Heat pumps Effectiveness measured by the Coefficient of Performance C.O.P. = T h /(T h -T c ) This comes from the Carnot Efficiency As the outside air.

Slides:



Advertisements
Similar presentations
Second Law of Thermodynamics
Advertisements

ACTIVE LEARNING PROCESS
EGEE 102 – Energy Conservation And Environmental Protection Energy Efficiency.
Chapter 6 Thermal Energy
Vapor and Combined Power Cycles
Section 16.3 Using Heat.
Chapter 13 Section 3.
POWER PLANT.
STEAM CONDENSERS.
Sources of Thermal Energy Where does it come from?
Refrigeration and Heat Pump Systems Refrigeration systems: To cool a refrigerated space or to maintain the temperature of a space below that of the surroundings.
Topic 8: Energy, power, climate change 8
Getting the electricity from the plant to the light switch Not a place for wireless technology-or is it?
Steam Power Station Presented By Ashvin G. Patel Asst. Prof. (E.E.)
Refrigerators and Heat Pumps
 Industrial societies spend huge amounts of energy.  Much of it is supply by electricity which comes from generators in power stations.
Jacob McKenzie, Ty Nowotny, Colin Neunuebel
Gas Turbine Power Plant
Topic: Energy Flow and Matter Cycles
 Coal comes in to the plant by barge transportation.  Coal is pushed onto a conveyer, that carries the coal straight into the plant.  The coal is then.
ENERGY.
Energy and the Environment Second Edition Chapter 3: Heat Engines Copyright © 2006 by John Wiley & Sons, Inc. Robert A. Ristinen Jack J. Kraushaar.
VII. The second low of Thermodynamics
SYSTEMS : ELECTRICITY How important is electricity to us? Where does it come from?
19. 2 nd Law of Thermodynamics 1. Reversibility & Irreversibility 2. The 2 nd Law of Thermodynamics 3. Applications of the 2 nd Law 4. Entropy & Energy.
Heat engines played a key role in the development of the modern industrial world. Steam locomotives were an important early use of the steam engine. Electric.
Generating Stations. Bulk electric power is produced by special plants known as generating stations or power plants. Depending upon the form of energy.
Furnace/Burner Boiler High Pressure Steam Turbine Generator Electricity Cooler/Condenser Steam Ash and Smoke Coal is burned in a large Furnace/Burner to.
Welcome PRESENTATION BY ASHISH MISHRA.
Britta Groh Physics 106Spring  Almost 85% of the energy used in the US in 2007 was generated by fossil fuels  Fossil fuel technologies are no.
Renewable sources of energy
Heat Pumps In a heat engine, heat is converted to mechanical energy by taking advantage of the fact that heat flows from hot to cold. The heat is taken.
Where does Electricity Come From?
Heat Pumps In a heat engine, heat is converted to mechanical energy by taking advantage of the fact that heat flows from hot to cold. The heat is taken.
THERMAL POWER PLANT. INTRODUCTION : THERMAL POWER PLANTS CONVERT THE HEAT ENERGY OF COAL INTO ELECTRICAL ENERGY. COAL IS BURNT IN A BOILER WHICH CONVERTS.
A seminar on Practical Training taken at KOTA SUPER THERMAL POWER STATION.
Barford Power Station St Neots Community College Sixth Form Visit, May 2008.
THERMAL POWER PLANT.
WELCOME Project Electric Power Plant. Electric Power Plant Electric Power Plant.This is the age of Technology. In this age there is no place where we.
By: Eric R., Bree, Lauren, and Ariel. Introduction Used as energy for – Homes – Schools – Businesses Why do they use it? – Renewable resource – Almost.
BOILER HOUSE CONDENSOR SHAFT PUMP CLEAN WATER IN THE BOILER THERMAL POWER STATION FUEL OR GAS STEAM TURBINE GENERATOR.
DISTRICT HEATING District heating is an infrastructure which allows heat generated in a centralized location to be distributed to residential homes and.
Coal Fired Power Plants By: Shawn Houser Environmental Science High School Continue.
 Fossil fuel: the remains of ancient organisms that changed into coal, oil, or natural gas  Most of the energy that we use comes from fossil fuels 
Second law of thermodynamics. The Second Law of Thermodynamics.
Heat Engines A gasoline engine is a form of a heat engine, e.g. a 4-stroke engine INTAKE stroke: the piston descends from the top to the bottom of the.
EGEE 102 – Energy Conservation And Environmental Protection Energy Efficiency.
Chapter 16 Thermal Energy & Heat.  Objectives:  1. Explain how heat and work transfer energy  2. Relate thermal energy to the motion of particles that.
1 3E-03 Fire Syringe RAPID COMPRESSION IS ADIABATIC GIVING RAPID RISE OF AIR TEMPERATURE IN THE CHAMBER WHICH EXCEEDS THE IGNITION TEMPERATURE OF THE FLAMMABLE.
You can type your own categories and points values in this game board. Type your questions and answers in the slides we’ve provided. When you’re in slide.
Submitted By:Supported By: Suresh Chandra Jangid Branch: - Mechanical (IInd yr. )
Cogeneration Power plants generate lots of waste heat Modern coal fired plants convert 38% of the energy in the coal to electricity, the other 62% is waste!
Power Grid A network of power transmission systems Usually more than one path between points on a network.
Chapter No-5 STEAM CONDENSERS AND COOLING TOWERS Marks-16
Chapter 37: Fluid Containment
7th grade Science Brookville Intermediate School
 II THE ADVANTAGES OF ELECTRICITY
Power Plants Types of Power Plants
Unit 37: Fluid containment Dr
Thermo-electric refrigeration.
Electrical Gas Plumbing Heating & Cooling
What is it and where does it come from?
Unit 37: Fluid containment Dr
Thermodynamics, is also the Study of Enthalpy and Entropy
St. Augustine Preparatory School
Energy and Resources.
9 CHAPTER Vapor and Combined Power Cycles.
STEAM CONDENSERS AND COOLING TOWERS Marks-16
THERMAL POWER PLANT. A Thermal Power Plant converts the heat energy of coal into electrical energy. Coal is burnt in a boiler which converts water into.
Condenser in Power Plants
Presentation transcript:

