Insert White, Black and Yellow Wires into Switch Terminals as Shown Rotate Switch to Bend Wires. The Wires Should be Bent as Close to the Terminal End as Possible. 115/120V switch

Insert White, Black and Yellow Wires into Switch Terminals as Shown Rotate Switch to Bend Wires. The Wires Should be Bent as Close to the Terminal End as Possible. Position the yellow wire loop as close to the black wire as possible. Route the white wire loop so that it crosses over the yellow wire as shown 230V switch

Insert Blue wire into back terminal on backside of switch

Insert Brush Holders as Shown.

Insert Left Side Brush Connect Brush Wire, to Back Terminal, on Front Side of the Switch 120V MOD 230V MOD

Insert Right Side Brush. Connect Wire into Front Terminal, on Back Side of the Switch 120V MOD 230V MOD

Brush Wires Routed in Field Case 120V MOD230V MOD

Route Brush Leads through wire traps in Fieldcase as shown

Place Drill SA into Handle and Fasten Together with Screw. Ensure NO Brush Wires are Damaged or Pinched by Screw. Ensure Brush Wires are Tucked Down Below Parting Line Rib

Connect Capacitor Leads to C1 and C2 on Back of Switch FOR 115V and 230V UNITS ONLY After Connecting the Capacitor to the Switch, place them in Handle and orient Capacitor as shown.

Connect Capacitor Leads to C1 and C2 of Switch FOR UNITS WITH CAPACITORS USING N & N After Connecting the Capacitor to the Switch, place them in Handle and orient Capacitor as shown.

Attach Cordset to Handle with Cord Clamp Ensure Cord Jacket is a MINIMUM of 3mm from Cord Clamp

Cordset Assembly (Marquardt): Insert Power Cord wires as shown; Blue or White wire into the push-in terminal L1 and Brown or Black wire into the push-in terminal L2. For Grounded Units, connect Ground wire to Gearcase. Use This Wire Trap on Side of Switch. Ensure Both Wires are Over Boss MOD with Cap Route All Wires through Wire Traps as Shown

Cordset Assembly (Capax): Insert Power Cord wires as shown; White wire to the right of the Quick Disconnect Lever (1) and Black wire in the push-in terminal to the left of the Quick Disconnect. For Grounded Units, connect Ground wire to Gearcase. Use This Wire Trap on Side of Switch. Run the Ground wire past the trigger as shown. Route all wires through wire traps as shown Ensure Both Wires are Over Boss 230V MOD