1 Flux Numerical Methods. 2 Flux Basics The finite-volume formulation of the conservation equations resulted in the equation where was the flux of the.

Slides:



Advertisements
Similar presentations
Joint Mathematics Meetings Hynes Convention Center, Boston, MA
Advertisements

2ª aula Evolution Equation. The Finite Volume Method.
Finite Volume II Philip Mocz. Goals Construct a robust, 2nd order FV method for the Euler equation (Navier-Stokes without the viscous term, compressible)
Lecture 15: Capillary motion
Conservation Equations
Continuity Equation. Continuity Equation Continuity Equation Net outflow in x direction.
Cht. IV The Equation of Motion Prof. Alison Bridger 10/2011.
1 MECH 221 FLUID MECHANICS (Fall 06/07) Tutorial 7.
Coupled Fluid-Structural Solver CFD incompressible flow solver has been coupled with a FEA code to analyze dynamic fluid-structure coupling phenomena CFD.
Boundaries, shocks and discontinuities
1 Internal Seminar, November 14 th Effects of non conformal mesh on LES S. Rolfo The University of Manchester, M60 1QD, UK School of Mechanical,
High-Order Adaptive and Parallel Discontinuous Galerkin Methods for Hyperbolic Conservation Laws J. E. Flaherty, L. Krivodonova, J. F. Remacle, and M.
Shallow water equations in 1D: Method of characteristics
Computations of Fluid Dynamics using the Interface Tracking Method Zhiliang Xu Department of Mathematics University of Notre.
Tamed Effect of Normal Stress in VFF… P M V Subbarao Professor Mechanical Engineering Department I I T Delhi Negligible Bulk Viscosity Model for Momentum.
Lecture of : the Reynolds equations of turbulent motions JORDANIAN GERMAN WINTER ACCADMEY Prepared by: Eng. Mohammad Hamasha Jordan University of Science.
Numerical Methods for Partial Differential Equations CAAM 452 Spring 2005 Lecture 11 Instructor: Tim Warburton.
1 Finite-Volume Formulation. 2 Review of the Integral Equation The integral equation for the conservation statement is: Equation applies for a control.
External Flow: The Flat Plate in Parallel Flow
Zhaorui Li and Farhad Jaberi Department of Mechanical Engineering Michigan State University East Lansing, Michigan Large-Scale Simulations of High Speed.
CEE 262A H YDRODYNAMICS Lecture 5 Conservation Laws Part I 1.
A Hybrid Particle-Mesh Method for Viscous, Incompressible, Multiphase Flows Jie LIU, Seiichi KOSHIZUKA Yoshiaki OKA The University of Tokyo,
Compressible Flow Introduction
Solution of the St Venant Equations / Shallow-Water equations of open channel flow Dr Andrew Sleigh School of Civil Engineering University of Leeds, UK.
Boundaries, shocks, and discontinuities. How discontinuities form Often due to “wave steepening” Example in ordinary fluid: –V s 2 = dP/d  m –P/  
R. Oran csem.engin.umich.edu SHINE 09 May 2005 Campaign Event: Introducing Turbulence Rona Oran Igor V. Sokolov Richard Frazin Ward Manchester Tamas I.
AMS 691 Special Topics in Applied Mathematics Lecture 3 James Glimm Department of Applied Mathematics and Statistics, Stony Brook University Brookhaven.
High-Order Spatial and Temporal Methods for Simulation and Sensitivity Analysis of High-Speed Flows PI Dimitri J. Mavriplis University of Wyoming Co-PI.
Numerical Schemes for Streamer Discharges at Atmospheric Pressure
Approximate Riemann Solvers for Multi-component flows Ben Thornber Academic Supervisor: D.Drikakis Industrial Mentor: D. Youngs (AWE) Aerospace Sciences.
Mass Transfer Coefficient
7. Introduction to the numerical integration of PDE. As an example, we consider the following PDE with one variable; Finite difference method is one of.
Chapter 6 Introduction to Forced Convection:
J.-Ph. Braeunig CEA DAM Ile-de-FrancePage 1 Jean-Philippe Braeunig CEA DAM Île-de-France, Bruyères-le-Châtel, LRC CEA-ENS Cachan
