Solar Energy Lab 1 ENGR 1181. Today's Learning Objectives  After today's class, students will be able to: Describe and build both a calibration and solar.

Slides:

Advertisements

Similar presentations

Design a Logic Probe Experiment 20. Design Specifications Design a logic probe as shown in the block diagram of Figure 1 of Experiment 20 with a signal.

Advertisements

Fair Use Building and Research Labs Presents

Binary & Decimal numbers = 3* * *10 + 5*1 = 3* * * *10 0 Decimal system: Ten digits: 0,1,2,3,…,9 Example:

Electronics Dan Simon Cleveland State University ESC 120 Revised August 28, 2010.

Solar Energy Labs – Part 1 ENGR Today's Learning Objectives  After today's class, students will be able to: Describe and build both a calibration.

Working with Arduino: Lesson #2: Variable, Photo, and Force Sensitive Resistors EGN1007.

Design a Voltmeter Experiment 19. Goal Design a circuit that displays the value of unknown voltage between certain voltage ranges. – The unknown voltage.

Basic Circuits – Lab 1 Xmedia Spring Basically Power –Provides energy for the sensor and the output Sensor –Changes aspects of the circuit based.

Week 9: Design a Night Light

You will need the following parts from your kit: 1.Breadboard ohm resistor (brown, black, brown, gold) 3.1 LED (light emitting diode) 4.1 Potentiometer.

Basic Circuits – Lab 1 Xmedia Spring Basically Power –Provides energy for the sensor and the output Sensor –Changes aspects of the circuit based.

Electrical Measurements: Meters

Solar Energy Labs – Part 1 ENGR Solar Meters in the Real World A real world application of using solar light to generate power is describe in this.

Week 7: Design a Night Light New Experiment It is not in the lab manual.

Working with Arduino: Lesson #3: Force Sensitive Resistors EGN1007.

Jeopardy Safety Generating Electricity Circuits In your home Q $100 Q $200 Q $300 Q $400 Q $500 Q $100 Q $200 Q $300 Q $400 Q $500 Final Jeopardy Measuring.

Solar Energy Labs – Part 2 ENGR Solar Cells in the Real World Solar panels are becoming commonplace. We’re most familiar with fields or rooftops.

Wind Turbine Lab (Part A)

Circuits Lab ENGR 1181 Lab 3.

ENGR 1181 First-Year Engineering Program College of Engineering Engineering Education Innovation Center First-Year Engineering Program Solar Energy Meter.

TA: Chris Reilly Group 5: Benjamin, Ramie, Zachary, Dinal.

Circuits Lab ENGR 1181 Lab #3. Circuits in the Real World Many engineering fields and products require the use of circuits. Some are more complicated.

Investigation 16B  Key Question: What is the relationship between current and voltage in a circuit? Resistance and Ohm’s Law.

Working with Arduino: Lesson #4: Servos EGN1007. Learning Goals Learning Goals: The student will be able to: 1.Build a complete circuit using the Arduino.

Beam Bending Lab ENGR 1181 Lab # 6.

Potentiometer Foundations of Technology Potentiometer © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching.

Power and Power Measurement ENGR 10 – Intro to Engineering College of Engineering San Jose State University (Ping Hsu and Ken Youssefi) 1 Introduction.

Circuits Lab Introduction

Eng 1181 College of Engineering Engineering Education Innovation Center Marble Delivery System Introduction Lab 1.

Name: ________________ Class: _________________ Index: ________________ D.C. Circuit.

Circuits Lab ENGR 1181 Lab 3. Circuits in the Real World All engineering fields employ electronic circuits – electric cars, biomedical devices, computers,

Quality and Productivity Lab ENGR Q&P in the Real World Many industries use assembly lines to speed up production, reduce costs, and improve safety.

Physics 2225: Working With Electronic Equipment Purpose  Learn how to use basic electronic equipment: Digital multi meter Oscilloscope Function generator.

Detection Circuit ENGR Lecture. Learning Objectives of Lab  Students will learn about –  Electronic circuit components  Building the binary.

Microcontrollers Module 3: Digital Display. 7 – Segment Display A seven-segment display (SSD), or seven- segment indicator, is a form of electronic display.

Current Electricity and Electric Circuits. Static vs. Current Electricity Static Electricity: charges build up in one location Current Electricity: electrons.

ENGR 1181 First-Year Engineering Program College of Engineering Engineering Education Innovation Center First-Year Engineering Program Solar Cell Lab.

More Resistors Activity 6.2.3a Magic of Electrons

College of Engineering Solar Energy Meter Lab 4 Engineering Education Innovation Center ENGR 1181.

