HARDWARE – HALO RDDK 5 th Feb 2015

Introducing HALO

Contents Halo – Rapid Deployment Demonstration Kit Easy to Transport : HALO RDD Kit is easy to transport – comes packed in a pelicase for easy transport Dimensions (L x W x D): 632mm x 602mm x 333mm Full Function: HALO RDD Kit is ready for demonstration straight out of the box. No extra equipment required. Minimum Set up: HALO RDD Kit is designed to be set up from box to full function Tx/Rx pair in under 5 minutes. Minimal tools required for set up.

Contents HALO - Rapid Deployment Demonstration Kit POE Switch x 1 HALO x 2 Water Weight x 2 Tripod x 2 Quick Release Bracket x 2 Ethernet Cable x 2 Control Box x 1

Halo Rapid Deployment Kit Set Up Extend the tripod legs Slide the pole into the base of the tripod and secure Fill the water weight with water Attach the water weight using the Velcro strips to the tripod at the point marked in the figure Water Weight

Halo Rapid Deployment Kit Set Up Slide the Quickshift Donut onto the pole (with the lever open), Slide the Quickshift Donut into the desired position. If necessary, adjust the tension between the Quickshift Donut and the Pole using the 5mm Allen Key supplied. Once in place, close the lever to lock the Quickshift Donut in the desired position.

Halo Rapid Deployment Kit Set Up Attach the quick release mechanism of the bracket to the VESA Plate attached to the rear of the Halo as shown. VESA Plate Quick Release Mechanism

Halo Rapid Deployment Kit Set Up Control boxes are provided with the kit pre – connected to the Halo via the access panel cover. Attach the Control box to the pole via the screw provided.

Halo Rapid Deployment Kit Set Up Charger Port 12V in Speaker I 12V Power / OFF II Battery Power I 12V Power / OFF II Battery Power

Halo Rapid Deployment Kit Control Box Set Up Power the units using either 12V in (using the Power Supply provided) or via battery by switching the SW1 to the II position. Once both units are powered, set up can be achieved by connecting an Ethernet cable to the control box RJ45 Connector. Sound control is available; the sound can be turned on or off via the sound control switch on the side of the control box. RJ45 Connector Sound Control