2/26: Wide World of Modems Roll call. Video: modem Lecture: step- by-step 113 2514.

Slides:

Advertisements

Similar presentations

Serial Interface Dr. Esam Al_Qaralleh CE Department

Advertisements

Telecommunications & Networking

ITEC 352 Lecture 34 Communications. Review USB –How did you like the material (1-10) from bad to good –What did you learn? Differences between bus types.

1 Homework Reading –Tokheim, Section 13-6 Continue mp1 –Questions? Labs –Continue labs with your assigned section.

Layer Physical – WAN Pertemuan 10 Matakuliah: H0484/Jaringan Komputer Tahun: 2007.

Sem 6 – Chap 2 All You Need to Know about Modems.

1 Pertemuan 12 Layer Physical Matakuliah: H0174/Jaringan Komputer Tahun: 2006 Versi: 1/0.

Chapter 2 Data Communication Concepts Code Transmission Signal Modulation Service.

PC Modem Control The 8250 UART supplied with the PC supports a limited number of RS-232-C modem functions: The UART can be programmed to interrupt the.

Eng. Husam Alzaq The Islamic Uni. Of Gaza

Electronics and Networks: Dumb things with Wires Week 2: Serial Overview Jonah Brucker-Cohen Matthew Karau Monday 10am - 12pm Trinity College Dublin MSc.

EET Advanced Digital Chapter 21 Serial Ports.

1 The 9-Pin Connector Pin abbreviations (numbers in parentheses are the 25D pin numbers): 1. CD (8) 2. RD (Rx) (3) 3. TD (Tx) (2) 4. DTR (20) 5. SG (Ground)

ECE 371- Unit 11 Introduction to Serial I/O. TWO MAJOR CLASSES OF SERIAL DATA INTERFACES ASYNCHRONOUS SERIAL I/O - USES “FRAMING BITS” (START BIT AND.

PC 232 Serial Ports Ports –Connectors at back of PC –Plus related internal electronics to send/receive PC 232 Serial Port –Follows EIA/TIA 232 standards.

3/17 Parallel and Serial Ports. Roll Call Lecture: –ports –serial ports –parallel ports –USB ports Group Project Information - Handout.

1 CONTENTS All about modems. Comparison of various types of modem. Modem speed. Modem standards. Data compression and error correction. Installation,configuring.

University of Tehran 1 Interface Design Serial Communications Omid Fatemi.

Analog Modem Last Update Copyright Kenneth M. Chipps Ph.D. 1.

Chapter 10 Supporting Modems. You Will Learn… How modems work and how to install them About communications software that modems use to communicate with.

The University of Iowa. Copyright© 2005 A. Kruger 1 Introduction to Wireless Sensor Networks Engineering Issues I 31 March 2005.

Transmission Modes Serial Transmission  One bit is transmitted on a circuit at a time  Usually there is one transmit circuit and one receive circuit.

Computers in Surveying SVY2301 / E4006 Automated Surveying.

3.1 Basic concepts of data communications and networking

Serial Port I/O Serial port sends and receives data one bit at a time. Serial communication devices are divided into: Data Communications Equipment (DCE),

AS Computing F451 F451 Data Transmission. What data is transmitted? Phone SMS Radio TV Internet.

Modems Chapter 11 Release 22/10/2010powered by dj.

Chapter 7 Networking: Computer Connections. Networks n Network - a computer system that uses communications equipment to connect two or more computers.

Modems Chapter 17. Basic Knowledge  Modems are little devices to use the telephone to talk to other computers.  Modem is an abbreviation for Modulator/

Universal Synchronous/Asynchronous Receiver/Transmitter (USART)

Line Coding, Modem, RS232 interfacing sequences.

1 Lecture #2: Components of Network. Communication Subnetwork C o n t e n t s l Network Architecture: –Terminal Network –Computer Network l Data Transmission.

“Describe the overview of hardware interfacing and the serial communication interface. Describe the PIC18 connections to RS232. Explain the serial port.

Microprocessors 2 lesson Subjects lesson 7 Planning Interrupts Serial communication /USART Questions.

Serial Communications

Advanced Embedded Systems Design Lecture 8 Serial I/O BAE Fall 2004 Instructor: Marvin Stone Biosystems and Agricultural Engineering Oklahoma.

Modem A Presentation Department of Computer Engineering,

 8251A is a USART (Universal Synchronous Asynchronous Receiver Transmitter) for serial data communication.  Programmable peripheral designed for synchronous.

1 School Spain Unidad 2: Comandos Hayes. School Spain 2 Comando Hayes: Descripción A Go off-hook and attempt to answer a call. B0 Select V.22 connection.

CSE466 Autumn ‘00- 1 What’s Coming  Hardware  Basic Filters and Noise Management  Serial Communications  Design Meeting  Move the quiz up to Monday.

