2G BBULBE PASS Instructions-5 Replacement of Heater

Heater

Instructions 1. Take off water inlet and outlet fittings 2. Deflate spa 3. Remove cord grip with screwdriver 4. Remove the air pipe

5. Take out control box from spa pool 6. Remove the foam 7. Loosen the screws on the top lid 8. Remove the top lid Instructions

Instructions Bubble Power input Transformer input Heater Filter Transformer output 3 PIN- water switch 2 PIN - Sensor

9. Disconnect the wires 10. SPA power panel 11. Remove the middle part of control box hull 12.Replace the heater Instructions

13. Assembly the middle part of control box hull 14. Connect the wires 15. Put the top lid of control box 16. Put on the foam Instructions

17. Assembly the control box 18. Pull out the air pipe through spa tub 19. Connect the check valve with spa tub 20. Screw back water inlet and outlet tightly Instructions

Please give your valuable opinion!