New Features 5.7 Workshop Supplement

Inventory Number: Version: 2 ANSYS Release: 5.7 Published Date: September 15, 2000 Registered Trademarks: ANSYS ® is a registered trademark of SAS IP Inc. All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers. Disclaimer Notice: This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non- disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.” Copyright © 2000 SAS IP, Inc. Proprietary data. Unauthorized use, distribution, or duplication is prohibited. All Rights Reserved. New Features Workshop Supplement

Training Manual Aug New Features 5.7 Table of Contents - Workshops 1.Report Generator –Structural Analysis Plate w/Hole at Center 2.Faster Graphics and Results Viewer –Model with over 1.5 million DOFs 3.Functional BCs –Piece-wise Linear Convective BCs 4.AMG solver performance –Spherical shell 5.Plate under transverse load –Probabilistic Design 6.Thermal Contact –Axisymmetric Heat Exchanger 7.Bolt Pretension –Compressed Gasket 8.Built-Up Beams –Modal Analysis 9.ANSYS/LS-DYNA 5.7 –New Features Demonstration 10.Mesh Interpolation –FLOTRAN Analysis 11.Halfwave Dipole Antenna –High Frequency Analysis