©2008 Sponge-Jet Inc. All rights reserved. 1 Removing Fire Damaged Coatings in Power Plant Mill fire damaged paint on pulverized fuel line Blast area covered.

Slides:

Advertisements

Similar presentations

Removing Coatings and Cleaning Masonry Substrates

Advertisements

Work Smart. Is our vessel ready on site Or has there been a delay.

Single Coat 100% Solids Tank Linings SPECIALTY POLYMER COATINGS, INC. Single Coat 100% Solids Tank Linings.

Preparing a Coating Inspection Plan

MarineMend Repair Kit Procedure

Ahead in abrasives. Introduction Eurogrit BV Eurogrit’s head-office in Papendrecht The Netherlands.

International Paper - Riegelwood Plant Riegelwood, NC

Why use surface preparation to enhance aesthetics in concrete repair?

SYNTHETIC RED OXIDE METAL PRIMER It has good anti-corrosive properties. It contains Zinc-chrome. Recommended for agricultural, steel structures & other.

Steps to a More Effective Power Tool Cleaning Presented by: Earl Bowry, Jotun Paints, Inc.

RoboBlast USA Abrasive Blast And Vacuum System “ABAVS” Welcome to RoboBlast USA Abrasive blasting hasn't been very exciting...until now! Call Us at

30529 East Mill Run Milton, Delaware Fax Bruce R. Moore.

Quality from start to finish Abranet Soft

6/11/ Module 3 Safe Work Practices. 6/11/ Module 3 Overview High risk practices to avoid Safe work practices and safe work practices toolkit.

Technical Program: Tanks, Tanks and More Tanks “STEEL WATER STORAGE TANK MAINTENANCE” Maine Water Utilities Association Conference No. 490-April 12, 2007.

Coal Burning System.

Busting The Myths of Wet Abrasive Blasting

Installing Quality Internal Tank Linings: A Perspective David Cushman West Virginia Paint LLC General Manager NACE Certified Coating Inspector #1591 Copyright.

RIVERINA SEALING SOLUTIONS INDUSTRIAL ANTI-ABRASIVE “ I.A.A.™” Abrasion and Corrosion Protection of Industrial Plant and Machinery.

October Module 4: Review of Prohibited Practices, Personal Protective Equipment and Dust Control Overview: Prohibited practices. Protect yourself.

Basic Construction.  Prevent injuries to people  Maintain a safe environment for workers  Reduce hazards  Reduce machinery breakdowns.

Coal By: Josephine Latimer Jonathan Klosop Evan Sedor.

Cracks in Concrete. 2-Classifications 2-Classifications 3-Concrete removal, preparation 4-References Cracks in Concrete 1-lntroduction.

9/30/ Module 3 Safe Work Practices. 9/30/ Video Segment: Safe Work Practices Think about the following points as you view the video.

Engineering Controls for Silica Art Wickman, CIH Georgia Tech Safety & Health Consultation Program.

©2008 Sponge-Jet Inc. All rights reserved. SPONGE JET BLASTING & CLEANING AT SUPERHEATED TUBING BOILER 1 Details of Project: Coverage Area: Approximately.

Duct Coating Technology

Heat Exchanger Coating Technology

1 Portable Powered Tools Use the Right Tool the Right Way.

Section 3: Mining Regulations and Mine Reclamation

© Pearson Education Limited, Copying permitted for the purchasing institution only. This material is not copyright free. Painting and Decorating.

Staying Safe in the Shop Fire Safety, Safety Codes, and Personal Safety.

Cleaning Equipment & Methods Chapter 9 Page 97. Basic Cleaning Tools Scrapper Hand Wire Brush Power Brushes Solvent Brush Sand Paper Remove heavy dirt.

PING, Inc. 52 Acres 20 Buildings 1,000 employees Non-title V permit 47 pages VOCs & PM EHS Staff.

