  filling-wall of frame structure