Multiplexers and De-Multiplexers 1

Slides:



Advertisements
Similar presentations
Adders Used to perform addition, subtraction, multiplication, and division (sometimes) Half-adder adds rightmost (least significant) bit Full-adder.
Advertisements

Digital Logic Design Week 7 Encoders, Decoders, Multiplexers, Demuxes.
Decoders/DeMUXs CS370 – Spring Decoder: single data input, n control inputs, 2 outputs control inputs (called select S) represent Binary index of.
CHAPTER 2 Digital Combinational Logic/Arithmetic Circuits.
DIGITAL SYSTEMS TCE OTHER COMBINATIONAL LOGIC CIRCUITS WEEK 7 AND WEEK 8 (LECTURE 3 OF 3) MULTIPLEXERS DEMULTIPLEXERS.
Combinational Logic Building Blocks
ECE 301 – Digital Electronics Multiplexers and Demultiplexers (Lecture #12)
Multiplexer MUX. 2 Multiplexer Multiplexer (Selector)  2 n data inputs,  n control inputs,  1 output  Used to connect 2 n points to a single point.
Example of a Combinatorial Circuit: A Multiplexer (MUX)
 Combinational circuit that selects binary information from one of many input lines and directs information to a single output line.
Part 2: DESIGN CIRCUIT. LOGIC CIRCUIT DESIGN x y z F F = x + y’z x y z F Truth Table Boolean Function.
Multiplexers DeMultiplexers XOR gates
Combinational Logic Design
Digital Computer Concept and Practice Copyright ©2012 by Jaejin Lee Logic Circuits I.
1 Digital Logic Design Week 7 Decoders, encoders and multiplexers.
MSI Devices M. Mano & C. Kime: Logic and Computer Design Fundamentals (Chapter 5) Dr. Costas Kyriacou and Dr. Konstantinos Tatas ACOE161 - Digital Logic.
WEEK #9 FUNCTIONS OF COMBINATIONAL LOGIC (DECODERS & MUX EXPANSION)
Eng. Mohammed Timraz Electronics & Communication Engineer University of Palestine Faculty of Engineering and Urban planning Software Engineering Department.
Fall 2004EE 3563 Digital Systems Design EE3563 Multiplexers  A multiplexer is a digital switch  Allows a device to select a single line from many  Some.
Eng. Mohammed Timraz Electronics & Communication Engineer University of Palestine Faculty of Engineering and Urban planning Software Engineering Department.
Mux 2.1 Multiplexers and De-Multiplexers 2: ©Paul Godin Updated November 2007.
Logical Circuit Design Week 6,7: Logic Design of Combinational Circuits Mentor Hamiti, MSc Office ,
Kuliah Rangkaian Digital Kuliah 6: Blok Pembangun Logika Kombinasional Teknik Komputer Universitas Gunadarma.
Digital Logic Structures: Chapter 3 COMP 2610 Dr. James Money COMP
Morgan Kaufmann Publishers
Multiplexers and Demultiplexers
CSE 140 Lecture 12 Combinational Standard Modules CK Cheng CSE Dept. UC San Diego 1.
MSI Counters Counter ICs Technician Series ©Paul Godin Updated Feb 2015 gmail.com.
Steering Gates, Timing Diagrams & Combinational Logic Technician Series Steering 1.1 ©Paul Godin Created Jan 2014.
Basic Gates 2.1 Basic Digital Logic: Application of Digital Gates using AND / OR / NOT ©Paul Godin Created August 2007 Last Update Sept 2013 Basic Gates.
Basic Gates 1.1 Basic Digital Logic: AND, OR and NOT gates ©Paul Godin Created August 2007 Last Update Sept 2013.
Counters 2.1 MSI Counters Counter ICs ©Paul Godin Updated Aug 2013 gmail.com.
Magnitude Comparator A magnitude comparator is a combinational circuit that compares two numbers, A and B, and then determines their relative magnitudes.
Multiplexers and De-Multiplexers
Multiplexors Decoders  Decoders are used for forming separate signals for different combination of input signals.  The multiplexer circuit is a digital.
Company LOGO Edit your slogan here DKT 122/3 DIGITAL SYSTEM 1 WEEK #8 FUNCTIONS OF COMBINATIONAL LOGIC (ENCODER & DECODER, MUX & DEMUX)
ECE 2110: Introduction to Digital Systems Chapter 6 Combinational Logic Design Practices Multiplexers.
1 DLD Lecture 16 More Multiplexers, Encoders and Decoders.
Multiplexer (MUX) A multiplexer can use addressing bits to select one of several input bits to be the output. A selector chooses a single data input and.
Multiplexers & Decoders By: Jason Pitts CS 147 Spring 2010.
CSE 140 Lecture 13 Combinational Standard Modules Professor CK Cheng CSE Dept. UC San Diego 1.
Chapter4: Combinational Logic Part 4 Originally By Reham S. Al-Majed Imam Muhammad Bin Saud University.
CSE 140 Lecture 12 Combinational Standard Modules CK Cheng CSE Dept. UC San Diego 1.
Multiplexer.
ACOE161 (Spring2007)MSI Devices1 Revision on MSI Devices M. Mano & C. Kime: Logic and Computer Design Fundamentals (Chapter 5)
MSI Circuits.
CHAPTER 2 Digital Combinational Logic/Arithmetic Circuits.
Multiplexer.
EKT 124 MUX AND DEMUX.
CS221: Digital Logic Design Combinational Circuits 3
CSE 140 Lecture 12 Combinational Standard Modules
Combinational Circuits
OTHER COMBINATIONAL LOGIC CIRCUITS
The Multiplexer Multi what?
Hasib Hasan Ankit Baingane Edward Hanson
Unit5 Combinational circuit and instrumentation system.
CSE 140 Lecture 12 Combinational Standard Modules
Magnitude Comparator A magnitude comparator is a combinational circuit that compares two numbers, A and B, and then determines their relative magnitudes.
Latches and Flip-Flops 2
EET107/3 DIGITAL ELECTRONICS 1
Basic Digital Logic: X-OR and X-NOR Gates
COE 202: Digital Logic Design Combinational Circuits Part 3
Lecture 10 Logistics Last lecture Today
Instructor: Alexander Stoytchev
Basic Digital Logic: AND, OR and NOT gates Technician Series
Latches and Flip-Flops 2
Electronics for Physicists
Digital System Design Combinational Logic
ECE2030 HW-6.
Example of a Combinatorial Circuit: A Multiplexer (MUX)
Presentation transcript:

Multiplexers and De-Multiplexers 1 ©Paul Godin Updated Sept 2009

Definitions Multiplexer: A device that selectively forwards a single source of data from multiple sources. Often called a MUX. Input Signals Output signal Selection

Definitions De-Multiplexer: A device that forwards an input signal to a selected output. Often called a DEMUX. Input Signal Output signal Selection

Multiplexer – Selected input to single output A B C D S0 S1 Y A B C D Output Rotary selector switch Mechanical Equivalent Logic Diagram

De-multiplexer – Single input to selected output A A Y Input B B C C D D Rotary selector switch S0 S1 Mechanical Equivalent Logic Diagram

MUX and DEMUX Combination A mechanical combination MUX and DEMUX is often used when evaluating stereo equipment in a store. Unit #1 Unit #2 Unit #3 Unit #4 Speakers #1 Speakers #2 Speakers #3 Speakers #4 Selector (MUX) (DEMUX) Direction of data

MUX and DEMUX Combination A combination MUX and DEMUX is used in data communications.

Multiplexers

Examples of Multiplexers Examples of selectively forwarding an input signal to an output includes: Selection switch on a home stereo, where one selects between several sources to be sent to the amplifier and speakers. A multi-line telephone where one line is selected. A video surveillance monitor that switches between cameras. Multiplexers are used extensively in data and voice communication networks

Multiplexers Digital applications for multiplexers include external and internal applications (steering gates). Multiplexers are often used in conjunction with other digital circuits such as decoders, counters and other multi-function devices.

A Simple Multiplexer (2-input) Z B A If S = 0, value A is forwarded If S = 1, value B is forwarded Boolean Expression: Z = S’A + SB

A 4-to-1 Multiplexer S0 S1 Z B C D A

A 4-to-1 Multiplexer with Enable S0 S1 Z B A C D En’ What is the Boolean Expression for this circuit? Build a function table for this circuit

A multi-channel MUX Channel 1 a b c d Channel 2 En S A1 B1 C1 D1 A2 B2

Multi-Channel MUX in a Digital Alarm Clock V Decoder Decoder Decoder AM PM Alarm / Real Time Decoder Digital Clock Real Time 13 bits Digital Clock Alarm Time 13 bits The MUX permits the sharing of the displays and the decoders.

A 7-Segment Display for Multiplexing c b a d e f g Common: Digit 1 Common: Digit 2 c b a d e f g Common: Digit 1 Common: Digit 2 To display a digit enable the common for that digit only.

Multi-Channel MUX in a Shared Display Oscillator Select Decoder 10’s counter 1’s counter Oscillator With a high enough frequency, the digits appear to both be lit at the same time.

4-to-1 MUX in a Basic Frequency Selector Binary Value S0 S1 ÷2 250Hz ÷2 500Hz Output ÷4 1kHz ÷1000 4kHz The MUX selects the output frequency. 4MHz Crystal

Questions What is the difference between a multiplexer and a decoder?

End prgodin @ gmail.com