CCNA4 v3 Module 5 v3 CCNA 4 Module 5 JEOPARDY K. Martin

CCNA4 v3 Module 5 RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands RouterModesWANEncapsulationWANServicesRouterBasicsRouterCommands Acronyms Flow Control DLCI Operation Operation Config. Commands ► ► ► F i n a l J e o p a r d y ◄ ◄ ◄

CCNA4 v3 Module 5 Question EIR Acronyms 100 A: What is Excess Information Rate? CCNA4 v3 Module 5

Question A: What is Data Link Channel Identifier? DLCI CCNA4 v3 Module 5 Acronyms

CCNA4 v3 Module 5 Question A: What is Committed Information Rate? CIR CCNA4 v3 Module 5 Acronyms 300

CCNA4 v3 Module 5 Question A: What is Discard Eligibility? DE CCNA4 v3 Module 5 Acronyms 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Link Management Interface? LMI Acronyms 500

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the CIR? The dedicated bandwidth guaranteed to a virtual circuit. Flow Control

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the Committed Time (T C )? The time interval over which rates are calculated. Flow Control 200

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the EIR? The amount of possible bandwidth over the CIR. Flow Control 300

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the Committed Burst (B C )? The number of committed bits during the committed time. Flow Control 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the Excess Burst (B e )? The extra number of bits allowed on the VC. Flow Control 500

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is 10 bits? The number of bits in a DLCI address. DLCI 100

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What are VCs? DLCIs are used to identify these. DLCI 200

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is a Frame relay map? An association between dlci numbers and ip addresses. DLCI 300

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is ? The range of DLCI addresses. DLCI 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is the DLCI only applies to the connection between the local router and the local frame relay switch? This is meant when it is said that a DLCI is locally significant. DLCI 500

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Hub and Spoke? Another name for a Frame Relay star topology. Operation 100

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is an Inverse ARP message? In order to map a network layer address to a VC, a router sends one of these on each VC. Operation 200

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Discards the frame without notifying the sender? Frame Relay does this with an erroneous frame. Operation 300

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Split Horizon? This technique is used in frame relay networks to prevent routing loops. Operation 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is ISDN? Frame Relay was originally part of this other WAN technology. Operation 500

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Cisco and IETF? The two types of frame relay encapsulation. Configuration 100

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What are Cisco, Ansi, q933a? The three lmi types. Configuration 200

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What are multiple sub-interfaces? In order for one physical interface to have multiple VCs, these must be configured. Configuration 300

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Point-to-point? This configuration is used when the subinterfaces of a physical interface are each in a different subnet. Configuration 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is Multipoint? This configuration is used when the subinterfaces of a physical interface are all in the same subnet. Configuration 500

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is show interfaces serial? Use this command to verify that the correct frame relay encapsulation type has been set. Commands 100

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is show frame-relay pvc? Use this command to view the status of all PVCs. Commands 200

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is show frame-relay lmi? Use this command to view the number of lmi status messages that have been sent and received. Commands 300

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is frame-relay interface-dlci ? Assign a dlci number with this command. Commands 400

CCNA4 v3 Module 5 Question CCNA4 v3 Module 5 A: What is frame-relay lmi-type ansi? Use this command set the lmi type of a pvc to ansi. Commands 500

CCNA4 v3 Module 5 Question A: What is there is a problem between the remote router and remote frame relay switch? The condition of the frame relay connection when PVC Status = Inactive is displayed. Final Jeopardy CCNA4 v3 Module