Introduction to Horticulture

©2008 Sponge-Jet Inc. All rights reserved. 1 Preparing Gas Pipeline Weld Seams on Po River Major river, spanning east to west Italy Sensitive residential.

FILTERS Faculty of Maritime Studies Rijeka Marin Kustić.

Paint Removal from CMU and Brick Kenneth A. Trimber KTA-Tator, Inc.

October Module 5: During the Work Overview: Traditional renovations create airborne dust. Prohibited practices. Protect yourself and make a personal.

©2008 Sponge-Jet Inc. All rights reserved. 1 “Whitewater” Tank Preparation in Paper Mill Corrosion in whitewater tank of slushing area.

©2008 Sponge-Jet Inc. All rights reserved. 1 Tank Preparation Chevron Water Softener and Treatment Plant Chevron water softener and treatment tanks that.

16.3. Bellringer The Environmental Impacts of Mining Because of the potential environmental impact of mining on a large scale, mining is one of the most.

Fire Extinguishers 29 CFR © Business & Legal Reports, Inc Session Objectives You will be able to: Identify different classes of fire Choose.

A risk assessment has been undertaken and control measures should be specific to the job, not generic, should list the relevant controls for that job.

Why replace? When you can restore!. The MicroStrip System Low pressure, abrasive cleaning system Compressed air only / air & water Range of fine precision.

© 2016 Global Market Insights, Inc. USA. All Rights Reserved Sandblasting Media Market size worth $441.9 million by 2023.

Abrasive Blasting.

UniBond™ ST Polyester-Faced Adhesive Tape

Light Bulb Changing Procedure

How to Select and Optimize Abrasive Blasting Equipment

Paint & Coating Operations

Interior of steel tank; 56sqm (600sqft) 50micron (2mil) profile

Section 3: Mining Regulations and Mine Reclamation

Automated Surface preparation

SURFACE PREPARATION BY BLAST-CLEANING

NACE SPECIFICATION White Metal Blast Cleaning

T7 – POLYPROPYLENE PLEATED CARTRIDGES

Section 3: Mining Regulations and Mine Reclamation

Air Blasting with Steel Abrasives

Shop Safety Shop Cleanup….

Section 3: Mining Regulations and Mine Reclamation

Section 3: Mining Regulations and Mine Reclamation

Small Gas Engines Shop Safety

Objectives Describe seven important potential environmental consequences of mining. Name four federal laws that relate to mining and reclaiming mined land.

Section 3: Mining Regulations and Mine Reclamation

ASSS Automotive Shop Safety

Chapter 17 Reflection Homework: Read Section 1, pp. Reflection:

IMPORTANT NOTE TO CONSTRUCTION MANAGERS

Presentation transcript:

©2008 Sponge-Jet Inc. All rights reserved. 1 Removing Fire Damaged Coatings in Power Plant Mill fire damaged paint on pulverized fuel line Blast area covered with simplistic containment to capture the Sponge Media TM for recycling Paint is usually removed by scrapers and hand tools Conventional blasting not acceptable due to potential dust contamination to nearby rotating equipment

©2008 Sponge-Jet Inc. All rights reserved. 2 Removing Fire Damaged Coatings in Power Plant Burned paint removed using Silver 30 Sponge MediaTM abrasive; Media recycled 8-10 times 62.5micron (2.5 mil) profile with SA2.5(NACE 2) Near White Blast Cleaning Low blast pressure 4.1bar (60psi) to control rebound in confined area Project completed in one day (Sponge Media) vs. 3-4 days (hand tools)

©2008 Sponge-Jet Inc. All rights reserved Removing Fire Damaged Coatings in Power Plant Burned paint removed using Silver 30 Sponge Media TM abrasive; Media recycled 8-10 times 62.5micron (2.5 mil) profile with SA2.5(NACE 2) Near White Blast Cleaning Low blast pressure 4.1bar (60psi) to control rebound in confined area Project completed in one day (Sponge Media) vs. 3-4 days (hand tools)