Topic: Light Emitting Diodes Objective: ▫ Explain why LEDs only work with one setup and other bulbs are not as critical. Summary: Students use a battery.

Slides:

Advertisements

Similar presentations

Introducing circuits.

Advertisements

Living with the Lab Using Your Arduino, Breadboard and Multimeter EAS 199A Fall 2011 Work in teams of two!

TIJ1O1 ELECTRONIC COMPONENTS AND CIRCUITS 1. Recap: What is an electric current? An electric current is a flow of microscopic particles called electrons.

George Washington University DC Circuits Lab Professor Ahmadi ECE 002.

Using Your Arduino, Breadboard and Multimeter Work in teams of two! living with the lab 1 © 2012 David Hall.

Potential Difference (Voltage). Potential Difference Potential difference, or voltage, is the difference in electric potential energy per unit of charge.

Electronics Chapter 53 What is Electronics? Electronics is the careful and exact control of very small electric currents. It is used in many small devices.

How Does Electricity Flow? Electricity & Magnetism Science Instructor: Miss Aartman.

Electrical Energy - Moving electrons in a path is electricity

Breadboards, Multimeters, and Resistors EGR1301. Your Multimeter leads probes pincer clips – good for working with Boe-Bot wiring You will use the multimeter.

NPN Foundations of Technology NPN © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™ Foundations.

Integrated Science Unit 3, Chapter 7.

Direct Current (DC) and Alternating Current (AC). Series Circuits and Parallel Circuits.

10.7 Cells in Series and Parallel (page 310). A “dry cell” is another term for a battery. Dry cells can be put together in two ways to change the energy.

Measuring the Current and Voltage of a 820 Ω Resistor Setting for Multimeter = 200 mA DC Measure Voltage in 2 V increments up to 20 V.

 Electricity is caused by the flow (or net movement) of Electrons  Electric Current – the rate that positive charges flow in a circuit › Actually a.

Current, Voltage, and Resistance. Current, Voltage, and Resistance Explain 2-7 in your own words after you have viewed the slides Water Analogy Current-

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

Capacitor Foundations of Technology Capacitor © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

With a knowledge of how to connect cells in parallel and series, we can figure out how to arrange batteries to deliver a desired voltage, and in some cases,

“Introduction to Circuits”

Introduction to Electric Circuits. What is Electricity? No one really knows… A good definition for our class is: “Electricity is the flow of electrons.

Electrical Circuits. Electrical Circuit Closed path through which charge can flow A Circuit needs: 1.Source of energy (voltage) 2.Conductive path for.

Introduction to Electric Circuits. What is Electricity? No one really knows… A good definition for our class is: “Electricity is the flow of electrons.

Voltage, V Voltage tells us how hard a positive charge is pushed between two different points. Something, such as a battery, is needed to create a voltage.

Electronics Theory Bangor High School Ali Shareef 4/7/06.

Detection Circuit ENGR Lecture. Learning Objectives of Lab  Students will learn about –  Electronic circuit components  Building the binary.

Circuits, Systems, & the Arduino. Challenge: Make the bulb light up! -Make observations and explain why it has the setup it does? - What are the components.

How an NPN Transistor Works

Two basic types Ceramic disk Electrolytic Has positive and negative sides Farads – unit of measure (F) Microfarads(uF) and picofarads (pF) Cans have value.

TEKS 5.6B Demonstrate that the flow of electricity in circuits requires a complete path through which an electric current can pass and can produce light,

Chapter 8. Ohm’s Law  George Ohm experimented with circuits and came up with a mathematical relationship relating voltage, current and resistance in.

Can you get the bulb to work? Each of you will get one bulb, one wire, and one battery. Your goal is to get the bulb to light. Easy right? When you find.

Circuit Electricity May 30, 2012 Chapter 22. Terms  Current: Flow of charge  Symbolized by “ I ”  Units = Coulombs/second = Amperes (A)  Circuit:

RC Circuits MS&T Physics 2135, Lab O4. Objectives  Measure the time constant of a series RC circuit.  Determine C Note: You will be using a 1F, 5V electrolytic.

Resistors Foundations of Technology Resistors © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

Here are some graphics for the ohm’s law lesson. Read through the book, work out the assigned problems, and come up with a lesson plan (written on paper)

What materials are the best conductors. Possible Materials Aluminum Foil Paper Clips Wood Plastic Rubber Bands String.

Matter and Energy November 13, 2012 Ms. Smith Mrs. Malone DO NOW: Date: November 13, C demonstrate energy transformations such as how energy in.

Measuring Planck’s Constant Using Light Emitting Diodes (LED’s) Department of Physics and Astronomy Youngstown State University Dr. Michael Crescimanno.

Must Be Closed To Allow Electricity Flow; When Circuit Is Open No Electricity Flow CIRCUIT.

Diode Foundations of Technology Diode © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™ Foundations.

Photocell Foundations of Technology Photocell © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™

Building Circuits.

Introduction to Electric Circuits

Light Emitting Diode: LED

Aim: How is a Series Circuit different from a Parallel Circuit?

Do Now: Why does current not come from a battery? Explain.

Simple LED circuit.

Circuit Construction Kit Clicker Questions

Electronics – Learning Outcomes

Circuit Introduction Section 1:

Basic Electronics Year 10.

Saving Lighting Energy with the BBC micro:bit

Current Intensity and Voltage

Circuits Lecture 3.

Potential Difference (Voltage)

How a PNP Transistor Works

How an NPN Transistor Works

Equipment REQUIRED PRACTICAL.. This is a series of 3 practicals with graphs that need to be drawn. This will take multiple lessons Guidance for each practical.

Amps, Volts and Resistance (Ohm’s Law)

Voltage Difference The difference in electrical potential between two places. Unit of measure = V (volts) Voltage causes current to flow through an electric.

Basic Circuits.

Electricity and STEM Lab #5

Current Intensity and Voltage

Current We can measure the amount of current using an Ammeter. A

Solar cell setup.

TEKS 5.6B Demonstrate that the flow of electricity in circuits requires a complete path through which an electric current can pass and can produce light,

Electric Resistance describes how an electrical conductor (wire) opposes the flow of a current (flow of electrons) to overcome this opposition a voltage.

Presentation transcript:

Topic: Light Emitting Diodes Objective: ▫ Explain why LEDs only work with one setup and other bulbs are not as critical. Summary: Students use a battery and a red LED to determine the correct connections for this circuit. Students explain what happens based on both configurations and then a brief explanation is provided after the activity. Instructor Information

Topic: Light Emitting Diodes Methodology: ▫ Students experiment with the equipment to determine the solution. Explanation occurs after the trial and error troubleshooting. Differentiation: Students work in groups and students that have difficulty attaching the wires are given wires with banana clips instead of bare wires. Instructor Information

Light Emitting Diodes 3

LED Light

LED only work one way!! Electrons flow from Negative (-) to Positive (+) terminals BUT Current is the opposite direction because it is a positive flow of charges Current is positive flow and goes from Positive (+) to negative

LED Voltages LED ColorVoltage Drop Red1.8 Volts Green2.1 Volts Orange2.1 Volts Yellow2.1 Volts White3.5 Volts Blue3.6 Volts LED Currents Anywhere between 2 & 40 milliamps (mA)

Other Lighting Technology Incandescent Light Bulb Compact Fluorescent Light Bulb