4000 Imaje 4020 – Connectivity. 4000 Imaje 4020 – Content Content of Chapter Connectivity: 1. Interfaces 2. Serial connections 3. Ethernet connection.

Slides:

Advertisements

Similar presentations

BGAN M2M SERVICE + HUGHES 9502 BGAN TERMINAL First BGAN Terminal for Fixed Site Deployment Eric Talman – Technical Manager Whenever Communications, LLC.

Advertisements

8 April Doors Network Configuration Parameters (Single Site Mode)

Sem 6 – Chap 2 All You Need to Know about Modems.

IST 201 Chapter 5. LAN Technologies Ethernet – most widely used technology in LANS In 1970, developed and implemented by: Digital Intel Xerox IEEE

Spring EE 316 Computer Engineering Junior Lab Serial Ports.

CCNA 1 v3.1 Module 5 Review.

1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.1 Module 1 WANs and Routers.

IT Systems In and Out EN230-1 Justin Champion C208 –

McGraw-Hill©The McGraw-Hill Companies, Inc., 2000 Chapter 20 File Transfer Protocol (FTP)

Hardware & Software Needed For LAN and WAN

System Components Hardware overview for Apollo ACS.

CISCO ROUTER BY Mark Sullivan Nancy Tung Xiao Yan Wu.

Serial Communications Standards (Partly Excerpted from Simpl Primer) Cabling Configuration Protocol.

RS232 Serial and Parallel Interfaces

POS Review & spec change.

1 By Nigel Zeinert IED Communications Over LAN/WAN.

CCNA 1 Module1. Objectives Internet Connections Physical – NIC card to connect to local net Logical – Use a standard set of protocols (TCP/IP) Applications.

P.1 Examples of Applications for the tDS-700 Dec.22, 2010.

eAutomation Enabler – Advantech Industrial NETworking

1.5.1 Connecting peripherals. Ports Ports - cont Ps2 – Keyboard and mouse USB(Universal serial bus) – Keyboard, mouse, Printer, Scanner, digital Camera.

What is Router? Router is a device which makes communication between two or more networks present in different geographical locations. Routers are data.

1 © 2004, Cisco Systems, Inc. All rights reserved. Chapter 5 WANs and Routers/ Introduction to Routers.

Identification And Function

Baseboard Aavikkomursu 7.2. Aavikkomursu Micro- controller Extension port for programming microcontroller and sensor input Resistor RS485 interface chip.

Geodetic Research Laboratory Department of Geodesy and Geomatics Engineering University of New Brunswick 22/02/02 Stefan.Duerauer DIPLOMA THESIS Prototype.

Exterior Gateway Protocol Border Gateway Protocol (BGP) Interior Gateway Protocol Routing Information Protocol (RIP) Enhanced Interior Gateway Protocol.

Serial Expansion Hardware

Computer Fundamentals and Troubleshooting 1. Windows Troubleshooting 101 Verify Connections Reboot.

1 Chapter Overview Understanding Expansion Buses Configuring Expansion Cards Cables and Connectors.

CISCO NETWORKING ACADEMY Chabot College ELEC Hyperterminal Access to Routers.

| IPV-MUX-S | IP Gateway. |2|2 | IPV-MUX-S IP Gateway Line Ports | 10/100BaseT Ethernet auto-negotiation | Fiber Optic Module, 100BaseFX |1300nm Multimode.

1 Parani-MSP1000 Firmware Upgrade v1.2.0 Notes Sena Technologies.

Ethernet and Wifi Chapter 7 & 8. Send and Receive Data network adapter or network interface NIC card the most common wired Ethernet network interfaces.

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 1 WANs and Routers.

1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 1 WANs and Routers.

POS Eason 2010/10/27. Current solution SCB-C31: system diagram 1 Receipt printing Receipt printing SCB-C31 Null Modem Y-cable Ethernet FF M M F MainConsole.

Κώστας Γρηγορίου Sales Engineer Ιούνιος 26, 2007 Connect Your Serial Device to Ethernet ADAM – 4570 / 71 / 77 / 79.

1 TRADITIONAL CONFIGURATION (external GSM modem) Requirements: RS232 serial communication port available on the device (built-in or added by installing.

Advancing eAutomation 2-port Ethernet to RS-232/422/485 Data Gateway ADAM-4570 Reported by Alex Hsueh IAG Web & Comm. PM

CCNA 2 Week 1 Routers and WANs. Copyright © 2005 University of Bolton Welcome Back! CCNA 2 deals with routed networks You will learn how to configure.

Cisco Aironet Wireless LAN Products. Cisco Aironet 350 Series Product Family 2.4 GHZ DS 11 Mbps (802.11b) Access Points Client Adapters Wireless Bridges.