Heat pumps Effectiveness measured by the Coefficient of Performance C.O.P. = T h /(T h -T c ) This comes from the Carnot Efficiency As the outside air gets colder, T h -T c gets larger to C.O.P decreases. This means heat pumps are less efficient in very cold weather and very cold climates. Usually this occurs when the outside T falls below 15 F.

Peltier effect Peltier was experimenting with electricity Connected a bismuth and copper wire together and hooked them to a battery. Found one side became hot and the other cold as the current flowed! Basis for modern thermoelectric cooling/heating Modern devices use semi-conductors (more efficient). Not efficient enough for large scale heating or cooling Creates a lot of excess heat

Peltier Effect Right hand junction is heated-electrical energy is converted to heat Left hand junction is cooled-heat energy is converted to electrical energy.

Peltier effect

Cogeneration Power plants generate lots of waste heat Modern coal fired plants convert 38% of the energy in the coal to electricity, the other 62% is waste! Usually shed off into the environment (air, cooling pond, river, lake etc) Can have environmental consequences Can it be put to use?

Cogeneration Problem arises when the power plant is located far away from population centers- cannot effectively transport the heat over long distances In principle, the waste heat could be used to heat a boiler and provide steam for space heating and cooling. Or it could be recycled to drive turbines to produce additional electricity

Types of cogeneration plants Topping cycle plants - produce electricity from a steam turbine. The exhausted steam is then condensed, and the low temperature heat released from this condensation is utilized for heating. Bottoming cycle plants- produce high temperature heat for industrial processes, then a waste heat recovery boiler feeds an electrical plant. Need a high initial source of heat-metal manufacturing plants.

Examples The New York City steam system - district heating system which carries steam from central power stations under the streets of Manhattan to heat, cool, or supply power to high rise buildings and businesses. Another example is in use at the University of Colorado, Boulder - Total efficiency is 70% Possibility of explosions due to pipe failures exists

Example of Explosions The July 18, 2007 New York City steam explosion sent a geyser of hot steam up from beneath a busy intersection, with a 40-story-high shower of mud and flying debris raining down on the crowded streets of Midtown Manhattan It was caused by the failure of a Consolidated Edison 24- inch underground steam pipe installed in 1924

Possibilities Outside the U.S., energy recycling is more common. Denmark is probably the most active energy recycler, obtaining about 55% of its energy from cogeneration and waste heat recovery. In the US about 8% of its electricity is produced via cogeneration