U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW

Note: Use a dowel to eject the waste from the pipe tool. Make the ½” diameter holes with the pipe tool. Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel

Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel

Orthogonal Views of Product SKETCH and LABEL Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel

U3e-L8 Orthogonal Views of Product SKETCH and LABEL Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel

Draft the given shapes on paper. Be precise with your measurements and your drawings. Cut out shapes and discard all paper scraps. CLASSWORK 2 DRAWINGS 1 DRAWING Diameter=¼” Motor Design, Design Drawings, and Lesson Courtesy of Fred Nastvogel