SRAM Design for SPEED GROUP 2 Billy Chantree Daniel Sosa Justin Ferrante

The Bitcell

The Bitcell (cont.) 6-Transistor Design M 1 and M 5 are 3 micron wide, 600 nm long M 2 and M 6 are 1.5 micron wide, 600 nm long M 3 and M 4 are 1.5 micron wide, 750 nm long Cell Ratio = (W1/L1) / (W5/L5) Pull Up Ratio = (W4/L4) / (W6/L6) Yields CR = 2.5, PR = 1.2 Well within constraints of CR > 1.2, PR < 1.8 Needed to ensure read stability while retaining ability to write to the cell By not choosing values such that CR and PR are at their limits, the bitcell becomes more robust with respect to variation.

The Voltage Sense Amp

The Sense Amp (cont.) Design Specs –9-Transistor S/A –Cross-coupled Inverters –One per Block Column (i.e., mult. reads) –~2ns Total Propagation Time Why? –Simplicity (over multi-stage S/As) –Size (area, power savings)

Tri-State Write Driver

Tri-State Write Driver (cont.) Design Specs –36-Transistor WD (w/buffering) –Write Control / Driver Sections –~2ns Total Propagation Time Why? –Simplicity –Efficiency

The Decoders

Row Decoder Composed of 2 to 4 NOR Predecoders and 3input NAND gates Fanout Reducing Buffers Enable Embedded Buffers

Column Decoder NMOS Pass Transistor Based

The Control Logic PRECH GENERATOR WRITE DRIVER CONTROL

The Control Logic (cont.) Design Specs –Used to control signals (e.g., WD_C) –Used to generate signals (e.g., prech) Why? –Necessary for signal synchronization –Do NOT impede READ/WRITE cycle time (i.e., control signals are processed alongside existing delays)

Sense Amp Enable Logic - Consists of an AND gate, buffers, and the Prech and Read signals. - In a read operation, the precharge signal will go low in order to precharge the bitlines, then returns high. - The read signal goes high before precharge in order to accelerate overall clock speed. Before it reaches the AND gate in this logic, it is buffered several times to delay the firing of the sense amplifier. - This allows a differential voltage between the bitlines to form before the sense amp fires, thereby providing correct operation.

With Your Powers Combined…

Metric Table Delivery ItemValueUnits Metric710 x 10^6Watts*ns^2*um^2 Bitcell Area14.6 x 10^6um^2 Total Area15.6 x 10^6um^2 Read Power1.23Watts Write Power1.42Watts Total Power1.26Watts Read Delay6.0ns Write Delay4.5ns Total Delay6.0ns

Ideas for Improvement Registers to latch output of SRAM Shortening read cycles and clock period –Depends on setup time and hold time of the registers, reducing precharge lengths Replace voltage sense amps with current sense amps

Any Questions?