Topology, refers to the physical and logical diagrams which summarize network connections and information flow.

FreelineUSA, Inc. Recovery from Corrupted Phone Book FL-USA 800 R

WIRING & HARDWARE SETTING ► Catalog ► Manual ► Installation Guide ► Troubleshooting ► Purchase Order ► IDTECK Home ► e-Training Center Between the PC and.

Computer Basics Common Components

Understand the Components of a Network Mrs. Whaley.

Module 1 CCNA2 v3 Module 1 JEOPARDY CCNA2 v3 Module 1 RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands.

IT Ess I v.4x Chapter 1 Cisco Discovery Semester 1 Chapter 3 JEOPADY Q&A by SMBender, Template by K. Martin.

Suleiman Mohammed(mcpn, mncs)

In a client/server arrangement, network services are located on a dedicated server. The server is a central computer that is continuously available to.

1 Syllabus at a glance – CMCN 6103 Introduction Introduction to Networking Network Fundamentals Number Systems Ethernet IP Addressing Subnetting ARP DNS.

24 Feb 2009ITCN 1 Introduction to Computer Networking M Clements.

1 Pertemuan 2 Routers. Discussion Topics Introduction to WANs Router physical characteristics Router external connections Management port connections.

Cisco Networking Academy Program Semester 4 Module 2 Async Communication.

4000 Imaje 4020 – Software Imaje 4020 – Content ■ Content of Chapter Software: 1. Flash Up 2. Netcenter 3. FTP 4. Active X 5. XCL commands 6. Exercise.

Serial Server Configuration Peter Szyszko. Hardware Configuration  Unit has to be connected to network and powered.  Computer has to be connected to.

WIFI Gateway Offering Wifi connectivity to Serial device

© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicITE I Chapter 6 1 Cisco Routers.

Serial / Ethernet Converter - IE-CS-2TX-XRS232/485

Setting up a Printer. ♦ Overview Linux servers can be used in many different roles on a LAN. File and print servers are the most common roles played by.

Intelligent building system EIB IP-Gateway

Semester 1 Cisco Discovery JEOPADY Chapter 3.

Serial Communications

COMPUTERS IN THE LEARNING ENVIRONMENT

CCNA 2 v3 JEOPARDY Module 1 CCNA2 v3 Module 1 K. Martin.

CCNA 2 v3.1 Module 1 WANs and Routers

Tiers vs. Layers.

Network Hardware and Protocols

Routers and Routing Basics Review

Cisco Routers Presented By Dr. Waleed Alseat Mutah University.

Presentation transcript:

4000 Imaje 4020 – Connectivity

4000 Imaje 4020 – Content Content of Chapter Connectivity: 1. Interfaces 2. Serial connections 3. Ethernet connection 4. Exercise- Connections; Ethernet and Serial

Interfaces ■ 1x Serial RS232, COM1, RJ-45, up to 115Kbps. ■ 1x Serial RS232, COM2, DB9, up to 115Kbps. ■ 1x Ethernet, LAN, RJ-45, 10/100Mbps.

Serial connection- Print mode ■ Serial Interface RS232 – DB9 or RJ45 With the Serial RS232 ports, possible to set: Print Mode (Normal mode): In this mode the control unit can receive external variables. XCL, ActiveX or scanners etc can be used. LAN 23 Telnet 21 FTP 9100 RAW Operating system 4020 Com2Com1

Serial connection- Passive server mode ■ Passive Server Mode (has to be chosen on the control unit). This mode is used in combination with the Ethernet port and the function is to communicate through the printer with external devices connected to the com ports. The external serial devices can in this way be reachable on the network even though they don’t have network support by their own. The configured com port will be given a TCP port number which is used to connect to the serial device. It requires a software on a server that can connect to different TCP ports. LAN 23 Telnet 21 FTP 9100 RAW Operating system 4020 Com Com1 2001

Serial connection ■ Serial Interface RS232– DB9 or RJ45 Cable between COM-port on PC, Scanner or weight to Controllers COM1 or COM2 Cable length of maximum 5m is recommended. See Book for Service Engineers for pin configuration. PC RS232

Ethernet ■ Ethernet interface- LAN, RJ45 With the Ethernet LAN port, possible to: Administration via NetCenter Make backup of files, jobs Send XCL commands

Ethernet ■ Ethernet interface- LAN, RJ45 Cable between LAN-port on PC and Printer LAN port Unlimited cable length* Standard UTP/STP cables. PC Ethernet * 90 Meter, Hub/Switch must be connected if longer

Ethernet ■ Ethernet interface- LAN, RJ45 In a LAN can several printers be connected to one PC.

Exercise ■ Hands on practice Exercise: Connectivity; Ethernet and Serial