Oasis Wildlife Water Systems announces a limited time and limited quantity offer! We have ten 100 gallon tanks that can be converted directly into fill.

Slides:

Advertisements

Similar presentations

The idea evolved from two different contractor customers who shared with us a better way to perform hydrostatic testing of DWV piping system. Two different,

Advertisements

Operation of the FW-720 Unit 1. Side 1 2 Inlet Hand Crank.

Responder FW-60 Operation of the FW-60 Unit. Components 2 Solar Panel Spare Filters Power Supply Spare UV and Quartz Sleeve 12 Volt Pig-tail Hoses Strainer.

Automobile Engine NO.4. NO.1 Mercedes-Benz E-class.

Engineer Training XL1200 Ink System. Engineer Training XL1200 Ink System Confidential 2 Ink System The XL1200 Ink System consists of the following elements:

 Established in 1995  Located in Wilmington, NC with a 40,000 Sqft facility.  Specializes in the design and manufacturing of connection solutions. 

Connecting to industry. Fittings for Steam Hose Remember Steam is……… minimum 212 F.

ENVIRONMENTALIST II-B WATER RECLAMATION SYSTEM. GENERAL INFORMATION EV II-B A compact water recycling system designed to reduce water consumption and.

Drip Irrigation presented by Pat McCormick Feb 25, 2014

3.7.6 Student Book © 2004 Propane Education & Research CouncilPage Identifying Procedures for Conducting Container Vapor Flaring Operations Before.

Caged Tanks for Pesticides: Terminology, EPA Regulations and Pesticide Labels Rinsing and Recycling Caged Tanks Nancy Fitz Chemical Engineer U.S. EPA Office.

Gathering Oil From the Fields

Boating is fun… we’ll show you how America’s Boating Course 3 rd Edition 1Trailering Chapter 4 Section 14 >>

LESSON TWO BEFORE YOU GET UNDERWAY. Key Topics Vessel’s capacity Vessel’s capacity Float plans Float plans Fueling a vessel Fueling a vessel Trailering.

2.3.9 Student Book © 2004 Propane Education & Research CouncilPage Identifying Procedures for Purging Containers & Injecting Methanol Prior to.

GO ORDNANCE !!! ORDNANCECORPS 1 Antenna Mast Group We will now trace the electrical circuits of the antenna mast mast group. Be fore we get started you.

Bench Testing, Maintenance, and Troubleshooting.  Identify three primary steps in bench testing a helitorch.  Identify six considerations in maintaining.

The DB In-Line Pumpout Unit Easy-to-use control panel with one switch to run the unit. 15 AMP reset fuse. 115 AC External water pump and tank drain have.

Power-Fill Operation Demonstration Power-Fill Operation Demonstration (See Installation and Operation Manual for detailed instructions)

1 Math Questions. 2 Length x Width x Water Depth = cubic feet.

Dennis Sabre Fire Appliances

PEUGEOT 206 INSTALLATION 99’— 05’ TU5JP4

Intro to Fluid Power Topics What is fluid power? Where is it used?

Pipe Fittings. Purpose of Pipe Fittings  Plumbing fittings have different shapes which allow rigid straight pipe to change both direction and diameter.

Equipment Familiarization Amatrol 850 Basic Hydraulic Training System

The Pennsylvania Department of Agriculture Division of Milk Sanitation in Cooperation With The Pennsylvania Milk Marketing Board Bulk Milk Farm Pickup.

MODULE 7 Unload a Cargo Tank Motor Vehicle (CTMV).

3.2.2 Student Book © 2004 Propane Education & Research CouncilPage Performing DOT Cylinder Evacuation and Vapor Flaring Operations Before DOT cylinder.

Connecting to industry 1. 2 Safety Break-away Couplings.

CD Ozone (oxidation) Ozone is produced with a high voltage electrical discharge called a “corona discharge” or “CD”. The idea is to actually create a small,

3.7.5 Student Book © 2004 Propane Education & Research CouncilPage 1 A full understanding of the operation of the liquid evacuation process if essential.

FILTRATION Presentation on FILTRATION. Introduction What is filtration? Why is filtration important? What are filter media? Can you name different types.

Water Supply Skill Drills.

Connecting and Using Implements with the Tractor Set 5 Marissa Morton SAAIP.

EMISSION PROBE PARTS TUBE: 3/8” OD x wall Stainless Steel Length determined by pipe diameter and placement of connecting end to allow easy connection.

SIP POU cooler Installation Guide. Getting Started The SIP 2000 can be easily installed in most POU coolers in just a few minutes. The tools needed are.

Tank plumbing 250 Telone 1/2013. Dip tube connection on Left Nitrogen Connection on Right.

Eco-Winter Installation. – Step 1 – Mount Eco-bypass to water heater.

3.5.9 Student Book © 2004 Propane Education & Research CouncilPage 1 Although unloading a bobtail cargo tank in metered delivery service at the bulk plant.

14.52 in Attach the Axle to the chassis using the four (4) bolts, washers, and nylon lock nuts. Mount the tires. Note: The wheel recess outside on the.

