DMX Controller SB-DN-512DMX

Wiring 512ch DMX scene controller DMX bus to other DMX fixtures to Ethernet hub 512ch DMX scene controller DMX bus to other DMX fixtures Computer lighting Moving heads Moving heads

Wiring Diagram Wiring Diagram DMX bus DMX bus connect to other DMX fixture DMX status LED HDL Buspro 10-30VDC 3ch 650mA LED driver

3CH 650mA LED Driver Set the DMX start channel Special function: mainly for testing whether the device works or not 513 channel B ON 514 light G ON 515 light R ON 516 lights R&G&B ON Start channel(range001-512)： e.g., If you use screw driver to set the start channel as 004, then the rest two channels will be ch5 & ch6, so R channel=4, G channel=5, B channel=6.

IP Setting There is a LCD panel and some keys on this module, you can manually check or change the IP via them. Whenever the IP is changed, the module is needed to be reset. (press the four keys at the same time for several seconds.) e.g., set the IP as 192.168.10.122, then reset it, after that, change the IP of the laptop as 192.168.10.123 and ping 192.168.10.122, see if it can be pinged successfully. 4/26/2017

Basic Information subnet ID and device ID Device remark Generally no need to set it if just DMX512/1990 (if use Art-Net or HDL-NET, need to set these parameters.) Change the ID if needed

Area Current area Channels of current area

Area Remark Area remark Save

Area Setup Channels waiting to be assigned. Select an area Create new area Channels waiting to be assigned. Add channels to and delete channels from current area Channels in current area

Channel Channel remark Effect property - CANCELED Make sure that Lower limit ≤ Higher limit ≤ Max limit, setting range: 0% - 100% Mapping relationship between “HDL channel” and “DMX channel” Channel remark

Scene Select Area Fill in a range to be involved Scene remark

Scene Setup Useful option when creating a scene. Running time: the transit time till the scene reaches the preset brightness. Mix the levels of channels to create scene save Useful option when creating a scene.

Add Sequence Add sequence

4/26/2017 Sequence Current sequence Steps (scenes) of current sequence

Sequence Setup Step (scene) Qty Set running times Set sequence mode save

Sequence Setup 4/26/2017 save Assign a scene to each step Set running time of each step save

Channel Control use button 1 to control channel 1 of DMX512: Set 'single on/off' mode, and input the DMX 512 ID(1/104), control type is 'single channel lighting control', parameter1 is for channel number(1-4), paremeter2 is for brightness(0-100).

Scene Control use button 2 to control scene 1 of DMX512: Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'scene', parameter1 is for area number, paremeter2 is for scene number.

Sequence Control use button 3 to control sequence 1 of DMX512: Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sequence', parameter1 is for area number, paremeter2 is for sequence number.