Introduction bin/Dev_DocDB/DisplayMeeting?conferenceid=54http://juno.ihep.ac.cn/cgi- bin/Dev_DocDB/DisplayMeeting?conferenceid=54.

Slides:

Advertisements

Similar presentations

Simulating Radioactive Decays in Next Generation Geoneutrino Detectors Megan Geen Wheaton College Advisor: Nikolai Tolich August 17, 2011.

Advertisements

MICE Collaboration MTG IIT – Feb 2002 The Fiber Tracker Option for MICE Spectrometers The D0 Central Fiber Tracker – Experience and Implications for MICE.

SoLID EC Design for IHEP 2012/10. Basic Features of Preliminary Design Based on COMPASS Shashlyk module design. 0.5mm lead/0.12mm air gap/1.5mm scintillator/0.12mm.

Activity for the Gerda-specific part Description of the Gerda setup including shielding (water tank, Cu tank, liquid Nitrogen), crystals array and kapton.

Prototype of the Daya Bay Neutrino Detector Wang Zhimin IHEP, Daya Bay.

ANGRA Neutrino Detector: Preliminary Design Main Concepts and Ideas (and some alternatives) Ernesto Kemp State University at Campinas – UNICAMP Gleb Wataghin.

02/10/2004 Minimum Bias Trigger Scintillator Counters (MBTS) for early ATLAS running M.Nessi ATLAS week, Freiburg.

LLNL A Sandia and Lawrence Livermore National Laboratories Joint Project Nathaniel Bowden Detection Systems and Analysis Sandia National Laboratories,

Luminosity Monitor Commissioning MICE Collaboration Meeting March 2010 Paul Soler, David Forrest Danielle MacLennan.

Update on Electronics Activities Jim Pilcher University of Chicago 20-Jan-2006.

GlueX Simulations Status Report on CD3 geometry Richard Jones GlueX Collaboration Meeting, Newport News, January 10-12, 2008.

Simulation of the DHCAL Prototype Lei Xia Argonne National Laboratory American Linear Collider Workshop: Ithaca, NY, July , 2003 Fe absorber Glass.

Jun 27, 2005S. Kahn -- Ckov1 Simulation 1 Ckov1 Simulation and Performance Steve Kahn June 27, 2005 MICE Collaboration PID Meeting.

Report on SiPM Tests SiPM as a alternative photo detector to replace PMT. Qauntify basic characteristics Measure Energy, Timing resolution Develop simulation.

Abstract A time resolved radial profile neutron diagnostic is being designed for the National Spherical Torus Experiment (NSTX). The design goal is to.

ISAT Module III: Building Energy Efficiency

Cost of a Large Solid Scintillator Detector Jeff Nelson Fermilab.

1 Coordinate Detector: prototype design The Coordinate Detector (CDET): Three independent vertical planes with 15 cm plastic shield in front, all planes.

Reaction Plane Detector Safety Review Abigail Bickley, for the RxnP Group University of Colorado June 22, 2006 All data sheets can be found at:

A Reconstruction Algorithm for a RICH detector for CLAS12 Ahmed El Alaoui RICH Workchop, Jefferson Lab, newport News, VA November th 2011.

KamLAND Experiment Kamioka Liquid scintillator Anti-Neutrino Detector - Largest low-energy anti-neutrino detector built so far - Located at the site of.

The MINER A Operations Report All Experimenters Meeting Howard Budd, University of Rochester July 8, 2013.

Construct two layers of hadron calorimeter and test Makoto Harada High Energy Physics Laboratory Faculty of Physics Department of Science Shinshu University.

New particle ID detector for Crystal Ball at MAMI-C Daniel Watts, University of Edinburgh John Annand 1, B. Briscoe 3, A. Clarkson 2, Evie Downie 1, D.

Simulation study of RENO-50 Jungsic Park Seoul National University RENO-50 International Workshop June 13-14, 2013 Hoam Faculty House, Korea.

Anatoli Konoplyannikov Design and integration of HV, LED monitoring and calibration system for HCAL Overview of the subsystems design High voltage.

A screening facility for next generation low-background experiments Tom Shutt Laura Cadonati Princeton University.