1 Direct Numerical Simulation of Compressible Turbulent Flows with Weighted Non-Linear Compact Schemes Alfred Gessow Rotorcraft Center Aerospace Engineering.
CIS888.11V/EE894R/ME894V A Case Study in Computational Science & Engineering We will apply several numerical methods to find a steady state solution of.
HEAT TRANSFER FINITE ELEMENT FORMULATION
Lecture 21-22: Sound Waves in Fluids Sound in ideal fluid Sound in real fluid. Attenuation of the sound waves 1.
Numerical Methods for Partial Differential Equations CAAM 452 Spring 2005 Lecture 12 Instructor: Tim Warburton.
Background 1. Energy conservation equation If there is no friction.
Numerical study of flow instability between two cylinders in 2D case V. V. Denisenko Institute for Aided Design RAS.
FREE CONVECTION 7.1 Introduction Solar collectors Pipes Ducts Electronic packages Walls and windows 7.2 Features and Parameters of Free Convection (1)
COMPUTATIONAL FLUID DYNAMICS (AE 2402) Presented by IRISH ANGELIN S AP/AERO.
AMS 691 Special Topics in Applied Mathematics Lecture 8
Discretization Methods Chapter 2. Training Manual May 15, 2001 Inventory # Discretization Methods Topics Equations and The Goal Brief overview.
Compressible Frictional Flow Past Wings P M V Subbarao Professor Mechanical Engineering Department I I T Delhi A Small and Significant Region of Curse.
Sarthit Toolthaisong FREE CONVECTION. Sarthit Toolthaisong 7.2 Features and Parameters of Free Convection 1) Driving Force In general, two conditions.
AMS 691 Special Topics in Applied Mathematics Lecture 3
1 Zonal Boundary Conditions. 2 Some Basics The flow domain is divided into zones and grids are generated within each zone. The flow equations are solved.
An Ultimate Combination of Physical Intuition with Experiments… P M V Subbarao Professor Mechanical Engineering Department I I T Delhi Boundary Layer.
AMS 691 Special Topics in Applied Mathematics Lecture 5 James Glimm Department of Applied Mathematics and Statistics, Stony Brook University Brookhaven.
1 Application of Weighted Essentially Non-Oscillatory Limiting to Compact Interpolation Schemes Debojyoti Ghosh Graduate Research Assistant Alfred Gessow.
External Flow: The Flat Plate in Parallel Flow
School of Aerospace Engineering MITE Numerical Simulation of Centrifugal Compressor Stall and Surge Saeid NiaziAlex SteinLakshmi N. Sankar School of Aerospace.
Towards Future Navier-Stokes Schemes Uniform Accuracy, O(h) Time Step, Accurate Viscous/Heat Fluxes Hiroaki Nishikawa National Institute of Aerospace.
External Flow: The Flat Plate in Parallel Flow Chapter 7 Section 7.1 through 7.3.
Viscosità Equazioni di Navier Stokes. Viscous stresses are surface forces per unit area. (Similar to pressure) (Viscous stresses)
Celestial Mechanics II
Lecture 3 & 4 : Newtonian Numerical Hydrodynamics Contents 1. The Euler equation 2. Properties of the Euler equation 3. Shock tube problem 4. The Roe scheme.
Great Innovations are possible through General Understanding …. P M V Subbarao Professor Mechanical Engineering Department I I T Delhi Thermodynamic View.
Continuum Mechanics (MTH487)
Convection-Dominated Problems
Modeling of Traffic Flow Problems
Ship Hydrodynamics - Resistance
The k-ε model The k-ε model focuses on the mechanisms that affect the turbulent kinetic energy (per unit mass) k. The instantaneous kinetic energy k(t)
Convergence in Computational Science
topic8_NS_vectorForm_F02
Finite Volume Method Philip Mocz.
topic8_NS_vectorForm_F02
High Accuracy Schemes for Inviscid Traffic Models
Presentation transcript:

1 Flux Numerical Methods

2 Flux Basics The finite-volume formulation of the conservation equations resulted in the equation where was the flux of the flow across the control surface resulting from the approximation of the surface integral. For a finite-volume cell, the flux was expressed as Where It was assumed that the flux was uniform over the cell face.

