Lecture 6: Stop Sign Control & Signalized intersections & Design LOS Explain there is hierarchy of intersection control Use the warrants for 2-way stop.

Slides:



Advertisements
Similar presentations
Capacity, Level of Service, Intersection Design (1)
Advertisements

2009 MUTCD Revisions Part 4 – Traffic Signals Revisions to the 2009 MUTCD.
Rules of the Road. Introduction This training will assist Spanish- speaking Motor Carriers in understanding some of the important traffic regulations.
Signals o Steady lights o Flashing lights o Signal/Sign combinations T – 1.22 Signals by traffic lights indicate the following: Steady red – moving traffic.
Driver Safety.
INTRODUCTION TO TRANSPORT Lecture 7 Introduction to Transport Lecture 7: Signal Coordination.
38 th Street to Kessler Boulevard Traffic Engineering Review Summary For Historic Midtown Initiative (HARMONI) By HNTB Corporation June, 2010.
Florida Department of Transportation, November 2009
Redwood Road & 35th Avenue Traffic Study. Problems Observed: High collision rate along the corridor was found at McArthur Boulevard intersection, with.
Chapter 4. NEVER drive faster than weather or road conditions allow Always slow down On narrow winding roads At intersections or railroad crossings On.
Chapter 4.
Board of County Commissioners November 8, Recommendation Project Background and Location Traffic Analysis Comparison of Alternatives Public Meeting.
Freeway Signing Plan Design April 29, 2008
1 Channelization and Turn Bays. 2 Island Channelization flush, paved, and delineated with markings – or unpaved and delineated with pavement edge and.
1 Austin Transportation Department Ali Mozdbar, P.E., PTOE Division Manager, Traffic Signals Traffic Signal Features for Pedestrians & Bicyclists.
MICHIGAN DEPARTMENT OF TRANSPORTATION Davison TSC
ECGD 4121 – Transportation Engineering I
ROUNDABOUTS. What Is A Roundabout? A specific type of traffic circle Not all traffic circles are roundabouts.
HERO UNIT Training Module Work Zone Traffic Control And Incident Management Operations.
At-Grade Intersection
Chapter 221 Chapter 22: Fundamentals of Signal Timing: Actuated Signals Explain terms related to actuated signals Explain why and where actuated signals.
INTRODUCTION TO TRANSPORT Lecture 4 Introduction to Transport Lecture 4: Signal Timing.
Lec 14, Ch. 15: Introduction to intersection control (Objectives) Understand why some sort of control is essential to allocate ROW at intersections Understand.
CE 7670: Advanced Traffic Signal Systems
Chapter 18: Hierarchy of Intersection Control
Introduction to Transport
Traffic Signal Warrants
Highway Capacity Software (HCS) – Part II
Highway Capacity Software Based on the Highway Capacity Manual (HCM) Special Report 209 Transportation Research Board (TRB), National Research Council.
Lec 14, Ch.8, pp : Intersection control and warrants (objectives) Know the purpose of traffic control Know what MUTCD is and what’s in it Know what.
Analyses of Unsignalized Intersections
Lecture #10 Chapter 15: Intersection Control. Objective 1.Hierarchy of Intersection Control 2.Assessing Basic Rules-of-the-Road 3.Assessing Need for Signalization.
Traffic Engineering Traffic Control Devices. Traffic Control Traffic engineers do not have any control over individual drivers need to develop devices.
Signalized Intersections
Transportation Engineering
Transportation Engineering
2015 Traffic Signals 101 Topic 1 Why?. Office of Traffic, Safety, and Technology Why? Who initiates a signal? Developer City/County Politician Public.
Transportation Engineering
1 Section III Day 2 DMV Manual p. 5-6, Write a scenario about how the driver of the white truck managed to keep his truck on the edge of the.
Negotiating Intersections
Chapter 16: Introduction to intersection control
Rules and Regulations for Safe Driving
Getting a Probationary Licencse…  Must pass MVC’s Knowledge and Vision tests  Complete Six months of supervised driving  Must be at least 17 years old.
Center for Advanced Transportation Education and Research University of Nevada, Reno Presenter: Cui Zhou University of Nevada, Reno Center for Advanced.
ROUNDABOUT CHARACTERISTICS TTE DEFINITIONS TRAFFIC CIRCLE: u Any intersection designed around a central island ROUNDABOUT: u A traffic circle with.
Intersection Control CTC-340. HMWK Ch 18 # 1,3,4,6.
INTRODUCTION An intersection is the general area where two or more highways join or cross, including the roadway and roadside facilities for traffic movements.
Chapter 20: Actuated Signal Control and Detection
Signs, Signals, and Roadway Markings
University of Minnesota Intersection Decision Support Research - Results of Crash Analysis University of Minnesota Intersection Decision Support Research.
Traffic Signal Timing Design Part II. Slide 2 What to do?  Distribute volume among lanes to Identify lane utilization Determine need for lane adjustment.
Signs and Roadway Markings
Roundabout Feasibility: Analysis Framework and Design Considerations Presented By: Jason D. Pack, P.E. Fred Choa, P.E.
Problem 4: Clifton Country Rd/Route 146 Intersection Base Case Phasing and Volumes Analysis Plans Description of Analyses Overarching Issues 4a: AM peak.
Intersections.
Hcm 2010: BASIC CONCEPTS praveen edara, ph.d., p.e., PTOE
Rainier Avenue South Pilot Project Update Seattle Bicycle Advisory Board Project Manager Jim Curtin September 2, 2015.
Slower vehicle speeds (under 30 mph) means less severe crashes 90% reduction in fatalities, 76% reduction in injury crashes 75% fewer vehicle conflict.
Chapter 9 Capacity and Level of Service for Highway Segments
Intersection Control Chapter 8 Dr. TALEB AL-ROUSAN.
Chapter 6: Intersections
2.2- Traffic Signals. Traffic Lights Green Light- GO – You can proceed only if the intersection is clear. When approaching a green light, check traffic.
Chapter 8 1 Chapter 8. Design of Intersections for Safety and Efficiency 1. Find the critical gap for an unsignalized intersection approach (given data.
Lesson Plan For Day Two Power point presentation 30 min Video– AAA- signs, signals, etc. 20 min Quiz- Signs Etc 10 min Correct 10 min H/O- Signs 10 min.
1 Section III Day 2. 2 In this picture are a pedestrian, an inline skater, and a cyclist. They are all going the same way. Which roadway user has right.
Chapter 8. Design of Intersections for Safety and Efficiency
Rules of the Road.
Signalized Intersections
Safe Driving Rules and Regulations
Presentation transcript:

Lecture 6: Stop Sign Control & Signalized intersections & Design LOS Explain there is hierarchy of intersection control Use the warrants for 2-way stop control Evaluate traffic signal warrants (by volume only) Apply the knowledge to the Moark Junction design Lecture objectives: By the end of this lecture the student will be able to:

The Hierarchy of Intersection Control Intersection Control Options: How much judgment can drivers safely exercise to avoid collisions? Three levels of control are available. Which one will be proper for the Moark Junction in the future? Level IPassive control – basic rules of the road apply  No control  Guide signs only  Warning sings with or without guide signs Level IIDirect assignment of ROW to major street or rotational ROW  YIELD control (roundabouts are in this category)  Two-way STOP control  All-way STOP control Level IIIPositive alternate assignment of exclusive ROW  Traffic signals: 2-phase, multiphase  Traffic control agent/officer

Warrants for two-way STOP sign Because the STOP sign causes a substantial inconvenience to motorists, it should be used only where warranted. A STOP sign may be warranted where one or more of the following conditions exist: A.Intersection of a less important road with a main road where application of the normal ROW rule would not be expected to provide reasonably safe operation. B.Street entering a through highway or street. C.Unsignalized intersection in a signalized area. D.High speeds, restricted view, or crash records indicate a need for control by the STOP sign. Level II Control: STOP Control Two-way stop control

Level III Control: Traffic Control Signals While warrants and other criteria for STOP and YIELD signs are somewhat general in the MUTCD, warrants for signals are quite detailed. Advantages of traffic signal control Provide for the orderly movement of traffic Increase the traffic-handling capacity of the intersection if applied properly and physical layout is conducive Reduce the frequency and severity of certain types of crashes, esp. right-angle collisions Provide for continuous or nearly continuous movement at a definite speed when coordinated (by coordination) Used to interrupt heavy traffic at intervals to permit other traffic, vehicular or pedestrian, to cross