©UNT in partnership with TEA1 Telecommunications & Networking Unit Subtitle: Modems.

Interfaces and Synchronization Martin Weiss. EIA 232D Interface Standard u Synonymous with ITU V.24 u Asynchronous interface u Up to 19.2kbps u 50 foot.

1 Asynchronous voice band modem for IP data protocols overview features.

Digital Interfaces An interface links two devices Interface Standards define: – mechanical specifications - how many wires & connector type –electrical.

Modems How They Work. Modem A device used by a PC to communicate over a phone line or cable A device used by a PC to communicate over a phone line or.

Review: The physical layer. Bandwidth/Capacity bit rate/baud rate How to determine the number of bits per symbol? Relation between the bandwidth and capacity:

CSC 335 Data Communications and Networking Lecture 4b: Communication and Multiplexing Dr. Cheer-Sun Yang.

1 Chapter Overview Modems The Internet and Web Browsers.

©F.M. Rietti Communication Lines Fundamentals. ©F.M. Rietti LM-18 Computer Science SSI Embedded Systems I 2 Communication Lines Generally used to connect.

A+ Guide to Managing and Maintaining Your PC Fifth Edition Chapter 17 Supporting Modems.

BASICS OF SERIAL COMMUNICATIONS BIRLA VISHWKARMA MAHAVIDYALAYA ELECTRONICS & TELECOMMUNICATION DEPARTMENT PRESENTING BY: ABHISHEK SINGH AMANDEEP.

Modem. Introduction: A modem [Modulator -Demodulator] is a device. Data communication means transmitting digital information form one computer to other.

Layer Physical – WAN Pertemuan 03 Matakuliah: H0524/Jaringan Komputer Tahun: 2009.

NARNARAYAN SHASTRI INSTITUTE OF TECHNOLOGY Prepared by: Wasu Ichcha kaur H Bhalani Nidhi M Dhakate Megha D MICROCONTROLLER.

Serial mode of data transfer

RS-232 Communications.

Homework Reading Continue mp1 Labs Tokheim, Section 13-6 Questions?

CS-401 Computer Architecture & Assembly Language Programming

MODEMS (Converts analog signals to digital and vice-versa)

6장 Transmission of Digital Data: Interfaces and MODEMs

Modem acronym for modulator-demodulator

RS-232 Communications.

Serial Communication: RS-232 (IEEE Standard)

Modem A Presentation Department of Computer Engineering,

Serial Communication Interface: Using 8251

Serial Communication Interface

Lecture 8: Modems (Converts analog signals to digital and vice-versa) 1nd semester By: Adal ALashban.

Data Communication.

CHAPTER SERIAL PORT PROGRAMMING. Basics of Serial Communication Computers transfer data in two ways: ◦ Parallel  Often 8 or more lines (wire.

Broadband Transmission

Presentation transcript:

2/26: Wide World of Modems Roll call. Video: modem Lecture: step- by-step

1. The DTR signal The PC sends a signal to the modem on line 20. This DTR (Data Terminal Ready) signal tells the modem that the PC is ready to go

1A. The DSR signal At the same time, the PC hears a voltage, Data Set Ready (DSR), from the modem’s pin 6, saying the modem is ready. Both signals are required for anything to happen

2. Transmit Data line. The software sends a command to the modem via line 2, the Transmit Data Line. It will switch to tones and pulses, dial, or disconnect

3. The hailing frequency. When the modem on the other end answers, your modem lets you know by telling you in two high pitched beeps. (Much like R2D2 would.)

3. Carrier detect The modem sends the PC a Carrier Detect (CD) signal on line 8. The signal is a steady tone that will later be modulated to transmit data

5. The handshake. The 2 modems discuss how they will exchange data. The modems must agree on speed, number of bits, & what info to send

5A. Terms. Handshake: the negotiations. Data packet: a block of data with start and stop bits. Parity bit: a doublechecking bit for error control

6. The PC tries to send data. The PC sends data by first signaling on line 4 of the serial port. This Request to Send (RTS) signal asks if the modem is free to receive data from the PC

7. The modem says “okey dokey”. Unless the modem is busy, it sends a Clear To Send (CTS) signal back to the PC on line 5. The PC sends the data on line

7A. The modem receives data. The modem sends data it receives to the PC on line 3. The modem drops the CTS signal if it is overwhelmed. It turns it back on after it catches up

8. On the other end of the phone line. The remote modem converts the incoming analog tones into digital signals. The remote computer then processes the digital signals

9. Sign off. The PC tells the modem to break the connection. If the other computer breaks the connection, the Carrier Detect signal is dropped and the PC alerted. Goodbye

In the future: Monday 3/1: web pages are due by noon. Wednesday 3/3: optional review session. Friday 3/5: midterm exam. Today’s entertainment: