VerilogA Overview  The schematic of the VerilogA transistor model is shown here. It is a table lookup-based model. The tables for I d V g, C gd and C.

Slides:

Advertisements

Similar presentations

Goals Investigate circuits that bias transistors into different operating regions. Two Supplies Biasing Four Resistor Biasing Two Resistor Biasing Biasing.

Advertisements

Transistors (MOSFETs)

Metal-Oxide-Semiconductor Fields Effect Transistors (MOSFETs) From Prof. J. Hopwood.

University of Toronto ECE530 Analog Electronics Review of MOSFET Device Modeling Lecture 2 # 1 Review of MOSFET Device Modeling.

Chapter 6 The Field Effect Transistor

J-FET (Junction Field Effect Transistor) Introduction The field-effect transistor (FET) controls the current between two points but does so differently.

MOSFETs Monday 19 th September. MOSFETs Monday 19 th September In this presentation we will look at the following: State the main differences between.

NAME OF FACULTY : MR. Harekrushna Avaiya DEPARTMENT: E.C. (PPI-1ST) BASIC ELECTRONICS.

Logical Effort Section Problems: P6.2 Compute the oscillation frequency of a seven-stage ring oscillator using 0.18 micron technology. Does.

Lecture 11: MOS Transistor

Lecture #26 Gate delays, MOS logic

Metal Semiconductor Field Effect Transistors

S. Reda EN160 SP’07 Design and Implementation of VLSI Systems (EN0160) Lecture 11: Logical Effort (1/2) Prof. Sherief Reda Division of Engineering, Brown.

11/5/2004EE 42 fall 2004 lecture 281 Lecture #28 PMOS LAST TIME: NMOS Electrical Model – NMOS physical structure: W and L and d ox, TODAY: PMOS –Physical.

The metal-oxide field-effect transistor (MOSFET)

CSCE 612: VLSI System Design Instructor: Jason D. Bakos.

ECD 442 Power Electronics1 Power MOSFETs Two Types –Depletion Type Channel region is already diffused between the Drain and Source Deplete, or “pinch-off”

Fig. 5.1 Physical structure of the enhancement-type NMOS transistor: (a) perspective view; (b) cross section. Typically L = 1 to 10 m, W = 2 to 500.

Reading: Finish Chapter 6

Week 8b OUTLINE Using pn-diodes to isolate transistors in an IC

Chap. 5 Field-effect transistors (FET) Importance for LSI/VLSI –Low fabrication cost –Small size –Low power consumption Applications –Microprocessors –Memories.

Dr. Nasim Zafar Electronics 1 - EEE 231 Fall Semester – 2012 COMSATS Institute of Information Technology Virtual campus Islamabad.

Chapter Five The Field-Effect Transistor. Figure 6—2 A three-terminal nonlinear device that can be controlled by the voltage at the third terminal v.

Simulation of CMOS inverters based on the novel Surrounding Gate Transistors. A Verilog-A implementation. A. Roldán, J.B. Roldán and F. Gámiz Departamento.

MOS Capacitors ECE Some Classes of Field Effect Transistors Metal-Oxide-Semiconductor Field Effect Transistor ▫ MOSFET, which will be the type that.

Transistors (MOSFETs)

By Squadron Leader Zahid Mir CS&IT Department, Superior University PHY-BE -21 Field Effect Transistor.

High Frequency MOSFET Model. Models for Computer Simulation Simple dc Model Small Signal Model Frequency-Dependent Small Signal Model Better Analytical.

Transistors Three-terminal devices with three doped silicon regions and two P-N junctions versus a diode with two doped regions and one P-N junction Two.

Field-Effect Transistors

Digital Integrated Circuits© Prentice Hall 1995 Introduction The Devices.

Field Effect Transistor (FET)

ECE 342 Electronic Circuits 2. MOS Transistors

Ch 10 MOSFETs and MOS Digital Circuits

Twin Silicon Nanowire Field Effect Transistor (TSNWFET)

Field Effect Transistors By Er. S.GHOSH

Penn ESE370 Fall DeHon 1 ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 10: September 28, 2011 MOS Transistor.

1 Metal-Oxide-Semicondutor FET (MOSFET) Copyright  2004 by Oxford University Press, Inc. 2 Figure 4.1 Physical structure of the enhancement-type NMOS.

Chapter 11 Field effect Transistors: Operation, Circuit, Models, and Applications Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction.

Flash Memory …and a tour through FETs. Junction Field Effect Transistor.

1 Fundamentals of Microelectronics  CH1 Why Microelectronics?  CH2 Basic Physics of Semiconductors  CH3 Diode Circuits  CH4 Physics of Bipolar Transistors.

CSCE 613: Fundamentals of VLSI Chip Design Instructor: Jason D. Bakos.

Field Effect Transistor. What is FET FET is abbreviation of Field Effect Transistor. This is a transistor in which current is controlled by voltage only.

NMOS PMOS. K-Map of NAND gate CMOS Realization of NAND gate.

Junction Capacitances The n + regions forms a number of planar pn-junctions with the surrounding p-type substrate numbered 1-5 on the diagram. Planar junctions.

Linear Delay Model In general the propagation delay of a gate can be written as: d = f + p –p is the delay due to intrinsic capacitance. –f is the effort.

PROCESS AND DEVICE SIMULATION OF A POWER MOSFET USING SILVACO TCAD.

1 Chapter 5. Metal Oxide Silicon Field-Effect Transistors (MOSFETs)

EE210 Digital Electronics Class Lecture 7 May 22, 2008.

ISAT 436 Micro-/Nanofabrication and Applications Transistors David J. Lawrence Spring 2004.

CMOS Logic.  The CMOS Logic uses a combination of p-type and n-type Metal-Oxide-Semiconductor Field Effect Transistors (MOSFETs) to implement logic gates.

MOSFET Placing an insulating layer between the gate and the channel allows for a wider range of control (gate) voltages and further decreases the gate.

Integrated Circuit Devices Professor Ali Javey Summer 2009 MOSFETs Reading: Chapters 17 & 18.

Electronics The Twelfth and Thirteenth Lectures Eleventh week / 1/ 1437 هـ أ / سمر السلمي.

EE210 Digital Electronics Class Lecture 6 May 08, 2008.

Junction Field Effect Transistor

MOS Capacitors UoG-UESTC Some Classes of Field Effect Transistors Metal-Oxide-Semiconductor Field Effect Transistor ▫ MOSFET, which will be the.

MOSFET Current Voltage Characteristics Consider the cross-sectional view of an n-channel MOSFET operating in linear mode (picture below) We assume the.

Animation of the MOSFET manufacturing process I encourage you to look at the website given below and use the button “animate to next” – the actual process.

Field Effect Transistor (FET)

CP 208 Digital Electronics Class Lecture 6 March 4, 2009.

Transistors (MOSFETs)

The MOS capacitor. (a) Physical structure of an n+-Si/SiO2/p-Si MOS capacitor, and (b) cross section (c) The energy band diagram under charge neutrality.

Government Engineering College Bharuch Metal Oxide Semiconductor Field Effect Transistors{MOSFET} Prepared by- RAHISH PATEL PIYUSH KUMAR SINGH

COURSE NAME: SEMICONDUCTORS Course Code: PHYS 473 Week No. 9.

SILVER OAK COLLEGE OF ENGG. & TECHNOLOGY  SUB – Electronics devices & Circuits  Topic- JFET  Student name – Kirmani Sehrish  Enroll. No

THE CMOS INVERTER.

MOS TRANSISTOR (Remind the basics, emphasize the velocity saturation effects and parasitics) Structure of a NMOS transistor.

6.3.3 Short Channel Effects When the channel length is small (less than 1m), high field effect must be considered. For Si, a better approximation of field-dependent.

IGBT - Insulated Gate Bipolar Transistor

Presentation transcript:

VerilogA Overview  The schematic of the VerilogA transistor model is shown here. It is a table lookup-based model. The tables for I d V g, C gd and C gs are obtained using the TCAD models  The TCAD models are the same as those shown in the previous except that the gate lengths are all set to L G 20nm  The parasitic Series Resistance and parasitic External Capacitance are not included in the TCAD model and are to be added at the circuit level as shown in the schematic above

Assumption for TFET VerilogA Models  For the Tunnel FETs, we assume identical drive-currents for the n-channel and p- channel transistors  The electron and hole Density-of-States can be quite different in III-Vs. We assume different Gate capacitances for the n-type and p-type transistors  For Si MOSFETs, we assume identical drive-currents and gate capacitances for n-type and p-type transistors

Spectre Circuit Simulation  In order to execute the circuit simulations you need to have Virtuoso Spectre Circuit Simulator installedVirtuoso Spectre Circuit Simulator  In order to run the idvg simulation use: spectre InAs_ntfet_idvg.scs  In order to run the FO1 inverter simulation use:  spectremdl –b inverter_InAs_tfet_FO1.mdl –d inverter_InAs_tfet_FO1.scs –measure inverter_InAs_tfet_FO1.measure  In order to run the Ring Oscillator simulation use  spectremdl -b InAs_Ring_Oscillator.mdl -d InAs_Ring_Oscillator.scs – measure InAs_Ring_Oscillator.measure