ENGR 1181 College of Engineering Engineering Education Innovation Center Solar Cell Lab 5 Intro.

Unit 3, Chapter 8 Integrated Science. Unit Three: Electricity and Magnetism 8.1 Ohm's Law 8.2 Work, Energy, and Power Chapter 8 Electrical Relationships.

College of Engineering Problem Solving Lab Final Build & Testing Lab – Problem Solving C Engineering Education Innovation Center ENGR 1181.

Environment and teaching kits Andrzej Kotlicki Physics and Astronomy.

First-Year Engineering Program Solar Cell Lab Investigation of Solar Cells How Solar Cells work Understand different characteristics and their impact on.

How a Photocell Works.

Temperature Sensing Temperature Bar Graph Project National Electronics Museum November 12, 2011 National Electronics Museum.

Beam Bending Lab Introduction

Basic Equipment and Schematic Reading. Objectives Learn the basic equipment that will be used in the Lab. Learn some of the basic symbols used on electrical.

Detection Circuit ENGR Pre Lab.

Marble Delivery System Lab ENGR 1181 Lab #1. Build a tower, build a team  Effective teamwork is the basis for team success

UNIT FIVE: Electricity and Magnetism  Chapter 16 Electricity  Chapter 17 Magnetism.

College of Engineering Wind Turbine – Part A Engineering Education Innovation Center ENGR 1181.

Praxis I 13 Oct Outline Component & Device Measurement and Instrument Datasheet How to build circuit using breadboard.

Intro to Electricity Electricity Definition: Circuit Definition: Three things for a circuit to work:

Investigation 5. Part 1  What do resistors do in circuits?

College of Engineering Problem Solving Lab Lab – Problem Solving Lab A Engineering Education Innovation Center ENGR 1181.

UNIT FIVE: Electricity and Magnetism

Aim: How is a Series Circuit different from a Parallel Circuit?

Series Circuit.

Introduction Molecules: made up of atoms of individual elements.

Electric Circuits (12.2).

Wind Turbine Lab (Part B)

Be able to describe how the resistance of LDRs and Thermistors varies.

Electric Circuits (12.2).

Circuits Lab Introduction

Electric Circuits Electricity refers to the presence of electric current in wires, motors, light bulbs, and other devices. Electric current is similar.

Current Electricity and Electric Circuits

2019 Investing Now Summer Program

Presentation transcript:

Solar Energy Lab 1 ENGR 1181

Today's Learning Objectives  After today's class, students will be able to: Describe and build both a calibration and solar meter circuit Convert a binary number to a decimal value Discuss how a potentiometer works Explain how a photodiode light sensor works Given a schematic drawing, build a working electronic circuit on a breadboard Use a Photodiode Light Sensor and a Binary Voltmeter circuit to measure the intensity of light (in Watts/m 2 )

Solar Energy Meter In lab today, you will build a solar energy meter circuit to measure the energy intensity from a light source. solar energy meter Output in Watts / m 2 Sun light

Solar Energy Meter Components LEDs Banana Plug Wires 1 Black and 1 Red DMM Circuit Components +5 Volt Power Module Breadboard (Pre-Wired)

Solar Energy Meter Circuit Schematic Breadboard Layout

Binary Voltmeter Calibration Circuit

Trimpot – variable voltage  Total resistance (Pin 1 to Pin 3) = 10 kOhms  Resistance at Pin 2 varies by turning the adjustment knob  Produces V adj output voltage of 0 to +5 Volts on Pin 2  It is a variable resistor V adj

8-Bit Binary Display The LEDs at the output of the Binary Voltmeter are labeled from D7 to D0 The LEDs are either "ON" or "OFF" – for binary numbers "1" and "0" D7 is the Most Significant Bit (MSB) and D0 is the Least Significant Bit (LSB) Any 8-bit binary number can be converted to a decimal number MSB LSB

Task 1 – Build the Calibration Circuit

Task 1 – Calibration Circuit Closeup

Task 2 – Enter Data into the Worksheet

Task 3 – Build the Solar Energy Meter Circuit

Task 3 – Solar Energy Meter Circuit Closeup

Task 4 – Use the Solar Energy Meter to measure the intensity of a light source

Task 4 – Record the Light Intensity data in the Lab Worksheet

TopicDocument Type Marble Delivery SystemNone Quality and ProductivityExecutive Summary CircuitsExecutive Summary Solar Energy – Part 1-- Solar Energy – Part 2Memo (Combined) Beam BendingMemo Wind Turbine 1-- Wind Turbine 2Report (Combined) Problem Solving Project 1 Project Notebook (Combined) Problem Solving Project 2 Problem Solving Project 3