Dimensional Analysis  Method of converting one unit to another  Conversion factor— ratio relationship between 2 units  Write units, BE SURE THEY CANCEL.

Slides:



Advertisements
Similar presentations
Using Ratio Reasoning to Convert Measurements
Advertisements

Dimensional Analysis Factor Labeling.
Using the Conversion Factor
PO D × basic advance d ÷ Convert Between Measurement Systems Type of MeasureCustomary  Metric Length 1 inch (in.) ≈ 2.54 centimeters.
2.6 Ratios, Rates, and Conversions
Ratios & Rates. What is a ratio? A ratio is the comparison between two quantities Have we studied anything that would be considered a ratio? Fractions.
Converting from English to Metric Units Use conversion factors that are exact by definition 1 inch = 2.54 cm 1 ounce = g 1 quart = 0.946L or 946.
Imagine This! You’re driving along a highway in Mexico when you notice this sign What should your speed be in miles per hour?
Dimensional Analysis.
Quick Quiz Greg’s car gets 20 miles per gallon. If Greg wants to go on a vacation to San Antonio which is 250 miles away, how much will it cost.
Practice Using the Factor-label Method
Lesson 1.06 Unit Conversion.
Conversion Factors.
5 Minute Check Simplify
Dimensional Analysis DHS Chemistry ferrer.
5-3 Dimensional Analysis Warm Up Problem of the Day
HW # 58 - Ready to Go On p. 242 # 1-20 all Warm up Week 17, Day One Find each unit rate. 1. jump rope 192 times in 6 minutes 2. four pounds of bananas.
5-4 Dimensional Analysis Warm Up Warm Up California Standards California Standards Lesson Presentation Lesson PresentationPreview.
7-3 Analyze Units Warm Up Problem of the Day Lesson Presentation
Dimensional Analysis Also called factor label method.
Dimensional Analysis 1 foot = 12 inches1 mile = 5280 ft 1000 mL = 1 L4 quarts = 1 gal Dimension Analysis makes use of equivalent statements. What are some.
Dimensional Analysis Mrs. Stoops Chemistry. What is it? Process for changing the units without altering the amount. If you have 4 quarters, you also have.
Conversion Factor Method of Analysis. Conversion Factor Method a.k.a. Dimensional Analysis.
Course Dimensional Analysis Warm Up Find each unit rate. 1. Jump rope 192 times in 6 minutes 2. Four pounds of bananas for $ anchor bolts.
Chapter 8 Factor – Label Method Part in. = ___ ft.
Dimensional Analysis or Unit Analysis
Welcome to AP Chemistry !. Scientific Measurements SI Units Significant Figures.
Dimensional Analysis Objective: To convert between units of area.
1.Write down the number as a fraction. 16 in x= 1.
1 Dimensional Analysis DHS Chemistry. 2 Note: From this point on, unless told otherwise, it is expected that all answers will be reported using the sig.
Lab 1 B Objectives 1.Calibrate a thermometer 2.Dimension analysis 3.Generate a graph on excel.
How can we convert units?.  Every measurement needs to have a value (number) and a unit (label).  Without units, we have no way of knowing what the.
BELL RINGER: DISCUSS WITH A PARTNER THE SITUATION GIVEN.
Unit Multipliers and Unit Conversion LESSON 50 PAGE 352.
Dimensional Analysis.
Measurements I can use the SI units of measurement I can convert using conversion factors.
Fill in the Missing Numbers 1 foot = _____ inches 1 meter = _____ centimeters 1 pound = _______ ounces 1 minute = ______ seconds 1 hour = ________ minutes.
Unit Conversions use fractions/ratios to change the units of measurement We “cross-cancel” units Units are common factors on top and bottom Use Formula.
5.7 CONVERTING UNITS LO: CONVERT BETWEEN METRIC AND IMPERIAL UNITS OF MEASURE.
Unit Conversions. A physical quantity must include: Number + Unit.
 A technique for solving problems of conversions.
2.1 Rates, Ratios, and Proportions EQ: How can I use units to understand problems and guide the solution of proportions?
Using Ratio Reasoning to Convert Measurement Units
Dimensional Analysis.
Using Ratio Reasoning to Convert Measurement Units
Dimensional Analysis Math technique used for conversion problems.
Warm Up Problem of the Day Lesson Presentation Lesson Quizzes.
Remember to set up each conversion the same way.
Dimensional Analysis Calculations with More than 2 Steps
Add to table of Contents:
4.7 Ratios, Proportions, & Converting Units of Measure
Dimensional Analysis.
Imagine This! You’re driving along a highway in Mexico when you notice this sign What should your speed be in miles per hour?
Imagine This! You’re driving along a highway in Mexico when you notice this sign What should your speed be in miles per hour?
Unit 1 - MEASUREMENT III. Unit Conversions
Conversion Factors Dimensional Analysis Lots of Practice
Chapter 4: Problem Solving
Warm Up Problem of the Day Lesson Presentation Lesson Quizzes.
Question: You can run at a rate of 6 miles per hour. How many inches per minute is this?
Proportions and Measurements
Dimensional Amalysis.
Day 61 – Unit Conversions.
Aim: How to use Dimensional Analysis to Convert from One unit to Another DO Now: Answer the following questions in your notebook in the following format.
Single-Factor Dimensional Analysis
Converting one unit to another
Clear off desk and get out something to write with
Converting Units with Dimensional Analysis
Direct Conversions Dr. Shildneck.
Dimensional Analysis and Scientific Notation
Exploration 1.4 Dimensional Analysis.
Presentation transcript:

Dimensional Analysis

 Method of converting one unit to another  Conversion factor— ratio relationship between 2 units  Write units, BE SURE THEY CANCEL ! ! !  “Where are we starting? Where are we trying to go?”

 KNOW  2.54 cm = 1 inch

Example 1: 12 inches to miles

Example 2: 3000 min to days

Example 3: 4000 miles to inches

Practice ! 1) Seconds since Declaration of Independence 2) 55 years to seconds

Homework—remember Element Quiz!!  1) 5 weeks to minutes  2) 600 ml to quarts  3) seconds to days  4) 95 miles to meters  5) 7000 eggs to dozens  6) How many seconds have you been alive on this Earth?  ** Ponder: How fast would you need to run to outrun a cheetah? A grizzly bear?