Disadvantages of traffic signal control Excessive delay (when timing is improper) Excessive disobedience of the signal indications (when red interval is improperly long) – may encourage red-light running Increased use of less adequate routes as road users attempt to avoid the traffic control signal Significant increases in the frequency of collisions (especially rear-end collisions)

Data requirements 1.Traffic volumes in each approach, at least 12 consecutive hours (24 hrs count preferred) containing the highest % of 24-hour traffic (include two peak periods) 2.15-min counts by approach and movement classified by vehicle type during the 2 hours in the AM and PM peak periods (4 hours total) 3.Pedestrian counts in each crosswalk during the same 4 hours in item 2 4.Information on nearby facilities and centers serving the movement disadvantaged (young, elderly, or disabled) 5.Posted or statutory speed limit and/or the 85the percentile speed 6.A condition diagram 7.A collision diagram 8.For the two peak AM and two peak PM hours: a)Vehicle-hours of stopped delay for each approach b)Number and distribution of gaps c)Speed limits d)Pedestrian delays for at least two 30 minute peak pedestrian delay periods e)Queue lengths on STOP- controlled approaches Warrants for traffic signals

MUTCD 2000 has 8 warrants for a traffic signal. They are guides, not specifications. Use professional judgments. (Note MUTCD 2009 became effective January 15, Two years to comply.  Warrant 1: Eight-hour vehicular volume (1a: minimum traffic volume; 1b: interruption of traffic; 1c: combination of warrants)  Warrant 2: Four-hour vehicular volume  Warrant 3: Peak hour  Warrant 4: Pedestrian volume  Warrant 5: School crossing  Warrant 6: Coordinated signal system  Warrant 7: Crash experience  Warrant 8: Roadway network Signals Warrants

Signal warrant 1A: 8-hour volume Min. vehicle volume: Principal factor is the intersection traffic volume. Must satisfy for each of any 8 hour of an average day.  May reduce the values by 30% if the 85 th percentile speed on the major approach is greater than 40 mph or population is less than 10,000 (built-up area of isolated community).

Signal warrant 1B Interruption of continuous traffic: The volume requirements must be met for each of any 8 hours of an average day.  May reduce the values by 30% if the 85 th percentile speed on the major approach is greater than 40 mph or population is less than 10,000 (built-up area of isolated community).

Signal warrant 1C Combination of warrants: Only in exceptional cases. When none of them are satisfied but when the first two warrants of Warrant 1 are satisfied to the extent of 80% of the stipulated volumes.

Signal warrant 2: 4-hour volume Check for each of any 4 hr of an average day

Signal warrant 3: Peak-hour volume Justified where traffic condition during 1 hr of the day result in undue delay to traffic on the minor street. (factories, office park etc.)

Signal warrant 3B: delay This warrant is satisfied when the delay during any four consecutive 15-minute periods on one of the minor-street approaches (one direction only) controlled by a STOP sign is equal to or greater than specified levels and the same minor- street approach (one direction only) volume and the total intersection entering volume are equal to or greater than the specified levels: 1. Delay experienced by minor approaches  4 vehicle-hours for a one-lane approach and 5 vehicle-hours for a two-lane approach. 2. Volume on the same minor approaches  100 vph for one moving lane of traffic, 150 vph for two moving lanes of traffic. 3. The total entering volume serviced during the hour equals or exceeds 800 vph entering volume for intersections with four or more approaches or 650 vph for intersections with 3 approaches. This applies to cases in which STOP control is already in effect for the minor road. Cannot jump from no-contro or YIELD to signals.

Moark Junction: Does it warrant a signal in 2035 in terms of Warrant 1 if the traffic growth rate you decided to use is applied to this intersection?

2009 turning counts by UDOT 2009 Turning Count Data Hour BeginUS 6 EB LTUS 6 EB THUS 6 EB TotalUS 6 WB THUS 6 WB RTUS 6 WB TotalUS 89 SB RTUS89 SB LTUS 89 SB TotalHourly Entering Vehicles 0: : : : : : : : : : : : : : : : : : : : : : : : Total US89 Northbound at Moark Junction = = 988

2009 Peak Hour Turns Estimates SB Right SB total

2035 turning count estimates US89 Northbound at Moark Junction = = 1,041

2035 Peak Hour Turns Estimates