3 Fluxes on a Hexahedral Cell A hexahedral cell contains 6 quadrilateral faces, thus where again, Face f ( f is an index for the face ) Area normal vector for face f

4 Numerical Flux on a Cell Face The numerical flux on a cell face is The normal area vector is usually easily defined for a quadrilateral or triangular cell face. The focus of the rest of this discussion is on numerical methods for computing at a cell face. We first will assume that is a known velocity for the cell face.

5 Numerical Flux on a Cell Face We first consider that we have the states of the flow on the “left” and “right” of the cell face, Q L and Q R. Our objective is to find the cell face flux. One can define A consistency condition for the numerical flux is that if Q L = Q R, then

6 Central Difference Method A central difference method for computing the flux is simply The central-difference method works okay for elliptic components of the flux because there is no preferred direction for the propagation of information. A simple central difference is often unstable, especially in the presence of strong gradients. One solution is to add some second-order and fourth-order dissipation (artificial viscosity) to the flux. Methods for computing D (2) and D (4) vary, but generally use second and fourth-order differences with switches to handle variations in Q.

7 Use of Central Difference Method For the Navier-Stokes equations, the viscous shear stress and heat flux terms in the viscous component D V of the non-convective component D are elliptic and those flux components can be computed with the central difference method. Similarly, the fluxes of the turbulence and chemistry equations can be computed using the central difference method. The convective portion of the flux and the pressure term in the inviscid component D I of the Navier-Stokes equation have a hyperbolic character. This wave nature can be put to use to compute the flux using upwind methods.

8 Upwind Methods We expressed the non-convective portion of the flux of the Navier-Stokes equation as This results in the cell-face flux being expressed as or We will now focus on computing the inviscid flux using upwind methods. The focus will be on the use of Roe’s Upwind Flux-Difference Splitting Method.

9 Roe Upwind Flux-Difference Method The Roe upwind flux-difference method computes the inviscid flux as: where is the flux difference computed as, Roe’s method is the default flux method in WIND.

10 Roe Upwind Flux-Difference Method The are the eigenvalues that represent the speed of the waves. The (+) indicate positive eigenvalues and the (-) indicates negative eigenvalues. The are the right eigenvectors that represent the direction of propagation of the waves. The are the Riemann invariants and represent the strength of the wave,

11 Roe Upwind Flux-Difference Method The differentials are computed as Flow properties at the face are computed using Roe-averaging Similar for computing v, w, and h t.

12 Higher-Order Projection The choice of values of Q L and Q R have several option: 1) Use the values of the finite-volume cells to the “left” and “right” of the face. This is a zero-order evaluation and will result in a spatially first-order flux. 2) Use an extrapolation of neighboring finite-volume cells to form a first- order evaluation of Q at the face. This will result in a spatially second- order flux. QiQi Q i+2 Q i+1 Q i-1 QRQR QLQL

13 Variation Limiting The simple extrapolation formulas assume a smooth variation of Q; however, discontinuities in Q are possible (i.e. shocks). Need some mechanism to sense such discontinuities and limit the variation of Q in these extrapolation formulas. Modify the extrapolations by introducing a limiter , This gets into the topic of TVD (Total Variational Diminishing) flux limiting methods, which we will not get into here. The essential role of the limiter is to make   0 in the presence of large variations, which make the flux spatially first-order.

14 Examples of Limiters The possible functions (and theory) for limiters is varied. A couple examples include: Superbee: Chakravarthy: Where r is some ratio of the flow properties and indicates the amount of variation in the solution. An example is The  is a compression parameter 1    2, where a value toward 1 makes the limiter more dissipative.

15 Flux Vector Splitting An alternative to flux-difference splitting is flux-vector splitting that considers that the inviscid flux can be linearly separated van Leer’s flux-vector splitting has the general form of

16 Other RHS Methods Other methods for the “right-hand-side (RHS)” that will not be discussed: Methods available for 3 rd to 5 th –order spatial accuracy. Roe’s method is modified to allow non-uniform grids. Roe’s method as used in the OVERFLOW code is available. Coakley method is available HLLE method is available (similar to Roe’s method) Next 