Miniature Engineering Systems Group Two-Stage Cryocooler Development for Liquid Hydrogen Systems.

Slides:



Advertisements
Similar presentations
Technical Committees – the Brains of ASHRAE Section 1.0 — Fundamentals and General.
Advertisements

Overview of Heat Activated Heat Pump Development Using the E/C Cycle Richard B. Peterson, Tom Herron, Hailei Wang, and Kevin Drost Department of Mechanical.
The Use of Small Coolers for Hydrogen and Helium Liquefaction
Active Coolers for cooling Infrared Detector on satellite payloads
MINIATURE ENGINEERING SYSTEMS GROUP: MINIATURE ENGINEERING SYSTEMS GROUP: COST ANALYSIS OF PRE-CHILLING AND HEAT LEAKAGE DURING OPERATION FOR LH2 VJ STORAGE.
HEAT EXCHANGER DESIGN FOR SMALL TO LARGE SCALE LOX-LH2 CRYOGENIC PROPELLANT STORAGE TANKS Justin McCabe Mentor: Dr. Ed Canavan AETD/Code Cryogenics.
ESS Cryogenic System Design
Lecture 4 Ideal cycles III Polytropic efficiencies Exercise
MICE collaboration meeting RAL 28 October 2004 Absorber R & D Plan by Wing Lau – Oxford University.
Current status Arkadiy Klebaner November 21, 2012
DISTRIBUTED CRYOGENIC COOLING WITH MINIATURIZED FLUID CIRCUITS Steffen Grohmann, ETT/TT RD39 Collaboration ST Workshop 2003 CERN, April 01-03, 2003.
ESS Cryogenic System Process Design Philipp Arnold Section Leader Cryogenics CEC – ICMC 2015 June 29, 2015.
Cryogentic Refrigeration(Freezing) Andrew Willenborg.
William Notardonato 1, Adam Swanger 1, Wesley Johnson 2, and Thomas Tomsik 2 1 -NASA Kennedy Space Center 2- NASA Glenn Research Center Ground Operations.
CASIPP Design of Cryogenic Distribution System for CFETR CS model coil Division of Cryogenic Engineering and Technical Institute of Plasma Physics Chinese.
Large-capacity Helium refrigeration : from state-of-the-art towards FCC reference solutions Francois Millet – March 2015.
MINIATURE ENGINEERING SYSTEMS GROUP ( Reverse Turbo Brayton Cycle CryoCooler Development for Liquid Hydrogen Systems.
Cryogenic cavern in Asian site Conceptual design of the cryogenic system Layout of the cryogenic plant for site A & B New layout of the cryogenic system.
Avi Friedman Master’s Student Mechanical Engineering Room: 1337 ERB Hometown: Owings Mills, MD Thesis: Design and Development.
MINIATURE ENGINEERING SYSTEMS GROUP. FUNDAMENTAL TECHNICAL ISSUES Zero boil-off of cryogenic propellants such as lh 2 in space Cryocooler simultaneously.
SNGE-13 Rotary compressor for conditioners Serikov New Generation Engineering serikov-nge.at.ua.
Adaptation of refrigeration compressors for Joule-Thomson cryocoolers fed with gas mixtures Agnieszka Piotrowska, Maciej Chorowski, Pawel Dorosz Wroclaw.
MINIATURE ENGINEERING SYSTEMS GROUP
Conceptual Design Study - Cryogenic Requirements How to decide the layout of ILC cryogenic system Conceptual design of cryogenic system Layout of cryogenic.
SCU Layout Concept - Minimal Segmentation Joel Fuerst (ANL) SCU 3-Lab Review Meeting Dec. 16, 2014.
MINIATURE JOULE-THOMSON CRYOCOOLERS FOR PROPELLENT MANAGEMENT TASK I: Thermodynamic Cycle Analysis and System Optimization Presented by  K.V.Krishna Murty.
Doctoral Degree Defense Defender: Lei Zhou Advisor: Dr. Louis C. Chow Dr. Jay Kapat Committee members: Dr. Louis C. Chow; Dr. Jay Kapat; Dr. Q. Chen;
IHEP 1.3 GHz Cryomodule and Cryogenics IHEP Cryogenic group 2nd Workshop of the IHEP 1.3 GHz SRF R&D Project Dec 2 nd, 2009.
Hall B Cryogenics CLAS and CLAS12 David Kashy Hall B Lead Engineer May 26, 2010.
Centrifugal Compressor LEI ZHOU MMAE UCF. Spec. of top cycle compressor Pr=2.42 Working fluid: Neon Mass flow rate: 0.51 kg/s Inlet pressure: 2 atm Inlet.
Cryo AIP Muon Campus AIP Review Arkadiy Klebaner January 23, 2012.
Hydrogen system R&D. R&D programme – general points Hydrogen absorber system incorporates 2 novel aspects Hydrogen storage using a hydride bed Hydrogen.
REVERSE TURBO BRAYTON CYCLE CRYOCOOLER DEVELOPMENT FOR LIQUID HYDROGEN SYSTEMS ( (Department.
October, 2009 Cryogenics System Roberto Than October, 2009 Internal Review.
BCWC Water-cooled water chillers with centrifugal compressor/s
Distributed 2-stage RTBC LH 2 Pipeline Cryocooler System Design LEI ZHOU MMAE UCF.
MINIATURE ENGINEERING SYSTEMS GROUP ( Two-Stage CryoCooler Development for Liquid Hydrogen Systems.
January 4, 2007 Project Overview RHIC II Project Internal Cost Review Roberto Than Cryogenics Systems January 4, 2007.
MINIATURE JOULE-THOMSON CRYOCOOLERS FOR PROPELLENT MANAGEMENT
Two-Stage Cryocooler Development for Liquid Hydrogen Systems A project supported by NASA Hydrogen Research at Florida Universities.
Cryogenics Introduction, Overview and Applications Prof. Anand Bhatt APME, IT, NU.
New compressor station Second stage of nitrogen system (N2 refrigerator, cryogenic tank, pipe lines) Cryogenic equipment required to run NICA Third stage.
S. Claudet - 31st May 2007Power refrigeration for LHC Power refrigeration at 4.5K & 1.8K for the LHC S. Claudet, CERN AT-ACR.
Project X RD&D Plan Cryogenics Arkadiy Klebaner AAC Meeting February 3, 2009.
1 Status of PT Cryocooler for Final Calorimeter KEK, ICEPP Tom HARUYAMA / Satoshi MIHARA MEG Pre-Meeting 1. Heat load and PT cryoooler 2.
Orbital Aggregation & Space Infrastructure Systems (OASIS) Background Develop robust and cost effective concepts in support of future space commercialization.
17-18 December 2013 LARP VTF Workshop BNL Proposal 1 A.Marone
PXIE Cryogenics Concept Arkadiy Klebaner Session 5 / WG1 (CW Linac and PXIE) October 26 th, 2011.
RECIPROCATING COMPRESSORS
Project X Workshop - Cryogenics1 Project X CRYOGENICS Arkadiy Klebaner.
CSNS cryogenic system Institute of High Energy Physics Guoping Wang June 21, 2016.
Brayton cycle with intercooling and reheating HARIKISHNAN PILLAI ENGG THERMODYNAMICS.
Cryogenic Engineering Lab. 팀 3 김경중, 박창기 Current researches in Cryogenic Engineering Laboratory.
Michael A. Green and Heng Pan
HEAT TRANSFER WITH EXTENDED SURFACES (FINS)
N. Hasan1, P. Knudsen2 and V. Ganni2
Propellant Depot Bernard Kutter United Launch Alliance
Solar Energy Lab Description and validation of the Little correlation for boiling zeotropic mixtures in horizontal tubes from cryogenic to room temperature.
Compound VCRS.
ILC Cryogenic Systems Draft EDR Plan
Section 1.0 — Fundamentals and General
Objectives Cooling Cycles Cooling system components Refrigerants
Technical Summary - ANL
Announcement Rapid and Early Energy Modeling for the Engineers for a Sustainable World Shah Smith and Associates Scott Sevigny Wesley Stidham March 8th,
ESR 2 Presented to Joint Hall A/C Summer Meeting
SNS Cryoplant Commissioning Past Experiences
ESR2 Process Cycle Design
07/22/2019 Dhananjay Ravikumar
Conceptual design of the Cryogenic System of Comprehensive Research Facility for Key Fusion Reactor Core Systems Liangbing Hu Sep.4.
ESR2 Process Cycle Design
Presentation transcript:

Miniature Engineering Systems Group Two-Stage Cryocooler Development for Liquid Hydrogen Systems

Technical Objective To develop efficient, compact, reliable, affordable cryocoolers for distributed cooling for liquid hydrogen systems. NASA Advisors: George Haddad and Bill Notardonato (KSC), Tom Tomsik (GRC) Applications: Refrigerated cryogenic transfer line - line chilldown, zero boil- off, in-line propellant densification Distributed cooling for zero boil-off in transfer/transport vessels Cryogenic storage and liquefaction of propellants in future Mars missions

Recuperator DC Power Supply Motor/ 2 stage intercooled compressor Intercooler Q rej Motor/ 2 stage intercooled compressor Recuperator Turboalternator Q rej JT expander Load Interface DC Reg- ulator/ Power Suppl y External HX Two Stage Cryocooler Neon RTBC and Helium JT

Prior Activities on Efficient, Compact Cryocoolers Phase 0 (completed in June 2002) Developed system concepts for efficient, compact cryocoolers to explore how technology developed for portable refrigeration system can be applied. Developed innovative designs for key, enabling components such as compressor, motor/generator, heat exchanger. Performed preliminary testing for an efficient, compact motor.

Phase I: Task 1. System evaluation and design Task 2. Centrifugal compressor: design, fabrication and testing Task 3. Motor/Generator: design, fabrication and testing Task 4. Friction and wear mitigation Statement of Work