R&D on W-SciFi Calorimeters for EIC at Brookhaven E.Kistenev, S.Stoll, A.Sukhanov, C.Woody PHENIX Group E.Aschenauer and S.Fazio Spin and EIC Group Physics.

Outline Highlight in background rates estimation (Liangjian and Chao) Impact of fine structures in reactor spectrum (Xin) Requirement in Energy resolution.

Spasimir Balev /CERN/ mrad 3 LKr simulation: – very slow, so only events with interesting topology are fully simulated: –  + with.

Blacksburg - October 14, 2006 LENS - The Lattice Architecture Jeff Blackmon (ORNL) on behalf of LENS Collaboration 8% Indium-loaded liquid scintillator.

Plastic scintillators for the g-RISING experiments Nami Saito.

THE FORWARD PROTON DETECTOR AT DZERO Gilvan Alves Lafex/CBPF 1) MOTIVATION 2) DETECTOR OPTIONS 3) FPD R&D 4) OUTLOOK Lishep 98 Lafex/CBPF Feb 17, 1998.

Daya Bay Muon Subsystem Review, 7/28-29/2007, IHEP, Beijing Muon System PMT Cable Routing Kirk McDonald Princeton University (July 28, 2007)

A detector design for the Daya Bay reactor neutrino experiment Yifang Wang Institute of High Energy Physics, Beijing Jan. 18, 2004.

Report of Muon Veto Task Force L. Littenberg 9 June 06.

Water Tank as the Outer Muon Veto Mingjun Chen

Luminosity Monitor UKNF Meeting 7 June 2010 Paul Soler, David Forrest Danielle MacLennan.

PANDA Anton A. Izotov, Gatchina A.A.Izotov, Gatchina, PANDA Forward TOF Walls. Side TOF walls in dipole Magnet SiPM/PMT187.

NESTOR SIMULATION TOOLS AND METHODS Antonis Leisos Hellenic Open University Vlvnt Workhop.

PID for super Belle (design consideration) K. Inami (Nagoya-u) - Barrel (TOP counter) - Possible configuration - Geometry - Endcap (Aerogel RICH) - Photo.

Deep Underground Large Water Cerenkov Detectors Two types have been proposed. 1) Horizontal cylinders ~60 m diameter by 180 m long – UNO & HyperKamiokande.

Hadron Calorimeter HCAL-J GEp Electron Calorimeter BigCal Hadron Calorimeter 1 G. Franklin, Carnegie Mellon University 10/13/2011.

,,,,, The Daya Bay Reactor Neutrino Experiment Liangjian Wen On behalf of the Daya Bay Collaboration Institute of High Energy Physics Daya Bay Detectors.

Nov Beam Catcher in KOPIO (H. Mikata Kaon mini worksyop1 Beam Catcher in the KOPIO experiment Hideki Morii (Kyoto Univ.) for the KOPIO.

March 19, 2010Kara Keeter1 Ultra-Sensitive Immersion Tank MOTIVATION –WHOLE-BODY COUNTING –TARGET SENSITIVITIES TO – g/g U/Th, etc. –POLLING.

LENS:  LENS Simulations, Analysis, and Results B. Charles Rasco Louisiana State University on behalf of the LENS Collaboration.

Mechanical Designs of The Central Detector Jinyu Fu

PMT Calibration R.Sawada 7/Jan/2007. Time calibration Method was talked at the previous meeting. The problems which was shown before were because I used.

Test results of Multi-gap RPC Test Chambers for a Digital HCAL  Geometrical design  Test setup  Signal: avalanche mode and streamer mode  Comparison.

Coordinate Detector: prototype design General idea about the Coordinate Detector (CDET) so far: Three independent vertical planes with 15 cm plastic shield.

PROPOSAL FOR A MUON VETO SYSTEM BEHIND THE HADRONIC CALORIMETER (MUV-3) Problems and requirements:  Expected total rate for 9.25 < R < 120 cm: 12.1 MHz:

Deep Underground Large Water Cerenkov Detectors Two types have been proposed. 1) Horizontal cylinders ~60 m diameter by 180 m long – UNO & HyperKamiokande.