CHAPTER Fuel Pumps, Lines, and Filters 22 Copyright © 2016 by Pearson Education, Inc. All Rights Reserved ADVANCED ENGINE PERFORMANCE DIAGNOSIS Advanced.

3.3.4 Student Book © 2004 Propane Education & Research CouncilPage Operating a Dispenser to Fill DOT Cylinders by Volume DOT cylinders are designed.

TAP LINE CLEANING MDP. Safety and Safety Gear  Do not use hot water to clean your beer lines. This will cause the lines to misshape and break, and could.

1 HVACR316 - Piping Copper Tubing and Fittings. 2 2 Safety Refrigerant cylinders should be stored and transported in the upright position to keep the.

CLM Maintenance. Covers : 1 - Side cover, 2 - Back cover, 3 Top cover, 4 - Lamp door, 5 - Side cover input and communication side, 6 - HEPA dust filter,

3.1.8 Student Book © 2004 Propane Education & Research CouncilPage Identifying Procedures for Conducting Container Vapor Flaring Operations Before.

3.6.3 Student Book © 2004 Propane Education & Research CouncilPage 1 Personnel who perform tank car unloading operations must comply with company operating.

Coolant Fill Coolant Check and Fill. Oil Fill & Dip Stick Main Engine Oil Fill Dip Stick Delo 400 – 40 wt. Engine Oil.

Engineering Evaluation Unit Monitoring and Laboratory Division California Air Resources Board (916) ABOVE GROUND STORAGE TANK (AST) VAPOR RECOVERY.

STEP 1 Locate the transmission cooler line connection on the vehicle. Identify the correct adapters to be used by referring to the vehicle application.

 Measurement of difference in potential energy between 2 locations in a circuit.  Also called potential difference  Measured in volts (V)  Drives.

Pipe Fittings Purpose of Pipe Fittings  Plumbing fittings have different shapes which allow rigid straight pipe to change both direction and diameter.

EBS-1 # COOLANT FLUID EXCHANGE QUICK REFERENCE ATTENTION: Using the Coolant Fluid Exchange requires the FILL and VAC Valves on the SERVICE.

V OLTS, C URRENT, AND R ESISTANCE What are they? And how do they work?

PostBase Automatic Feeder Component Removal Service Training

XTO Energy Safety Training

14 Refrigerant Recovery, Recycling, and Recharging.

FIGURE 9-1 The main parts of a vehicle’s heating system are the heater core, blower, heater hoses, and, in some cases, heater valve. (Courtesy of Everco.

FIGURE 33-1 A typical fuel tank installation.

2.2 Gallon TourTank Installation

Chemical Transfer.

EXAMPLE-#1 Connection at Meter Service

Autogas Infrastructure Simple, Scalable, and Affordable

State of Georgia BASIC FIRE FIGHTER TRAINING COURSE

Water-saving Shower Faucet

Instructions: Adding refrigerant fluid to system

After service guide for changing PCB

Automotive Technology Principles, Diagnosis, and Service

Presentation transcript:

Oasis Wildlife Water Systems announces a limited time and limited quantity offer! We have ten 100 gallon tanks that can be converted directly into fill tanks to be used In transporting water for filling your Oasis Wildlife water devices on your ranch or lease. These are the same heavy duty, polyethylene tanks found in our water devices. We are offering these tanks at a big discount and are equipping them with control valves or dc pumps. With the control valve you can gravity feed 100 gallons of water into your Oasis Wildlife tank simply by connecting a water hose to the end of the control valve. Drop the other end of the hose into your water device and open the valve! In a matter of minutes you have transferred the water from the fill tank to your water device. If you need the pump system it operates directly from you trailer hitch connections. Connect the water hose as noted above, plug the pump into your trailer hitch, and the pump will do the rest. This system works very well when the top of the water device is above the bottom of the fill tank in your truck or trailer! When the transfer is complete, simply disconnect the pump, close the control valve, and remove the garden hose.

100 Gallon Fill Tank w/control valve As you can see we attached the control valve assembly into the existing ½” NPT fitting in the tank. Attach a garden hose to the male garden hose thread and place the other end of the hose into the water device. The shorter the hose the faster the water transfers! When the transfer is complete, simply shut the valve, remove the hose, and store the fill tank.

100 Gallon Fill Tank w/pump As you can see we attached the pump assembly into the existing ½” NPT fitting in the tank. a garden hose to the male garden hose thread and place the other end of the hose into the water device. The shorter the hose the fast the water transfers! Plug the pump wiring harness into your trailer wiring connector. On certain truck models you may need to turn your headlights on for power to the pump. When the transfer is complete unplug the pump wiring harness, shut the valve, remove the hose, and store the fill tank.

We are offering these tanks at the following prices from our Burnet, TX manufacturing location: 100 Gallon Poly Tank with control valve: $ Gallon Poly Tank with dc pump: $ Again we only have ten of these units available for sale with first come, first served. Contact us at or call