EE 1270: Introduction to Electric Circuits Lecture 6: Advanced Nodal Analysis Chapter 4 Techniques of Circuit Analysis: Sections 4.3,4.4
Dependent Sources ____ Controlled Voltage Source Current Source ____ Controlled Current Source
Node Voltage Method: Dependent Sources Find unknown voltages by summing the currents leaving each node Example 4.3 Step1: Label Nodes Step2: Define Node Voltages
Node Voltage Method: Independent Sources Step3: Write Current Leaving Each Branch Passive Sign Convention Substitute iϕ with Step4: Solve Simultaneous Equations in Standard Form Find the unknown voltage or curent
AP4.3a: Find power associated with each source Simultaneous Equations: Passive Sign Convention Solution p50V= p5A= p3 i1=
Super Node
Supernode Circuit with voltage source between two nodes Combine nodes to form a supernode
Voltage Source Between Nodes Step1: Label Nodes Step2: Define Node Voltages
Voltage Source Between Nodes Step3: Write Current Leaving Each Branch At Node 2 Passive Sign Convention At Node 3 Now add them together (or isolate i and equate them) to get Eq.1: Step4: Solve Simultaneous Equations in Standard Form Eq.2?
Alternative: Create a Supernode Now we can write Eq.1 directly as …
Example: Transistor Circuit* *=if time permits Note: When a signal level is low, it can be passed through an amplifier to increase its level. An amplifier can be built from BJT transistor. The following schematic represents a part of the amplifier. See page 98-99 for equations
AP4.5 (create super node): Find v Passive Sign Convention Simultaneous Equations: Solution v=
Passive Sign Convention AP4.4: Find vo Passive Sign Convention Simultaneous Equations: Solution vo=
Passive Sign Convention AP4.6: Find v1 Passive Sign Convention Simultaneous Equations: Solution v1=