PMT time offset calibration (not completed) R.Sawada 27/Dec/2007.

Exercises for Q1. Insulated copper tube A thin walled 10 mm copper tube is used to transport a low-temperature refrigerant with a temperature that is.

RICH studies for CLAS12 L. Pappalardo1 Contalbrigo Marco Luciano Pappalardo INFN Ferrara CLAS12 RICH Meeting – JLab 21/6/2011.

1 Work report ( ) Haoqi Lu IHEP Neutrino group

Prototypes photon veto detectors for NA62 experiment CERN M. Raggi - INFN/Frascati for the NA62 Photon Veto Working Group LNF, RM1, NA, PI, SOFIA First.

Methane Update and Run Plan Ben Jones. Configuration 8 inch PMT with TPB plate - 8” from alpha source - Now includes magnetic shield - 2 inch PMT without.

The photomultiplier tubes selection for KM2A electromagnetic particle detectors (EDs) hou chao IHEP The 2nd workshop of air shower detection at high altitudes.

KM2A MD prototypes xiao gang introduction simulation Prototypes conclusion.

Jim Brennan for the WATCHMAN Collaboration Detector Engineering Design Simulation courtesy G. Jocher/J Learned, U Hawaii This work was performed under.

Plans for this week MWPC: wire stretching today

Simulation for DayaBay Detectors

Tao Hu, Jianbei Liu, Haijun Yang, Boxiang Yu For the CEPC-Calo Group

Geant4 Simulation :MCP PET

Stainless Steel Water Well Casing.

Deng Ziyan Jan 10-12, 2006 BESIII Collaboration Meeting

ACD transparency - gaps between tiles - holes in tile to attach them

BESIII TOF Digitization

Presentation transcript:

Introduction bin/Dev_DocDB/DisplayMeeting?conferenceid=54http://juno.ihep.ac.cn/cgi- bin/Dev_DocDB/DisplayMeeting?conferenceid= days of workshop, focusing on software side – How to install/run/analyze current simulation? I will try to summarize the various topics discussed in this workshop

Liangjian’s talk

Better than 2.5 MeV is the requirement

One can consider P.E. counting for distance PMT and late light etc.

Two electronics scheme: – IHEP: global trigger  read everything after trigger – German: triggerless  only read things once passing certain threshold  lower threshold? Loss information?

6 Acrylic Option From inside to outside: liquid scintillator, acrylic sphere,water, strut and stainless steel truss. Number of stainless steel struts: 480. Strut outer Radius : 51mm Strut thickness: 12 mm. 560 PMTs removed because of stainless steel struts. Number of PMTs: Coverage ~75.27%. 400mm Stainless Steel Strut Stainless Steel Acrylic thickness: 12cm Ziyan Deng

7 Balloon Option From inside to outside: liquid scintillator, balloon, acrylic board,LAB, strut and stainless steel tank. The material of balloon is nylon, ETFE, or FEP, or some other materials In the simulation we assume that strut is same as acrylic option, but material is acrylic. Number of PMTs: Coverage ~75.27%. If acrylic struts are thin enough to be placed in the gap between PMTs, coverage is 77.8% Acrylic board Balloon Thickness of balloon: 200um, acrylic board: 1cm Acrylic strut Ziyan Deng

8 TotalPE distribution with/without explosion proof Acrylic OptionBalloon Option Acrylic option: refractive index of acrylic and water different. Balloon option: refractive index of acrylic and LAB similar. With/without explosion proof, PMT placement is the same. Ziyan Deng

Comments of Resolution study Still need to include the electronics simulation into the chain Noise has not been totally added for the resolution study Some dedicated toy simulation has been worked out to attack some particular problem

Anatael and Stefano

Changgeng

Marco

Simulation Support For each sub-system, what simulation supports do you need? – How much effort can each sub-system working group put in? We can hold a dedicated meeting to teach running simulation – A list of major questions needs to be addressed for the Feb workshop as well as the following proposal submission We can try to cover as much as we could Current man-power (Xin, Chao, Jiajie) – Calibration tube for Pelletron – Water Pool Simulation – … – More people are welcome!