Adapt this file to match your company’s work Module Area(s)… Change the content (Image & Text) of each slide, just be sure not to change the actual formatting. If you include a “Safety” section, you are still required to change the content into your own words with revised pictures.

PowerPoint Jeopardy Category 5 Axle/wheelbase Category 4 Cartridge Hole Category 3 Eye Screws Category 2 Wheels Category 1 CO 2 Body “Doubled Falcons”

How long should the body length be in milimeters… Category 1 – 10 points

What type of wood would you use... Category 1 – 20 points

Body height with wheels is... Category 1 – 30 points

How many axles should a car have? Category 1 – 40 points

Total Body Mass Category 1 – 50 points

How many wheels should a car have? Category 2 – 10 points

The wheel diameter Should be from… Category 2 – 20 points

The wheel width Should be from… Category 2 – 30 points

All the wheels should touch the ground at the… Category 2 – 40 points

The wheel should be made from… Category 2 – 50 points

How many eye screws should the Co2 car have? Category 3 – 10 points

Should the screws make contact with the racing surface? Category 3 – 20 points

What should the string pass through? Category 3 – 30 points

What is the inside diameter of the eye screw? Category 3 – 40 points

The distance apart of the eye screws should be from… Category 3 – 50 points

What is the minimum of the thickness around the entire hole? Category 4 – 10 points

The hole depth should be? Category 4 – 20 points

The safety zone thickness should be? Category 4 – 30 points

The chamber diameter should be from… Category 4 – 40 points

Lowest point of chamber diameter to the race surface should be… Category 4 – 50 points

Co2 must have how many axles? Category 5 – 10 points

Bottom of axle hole or Bearing above bottom of car Should be from… Category 5 – 20 points

Rear axle hole from rear of car should be from… Category 5 – 30 points

Wheelbase should be… Category 5 – 40 points

Must have how many axle clips… Category 5 – 50 points