EBC dial indicators The next slides are the graphic representation of the dial indicator measurements The values shown are the values as read from the indicators. On the indicator 0 – 100 corresponds to 2.56 mm As there are to many people working next to the indicators some of the measures could be false. The values with the red arrow indicate a known impact on the indicator The next comments are only brief remarks from looking at the graphics behaviors

Right Vertical Indicators All indicators with the same behavior. The Vertical displacement is increasing Bigger vertical displacements on the outer part of the saddle

Left Vertical Indicators To much variation is the measures. Probably part of the measures is altered. The last measures are stable and indicate an increase of vertical displacement

Middle Vertical Indicators Very different behaviors on finger and ITC sides. These indicators were to close to the drilling machine, witch can probably explain the big differences

Horizontal Indicators All indicators present the same behavior – almost no movement