To complete installation on electronic models run one wash cycle then click the DIP switch setting no.4 to the on position DIP switch settings

Electronic models Setting DIP switches Wash + Rinse Temperature adjustments DIP-switches

Temperature adjustments Dishwashing temperatures: Wash = 65°C. Rinse = 85°C Glasswashing temperatures: Wash = 55°C. Rinse = 65°C The current preset temperatures can be changed by entering config mode (machine off and on, then hold “power on button” for 5 secs) the preset temperatures will appear. IMPORTANT: turn trimmers only fraction at a time, then wait for the display to catch up, otherwise you will not see changes   Electronic models

Electronic Hood Type Models CHH50 Hood Dishwasher  6.8 kw /3 phase switchable to 5.1 kw/single phase  Up to 50 racks per hour  Hot or cold fill  Gravity drain CHH50D drain pump version  Fitted class A air gap  Fitted booster pump CHH60D Hood Dishwasher  9.1 kw / 3 phase switchable to 6.8 kw/single phase  Up to 60 racks per hour  Hot or cold fill  Fitted drain pump  Fitted class A air gap  Fitted booster pump CHH70D Hood Dishwasher  10.8 kw / 3 phase  Up to 70 racks per hour  Hot or cold fill  Fitted drain pump  Fitted class A air gap  Fitted booster pump

Electronic Hood Type Models Hood Dishwasher corner operation Inside the Hood Dishwasher

CHH50 CHH60 CHH70 POWER ON CYCLE SELECTOR TEMPERATURES WASH - RINSE CYCLE START (VIA HOOD) CYCLE START CONTINUOUS WASH Electronic models

HOOD TYPE - OPERATIONAL GUIDE  Press Power button - The display shows current temperature in each tank.  The rinse boiler begins to heat, The neon indicator next to cycle start will flash red.  At 85  C water fills the wash tank via the rinse arms. This operation is repeated automatically until the wash tank is full.  Once full and up to temperature the neon next to cycle start turns green.  Choose the programme you require. Glass symbol = 1 min, plate symbol = 2 min and pot symbol = 3 min. Push cycle start and the machine will run. During a cycle the neon light next to the chosen programme will flash green.  The  symbol allows you to use an extended wash programme, select this option and push cycle start, the machine will continue to wash until you push cycle start again to begin the rinse cycle.  The Auto start feature when activated allows you to start your chosen programme by closing the hood, eliminating the need to push cycle start each time. When in use the neon light next to auto start is illuminated green.  NOTE: During normal operation the cycle start neon only lights when the rinse boiler is over 85  c, you may start a wash cycle at anytime but the rinse cycle will only begin once the rinse temperature has been reached. Depending on your machine installation this may extend the wash cycle beyond the above times.  At the end of a session push the power switch, machine returns to standby, lift out the filter covering the wash tank and remove the drain plug. The wash tank will empty.  Alternatively if a drain pump is fitted: At the end of the session use the cycle selector switch to choose the drain option, lift out the filter covering the wash tank and remove the drain plug and push the cycle switch. The machine will automatically empty and return to standby. Electronic models

Electrical supply: supplied as 3 phase Note: CHH50 and CHH60 can be changed to suit 1 phase – (see diagram or run movie) Water pressure: minimum flow of 1.0 Bar If gravity drain version :max height = 200mm If drain pump version stand-pipe: max height = 820 mm Changing phasing and kW loading Hood type Chh50/60 Installation of hood type model

Three Phase Electrical Setting Three Phase Electrical Setting

Single Phase Electrical Setting Single Phase Electrical Setting