WS50(Stratacache) Software updating guide (By Using USB)

For the Remote usage 1. Use User remote that should be in the store. Navigation works OK. 2. Use SVC remote. But the navigation button is for channel and volume. So please use local button on the back for navigation. Only Press the POWER, ENTER, number button, IN-START, ADJ and EXIT. Do not use other buttons such as POWER ON. X 1

McDonalds FW updating Instruction LGE Confidential Date : `14.6.10 Notice Please check the Signage model information(1,2,3) before upgrading the New FW. The New FW must be updated to the specific version. Or the unit will be locked up. The ones that don’t match the information don’t need to have the new FW. 1. Check the Serial Number ※ The new FW must be downloaded on any unit dated before May, 2013. (305KCxxxxxxx) You can check the FW version and the Serial number in the “IN START” menu. ☞ Press “IN START” → Enter Password “0413” 2. Check the available FW version ※ Please see FW Version. It must be V3.09.00 or higher, If it is not, please update the FW ` 3. Check the Main OSD Color * Don’t Push “POWER ON” button. This is not the turn on KEY - Press the “Menu” Key - Depending on which FW version, some models may have Red OSD Color ※ The new FW must have Blue OSD Color 2

1. How to update MONITOR software Pull Down the Straps Locate 2 strap handles from the back of the monitor and Pull them down. Tilt Up Carefully pull the monitor towards you. 3

1. How to update MONITOR software IR Receiver Connection Connect the IR Receiver. Allows the use of a wired remote or IR receiver extension. USB Connection Connect the USB device to the USB IN jack on the Monitor. 4

2. Expert software update ※ Please turn off the Media Player or unplug the RS232C cable from the monitor before beginning this step 1)Insert the USB device into the USB jack. 2) Select Cancel or Press “EXIT” key when the pop up screen comes on 3) Press “Menu” → Press “▼” Button on the rear of the Monitor to highlight Option, then → Press “7”key seven times 4) Select the software to update 5) Wait until the update process is completed. After completion, the monitor will restart automatically 2. Update FW ` 4th button from right that “▼” Button 5

2. Expert software update  Current Version  Update Version ***Do not put check marks on Forced Update Options!! Select software to update. 6

2. Expert software update Once the auto-power cycle is completed after the upgrade, unplug the USB thumb drive from the monitor. ***Please DO NOT UNPLUG the USB thumb drive while upgrading*** 7

WS50 S/W Version - S/W Version : 3.09.00. - MICOM Version : 7.05.0 3. S/W Version info WS50 S/W Version - S/W Version : 3.09.00. - MICOM Version : 7.05.0 You can check the FW version and the Serial number in the “IN START” menu. ☞ Press “IN START” → Enter Password “0413” ` * Don’t Push “POWER ON” button. This is not the turn on KEY If above S/W version and MICOM version do not match with what you currently upgraded to then please check your F/W version on the USB thumb drive and follow the F/W upgrade procedure with a correct F/W again on page 2. 8

Menu Setup (manually) 11

4. Changing and Verifying the Settings Display Port -Please Select the input to Display Port. Time -Verify the “Time” settings below. Off Time = Off On Time = Off Sleep Timer = Off Power On Delay = Off Auto Off = Off Automatic Standby = Off Picture -Verify the “Picture” settings below. Energy Saving= Off Smart Energy Saving= Off 14