QCAL upgrade status FE electronic replacement actual status future design test E. Santovetti KLOE General meeting 19-20 December 2002.

Slides:

Advertisements

Similar presentations

Layer 0 Grounding Requirement in terms of noise performance Grounding/Shielding studies with L0 prototype Summary Kazu Hanagaki / Fermilab.

Advertisements

Power supply cable Charge injection 3 channels readout (external cables to the scope) 3 channels readout (internal cables) Set up for reading two cards.

Beam Position Monitors MICE CM Harbin January, 2009.

Circuit Board Having Shielding Planes with Varied Void Opening Patterns for Controlling the Impedance and the Transmission Time of Differential Transmission.

CMS WeekDec 2002E. Hazen HF Electronics Status Report E. Hazen, J. Rohlf, E. Machado Boston University.

LarTPC Electronics Meeting Current Work at MSU Fermilab Dan Edmunds 23-February-2010.

Photomultiplier Tube. What is it? Extremely sensitive detector of light in the ultraviolet, visible and near infrared Multiplies the signal produced by.

WorldFIP optical repeaters 1 | status Feb 2013: 66 repeaters ordered to HLP; never delivered Feb 2014: HLP announced eminent closure Jun 2014: 40 of the.

BLM FOR THE INJECTORS PROJECT CABLING NON-CONFORMITIES LIU-PSB Working Group Meeting (15/08/2013) Christos Zamantzas

Controlled Impedance An introduction (No electronics background required)

Experimental Area Meeting V. Bobillier1 Good connection to earth (in many points) of every metallic parts to be installed in the cavern is very.

Yu. Guz 18/12/20061 HCAL commissioning: status and plans Yu. Guz, IHEP, Protvino Outline 1. current status of HCAL a)CW+PM b)signal cables c)LED monitoring.

NESCOT CATC1 Cable Testing CCNA 1 v3 – Module 4. NESCOT CATC2 Waves 1. The _________ of the waves is the amount of time between each wave, measured in.

Chiho Wang ATLAS TRT Duke University CERN, Feb TRT Barrel assembly status & schedule Feb. 9, 2005.

12/Dec/2012SBS-Meeting1 of 24 Status of the Front Tracker GEM and INFN Electronics 2013 – Feb – 20 SBS Weekly Meeting GEM Assembling SRS – INFN Electronics.

P. 1Mario Deile – TOTEMino: Infrastructure Status and Schedule Mario Deile Zone 2.Gas system 3.Cabling 4.Cooling water 5.Counting-Room 6.Safety.

Physical Transmission

LHCf Arm2 – status of hardware upgrade in Firenze Lorenzo Bonechi 20 December 2013.

Instrumentation (AMME2700) 1 Instrumentation Dr. Xiaofeng Wu.

1 5 December 2012 Laurent Roy Infrastructure / Electronics Upgrade -Cabling (long distance) -Rack and Crate (space, electrical distribution, cooling) -Detector.

Straw Electronics status and preparation for the technical run NA62 workshop Siena.

Ground loops Why grounding is so important ?DefinitionGround loops :(Introduction)where ground loops affect ?Ground loops are created by :Solutions.

P. Paolucci - I.N.F.N. di Napoli 1 MTCC meeting May 06 HV & LV status DELIVERED AT BLG /60  67% of the A3009 (LV) 6/40  15% A3512N (HV) 10/10 

Some questions:  In which order cables will be put ?  Who, where will put PS signal cables in bundles ?  Which kind of cable binders: velcro or panduit.

STATUS OF KLOE F. Bossi Capri, May KLOE SHUTDOWN ACTIVITIES  New interaction region  QCAL upgrades  New computing resources  Monte Carlo.

BKLM RPC Signal & Ground Schematic Gerard Visser, Indiana University (for the barrel KLM team) 10th B2GM, 11/2011 magnet structure GND 7mm FOAM 3mm GLASS.

AMS-RICH Detector. J. Berdugo – CIEMAT (Madrid, Spain) 1 AMS-02 Phase II Flight Safety Review AMS Ring Imaging CHerenkov PURPOSE: 1.Precise measurement.

General News M.Lenti. Outlook Reminder of the RICH schedule PMs and sockets: what we have Mirrors What would change for PM holding disks if vacuum inside.

False asymmetries/Ground Loops David Bowman 4/27/12.

P. Aspell CERN April 2011 CMS MPGD Upgrade …. Electronics 2 1.

PSD upgrade: concept and plans - Why the PSD upgrade is necessary? - Concept and status of the PSD temperature control - Concept of the PSD analog part.

1/5 ECAL/HCAL Front-end status Calorimeter Meeting Frédéric Machefert Wednesday February 9 th, 2011.

Gain stability and the LYSO beam radiation monitor measurements

Radioactive source and cosmic-ray test for the MWPC Davide Pinci on behalf of the Frascati-Roma1 MWPC group.

