1) If you check IF output, ① if you check voltage with tester (DVM), 0.80V~1.20V is appeared. ② The signal is analog signal. In case you check with oscilloscope.

Slides:

Advertisements

Similar presentations

Beath High School - Int 1 Physics

Advertisements

Specialized in alarm system, CCTV research, manufacturing and trading.

The Worlds No.1 Bridge Navigation Watch Alarm System Introducing Navgard.

Security Options. Car Alarms Audible SoundsDoor Lock ActivatorsParking Light Flash Remote Panic Button (Optional) Starter Disable Protection (Optional)

Trouble - Shooting ELR - Electric Latch Retraction.

Reflectance Sensor Array: Line sensing Team: Grounded Rachel Kmetz, Matthew Forsyth, Austin Meirick, and Levi Eisel.

ELCT 301 Dr. Enrico Santi Equipment Testing & Troubleshooting Procedure © Prepared by: Rizwan Muzaffar.

ELECTRICAL. Circuits Outline Power Hub Microcontroller Sensor Inputs Motor Driver.

BE Lesson 8: Using the 555 IC timer chip .

Microwave Motion Sensor Modules (DNS-000 Series) ■ Features - X-Band Microwave Motion Sensor Module - * Used a RF the Microwave Sensor. * The up-to-date.

Connecting VEX and ROBOTC

Ahmed Abdel-Fattah Jerry Chang (a.k.a. Fred) Derrick Culver Matt Zenthoefer.

1st of year Checkout 1.Powering up detector(s) 1 st in the DARK Ramping up voltages slowly in 50 v steps 2. Look for signals 3. Check rates 4. Light leak.

45 nm transistor 45nm =.045um (microns)= 450 Angstroms.

Lecture 271 More Nodal Analysis. Lecture 272 Where We Are Nodal analysis is a technique that allows us to analyze more complicated circuits than those.

Project Check Point 3 Audio Interface Jeff Du. Overview Project specs and overview next Tue. Mid-term next Thurs. This audio interface lab is REALLY easy.

AUTOMATIC PLANT WATERING SYSTEM CREATED BY: KOOSHA DANESHI, CHAO JIANG, ALASTAIR FRASER.

SF-3000 Installation Manual. 2 Back of SF CON400) USB connector - User can use USB memory stick after connect USB connector of key PCB. CON500)

Programming Logic Controllers

Motion detector Bikesh Shrestha Ari Rajamäki.

VAT: Volt Ampere Tester

Team Members Jordan Bennett Kyle Schultz Min Jae Lee Kevin Yeh.

PIR MOTION SENSOR Mohammed Muhid Ahmed S Checked By: Uzair Aakhoon.

Country house Control Panel Glass break detector Hooter alarm Magnetic sensor Motion detector Security light.

PIR MOTION SENSOR Created by: Zaryab Altaf S

Module 4: Proximity Sensors Eng. Asma Abu Baker. Outlines Analog Sensors Digital Sensors Proximity sensors Inductive sensor Capacitive sensor Optical.

Negative resistance  Negative resistance is a property of some electric circuits where an increase in the current entering a port results in a decreased.

Driving Procedures & Maneuvers

■ Instruction Manual Thank you for purchasing this product. You are requested to use right, reading this instruction manual before use. Microwave Motion.

Question ONE What is the name of this component?.

LOGIC GATES A logic gate is an elementary building block of a digital circuit.digital circuit Most logic gates have two inputs and one output terminals.

Your Car Safeguard System Riding on a GSM mobile network.

Zhejiang TTN Electric Co., Ltd. Founded in 1994,Zhejiang TTN electric Co.,Ltd, has got ISO9001;2000 international quality systems authentication.

Motion Detecting Workstation Theodore Shinners Kevin Schmitz University of Iowa: Embedded Systems Spring 2011.

Gary QuartanaMotorola Confidential Proprietary V80 Trouble Shooting Guide Jul 17, 2003 ~10ns Power up time URTS1 GPIO control TPS851 output V80 Troubleshooting.

Which of the signals below is a digital signal?

Microprocessors Tutorial 2: Arduino Robotics. Agenda 1. Robot Anatomy 2. Sensor Review 3. PWM 4. MAKE: Fade 5. Motors 6. H Bridge 7. Robot Control library.

2010/2011 Lab Project. Lab Project Consist of Two Parts Demo Viva Total Marks Final Exam: 50% Test (2x) : 20% Lab Report: 10% Lab Test: 10% Lab Project:

Microwave Motion Sensor Modules (DNS-000 Series) ■ Features - X-Band Microwave Motion Sensor Module - * Used a RF the Microwave Sensor. * The up-to-date.

