First condition of equilibrium: Fnet = 0

Slides:



Advertisements
Similar presentations
Torque and Rotation.
Advertisements

Torque and Rotation Physics.
Physics 111: Mechanics Lecture 12
Statics Worksheet Solutions
1. A motorcycle plus rider has a mass of 1000 kg. They travel inside a loop with a radius of 6 m. At the lowest point, the speed is 20 m/s. What force.
Q12. Static Equilibrium.
Static Equilibrium KEY
6-2 Using Newton’s Laws. Mass and Weight Objects at different weights will still fall at the same rate Weight force The force of gravity acting upon an.
Torque and Equilibrium
Torque and Rotation Physics.
1 UCT PHY1025F: Mechanics Physics 1025F Mechanics Dr. Steve Peterson EQUILIBRIUM.
Physics Montwood High School R. Casao
Chapter 9 – Rotational Dynamics
1. How is torque calculated?. Torque = Force X length of torque arm T = F x l.
Torque and Equilibrium
Force applied at a distance causing a rotating effect
Rotational Dynamics and Static Equlibrium Teacher: Luiz Izola
Causing Rotational Motion In order to make an object start rotating about an axis, a force is required However, not only the amount of force applied but.
Torque.
Agenda 1.Warm Up 2.Check HW 3.Notes: Torque 4.C#11 Warm Up A vertical spring with a spring constant of 5Nm, has a 1 kg mass hanging from it. It undergoes.
Reading Quiz 1. Viscous friction is
Physics 106: Mechanics Lecture 07
Rotational Dynamics and Static Equilibrium
Physics 106: Mechanics Lecture 08
Equilibrium of Particles Free-body Diagram Equilibrium of Rigid Bodies
Statics. Static Equilibrium  There are three conditions for static equilibrium. 1.The object is at rest 2.There is no net force 3.There is no net torque.
T082 Q1. A uniform horizontal beam of length 6
Project Balance a meter stick.
Static Conditions of Equilibrium: Static Equilibrium:
First condition of equilibrium: Fnet = 0
Chapter 9 Torque.
Rotational Equilibrium and Rotational Dynamics
AP Physics B I.E Circular Motion and Rotation. I.E.1 Uniform Circular Motion.
Torque and Rotation Physics. Torque Force is the action that creates changes in linear motion. For rotational motion, the same force can cause very different.
Torque and Equilibrium Practice
PARALLEL FORCES Forces that act in the same or opposite directions at different points on an object.
Chapter 8 Statics Statics. Equilibrium An object either at rest or moving with a constant velocity is said to be in equilibrium An object either at rest.
What forces act upon the meter stick? Where should the force of gravity be considered to act? Center of Gravity – the single point on a body where the.
Formative Assessment. 1. A 130. gram uniform meter stick has a 22.0 g clamp on the 23.0 cm mark, where would you clamp a 35.0 g clamp to make the meter.
Center of Mass Torque. Center of Mass When analyzing the motion of an extended object, we treat the entire object as if its mass were contained in a single.
Chapter 8: Equilibrium and Mechanical Advantage
Home work Thesis 1. Hair tension and it’s applications 2. Frictions and their applications 3. Frictional reduction 4. The moon movements 5. Water moving.
Torque. Center of Gravity The point at which all the weight is considered to be concentrated The point at which an object can be lifted w/o producing.
Chapter 7-8 Pretest.
Chapter 8 Review. 1. How is torque calculated? T = F x l.
Torque and Equilibrium Physics 12. Torque  In the past we have looked at forces that have acted through the centre of mass of an object  These leads.
Torque and Equilibrium
Static Equilibrium AP Physics Chapter 9. Static Equilibrium 8.4 Torque.
Chapter 8 Rotational Equilibrium and Rotational Dynamics
Copyright Sautter The next slide is a quick promo for my books after which the presentation will begin Thanks for your patience! Walt S.
Ying Yi PhD Chapter 9 Rotational Dynamics 1 PHYS HCC.
Wednesday, Nov. 13, 2002PHYS , Fall 2002 Dr. Jaehoon Yu 1 PHYS 1443 – Section 003 Lecture #17 Wednesday, Nov. 13, 2002 Dr. Jaehoon Yu 1.Conditions.
Torque & Equilibrium AP Physics.
TORQUE The turning effect of a force. Torque Which way will the door turn? Rachel Julia.
Torque.
Statics Worksheet 1 Answers
Poll You push a bobsled on ice. There is a kinetic frictional force on the bobsled by the ice. The kinetic frictional force on the bobsled while you are.
Torque at 90o This has NOTHING to do with torque but it comes up when you google images…go figure.
Weight Fg = mg Fg=weight m=mass g=acceleration due to gravity Ex: Calculate the weight of a 12 kg toy cart. What is the difference between weight and.
Torque and Equilibrium
Torque.
PHYS 1443 – Section 003 Lecture #17
Rigid Body in Equilibrium
A beam of mass mb = 10.0 kg, is suspended from the ceiling by a single rope. It has a mass of m2 = 40.0 kg attached at one end and an unknown mass m1 attached.
Solution... Click for answers.
Physics 101: Lecture 14 Torque and Equilibrium
Chapter 9 Torque.
Rotational Statics i.e. “Torque”
Rigid Body in Equilibrium
Presentation transcript:

Equilibrium: the state of no acceleration– balanced forces and balanced torques First condition of equilibrium: Fnet = 0 Second condition of equilibrium: τnet = 0 Static Equilibrium: Forces and Torques balance and the object is at rest Center of Mass (cm)– the point around which gravitational torques balance– it is where the Fw can be considered to be “located” at C For a uniform object, the cm is at the center: Fw

Solving Statics Problems 1) Forces are balanced horizontally and vertically 2) Torques are balanced as counterclockwise (+) and clockwise (-) around an arbitrarily placed pivot point F3 F1 CC PP C F2 C

CC F3 CC F1 F2 PP C F3 F1 C PP C CC F2

A uniform meterstick with a weight of. 150 N is balanced at the 75 A uniform meterstick with a weight of .150 N is balanced at the 75.0 cm mark by a mass hung at 90.0 cm mark. How much is the mass that is producing equilibrium? How much does the stand push up? Ø Fs PP .750 m C .500 m .400 m Fh C Fw CC

Tc = Tcc Fw = .150 N (Fh)(.150 m) = (.150 N)(.250 m) mh = ? Fh = (.150 N)(.250 m) .150 m = .250 N m = Fh g = .250 N 9.80 m/s2 = .0255 kg Fdown = .150 N + .250 N Fup = Fdown = .400 N

A large wooden beam weighs 820 N and is 3. 2 m long A large wooden beam weighs 820 N and is 3.2 m long. The beam’s center of gravity is 1.4 m from one end. Two workers begin carrying the beam away. If they lift the beam at its ends, how much weight must each worker support?

Ø Fu Fu 2 CC PP 1.4 m 1.8 m Fw = 820 N C

Tc = T cc (820 N)(1.4 m) = (Fu2)(3.2 m) Fu2 = (820 N)(1.4 m) 3.2 m = 360 N Fup = Fdown Fu + Fu2 = 820 N Fu = 820 N - 360 N = 460 N

A cat walks along a uniform plank that is 4 A cat walks along a uniform plank that is 4.00 m long and has a mass of 7.00 kg. The plank is supported by two sawhorses, one 0.500 m from the left end of the board and the other 1.50 m from its right end. When the cat reaches the right end, the plank just begins to tip. What is the mass of the cat?

1) A 10.0 N meterstick is suspended from two spring scales, one at the 8.00 cm mark and the other at the 90.0 cm mark. If a weight of 5.00 N is hung at the 20.0 cm mark and a weight of 17.0 N is hung at the 55.0 cm mark, what will each scale read? 2) An 850 N painter stands 1.20 m from one end of a 3.00 m scaffold plank supported at each end by a stepladder. The scaffold plank weighs 250 N and there is a 50.0 N paint bucket .50 m from the other end of the plank. How much upward force is exerted by each of the two ladders?

3) A 650. 0 N boy and a 490. 0 N girl sit on a 150 3) A 650.0 N boy and a 490.0 N girl sit on a 150.0 N porch swing that is 1.70m and supported at each end by chains. What will be the tension in each chain if the boy sits .750 m from one end and the girl sits .500 m from the other end? 4) A uniform 2.50 N meterstick is hung from the ceiling by a single rope. A 500.0 g mass is hung at the 25.0 cm mark and a 650.0 g mass at the 70.0 cm mark. What is the tension in the rope and at what mark is the rope located on the meterstick?

200.0 N 100.0 N 100.0 N 60.0˚ 45.0˚ 3.00 m 2.00 m 1.00 m What force must be added to the right end to produce translational and rotational equilibrium? 150.0 N