8/31/05DR Lynch1 HBD Preparations in the IR Don Lynch.

Infrastructure for LHCb Upgrade workshop – MUON detector Infrastructure for LHCB Upgrade workshop: MUON power, electronics Muon upgrade in a nutshell LV.

10/2/2002MJL - MuTr DC Report Muon Tracking Status South North.

PHENIX Safety Review Overview of the PHENIX Hadron Blind Detector Craig Woody BNL September 15, 2005.

Status of the PSD upgrade - Status of the PSD cooling and temperature stabilization system - MAPD gain monitoring system - PSD readout upgrade F.Guber,

Saverio MINUTOLITOTEM Electronics W.G., 9 December T1 electronics status.

Chiho Wang ATLAS TRT Duke University CERN, Sep Barrel integration status.

CERN – 7 Oct 04 1 LHCb Muon Grounding Anatoli Katchouk CERN Alessandro Balla, Paolo Ciambrone, Maurizio Carletti, Giovanni Corradi, Giulietto Felici, Rosario.

1 Installation Status Remaining Issues RIKEN/RBRC Itaru Nakagawa.

Wired Transmission 24 Wired Transmission 24. Wired Transmission 24 This is about the method used to actually transmit or send data That means actual wires.

Dr.F. Arteche EMC DEPFET Project: A general overview.

Carlos A. Martins ESS – Accelerator Division - RF Electrical Power Systems June 2 th, 2014 Design, construction and measurement.

G.F. Tassielli - SuperB Workshop XI LNF1/11 02/12/2009 Status report on CLUster COUnting activities G. F. Tassielli on behalf of CLUCOU group SuperB Workshop.

Faculty of Physics, University of Belgrade Collaboration meeting, Budapest 15 th of May, ToF-L/R detector HV upgrade Jovan Puzović, Faculty of Physics,

ATLAS TRT Duke University CERN, Feb Fuse Box Status Duke University.

E.Guschin (INR,Moscow) 20 January 2006PS/SPD meeting CERN PS/SPD LED monitoring system status In December 2005: –All splitters and drivers are delivered.

Belle-II bKLM RPC Readout Power & Ground Discussion 12 th Belle II General Meeting Gerard Visser Indiana University CEEM 7/24/2012.

HF ROBOX PRR3 Apr 2003E. Hazen HF Front-End Electronics ● System Description – Overview – PMT Board, ROBOX, Patch Panel – Signal Cable, Front-end boards.

L. Benussi On Behalf of LNF crew

PreShower Characterisations

Test beam straw prototype production status

HF Test station at P5 A.Mestvirishvili.

Noise issues – Potentiometer signal from the electronic card

Transmission Media.

NA61 PSD. Upgrade status. Institute for Nuclear Research RAS, Moscow.

LV Test Napoli feb 05 Noise ripple: EASY - + CRATE LV cable

University of Wisconsin-Madison / SSEC

GEM-based Digital Hadron Calorimetry for SiD

David Mitchell December 21, 2005

GEM-based Digital Hadron Calorimetry for SiD

Testing of the EMCO Prototype Boards

FOCAL LINE MODIFICATION OF THE E/W ARM OF THE NORTHERN CROSS RADIOTELESCOPE The modification consisted in removing the entire focal line from sector 3.

HUB – AMPLIFIER - REPEATER

Repairing the Electrical Components

Commissioning of the CMS Hadron Forward Calorimeters Phase 1 Upgrade

Presentation transcript:

QCAL upgrade status FE electronic replacement actual status future design test E. Santovetti KLOE General meeting December 2002

E. SantovettiKLOE GM December 2002 FE electronics now PM and divider ~ 50 cm far from amplifier for safety reason (PM not accessible). Triaxial cable with signal, ground and HV No shield around the PM Very high noise

E. SantovettiKLOE GM December 2002 New FE electronics amplifier in the same location of the PM divider Differential amplifier to reduce the noise (transmitter on the PM and receiver on the SDS back plane Change of the signal cable (don’t pass anymore through the blue box ): twisted or double coaxial (to be tested) Amplifier small board removable under investigation (very difficult to access) Quality test of the amplifier chip with at least one month of operation before installation Thin electrical shield around the PM Replacement of the worst 10 photomultipliers (to be delivered): the gain of all 32 PM’s will be measured All the components have been ordered

E. SantovettiKLOE GM December 2002 Time schedule amplifier in the same location of the PM divider Differential amplifier to reduce the noise (transmitter on the PM and receiver on the SDS back plane Change of the signal cable (don’t pass anymore through the blue box ): twisted or double coaxial (to be tested) Amplifier small board removable under investigation (very difficult to access) Quality test of the amplifier chip with at least one month of operation before installation Thin electrical shield around the PM Replacement of the worst 10 photomultipliers (to be delivered): the gain of all 32 PM’s will be measured All the components have been ordered