INTRODUCTION TO FBD - Function Block Diagram by ( LOGO ) Revision 2.

Rev Server blade enclosure overview Power backplane Signal backplane Management module Reset Bottom.

BMP085 Barometric Digital Pressure Sensor Module TYWu.

目录 12 in 1 Sensor Features ● PIR motion sensor ● Ultrasonic sensor ● LUX sensor ● Temperature sensor ● 2 Dry contacts ● 2 external condition inputs ● IR(infrared)

0-10V Ballast Dimmer HDL-MRDA HDL-MRDA channel 10A DC0 － 10V output module is a multifunction control module. It has 6 channel relay.

FEB Slide 1 Task No.:Point(s):1Only one answer is correct.Cat. No. To measure electrical … A current, the ammeter must be in line with the current.

HOT CAR BABY DETECTOR Group #20 Luis Pabon, Jian Gao ECE 445 Dec. 8, 2014.

BlueROV Electrical Interconnect Block Diagram

Connect VEX and ROBOTC Electrical Engineer Responsibilities © 2011 Project Lead The Way, Inc.Automation and Robotics VEX.

Basic Electricity END Alternators. 2 WHAT DOES AN ALTERNATOR DO? -IT GENERATES ELECTRICAL CURRENT -IT CONVERTS ALTERNATING CURRENT TO DIRECT CURRENT -IT.

Microwave Motion Activator I (Automatic Door Sensor)

Microwave Motion Sensor Module

(EVENING ON TO MORNING OFF)

Textbook Detection System With Radio-Frequency Identification

Zone Terminal MT/U Technical Overview

You have 5 minutes to look over your table of sensor and outputs ready for a spot check on the different symbols Start Timer 5 mins

EMBEDDED SYSTEMS SUCHITA M. DAKI.

Data Logging 1 WJEC ICT.

Electrical Engineer Responsibilities

CONNECTION METHOD (X-Band Microwave Motion Sensor Modules)

Chapter 31 Battery Systems.

CBC Fundamentals Lecture is based on material from Robotic Explorations: A Hands-on Introduction to Engineering, Fred Martin, Prentice Hall, 2001.

Theory of Operation PARADOX Technology DIGITAL Pet Proof Operation

CSE 171 Lab 11 Digital Voltmeter.

Process of Debugging a Circuit

SINKING AND SOURCING Two terms most frequently mentioned when discussing connections to inputs or outputs are “sinking” and “sourcing“. These two concepts.

Identify the equipment such as detector, electronics modules and NIM bin. Note down detector type, size, operating voltage.

LVDT You’re expected to learn

AM-7026 Down Converter-Receiver

ประกาศกระทรวงอุตสาหกรรม ฉบับที่ 5292 (พ.ศ. 2562)

Requirements and Verification

Presentation transcript:

1) If you check IF output, ① if you check voltage with tester (DVM), 0.80V~1.20V is appeared. ② The signal is analog signal. In case you check with oscilloscope (100MHz), analog wave is appeared.2) As mentioned above, IF shows output signal and voltage 0.80V~1.20V independently. 2) The check points are 2 points, "GND" and "IF" utilizing voltage tester (DVM). 3) Be sure to connect correctly (+,-) to power supply. The reverse connection of "+" and "-" will damage module. 4) Be sure to supply power to module between 4.8VDC ~ 5.2VDC(DNS-100C) and 2.3VDC~2.7VDC(DNS-100P). Dnet Co.,Ltd. Tel) , 3544 Fax) Web-site: CONNECTION METHOD (S-Band Microwave Motion Sensor Modules) Model No. : DNS-100CModel No. : DNS-100P OUTPUT – (1)Voltage:0.80VCC ~ 1.20VCC – (2)Signal: Analog Signal

Dnet Co.,Ltd. Tel) , 3544 Fax) Web-site: OUTLINE DRAWING (S-Band Microwave Motion Sensor Modules) Model No.:DNS-100 (Applications) 1. traffic / express highway watch and control. 2. security relation products (sensor and alarm set etc). 3. automobile rear collision warning. 4. automatic door activation. 5. sensor light. 6. sensors it applies in all products which operate. 5V or 2.5V

Dnet Co.,Ltd. Tel) , 3544 Fax) Web-site: ANTENNA PATTERN (S-Band Microwave Motion Sensor Modules) Model No.:DNS-100 ELEVATION

DongNam En-Tech Co.,Ltd. Tel) , 3544 Fax) Web-site: ANTENNA PATTERN (S-Band Microwave Motion Sensor Modules) Model No.:DNS-100 AZIMUTH