Programming Software and Setting

Default IP Add ： , also can be changed via Programming Software, if forget IP address, Programmer can press the IP button and recover to Default one(IP LED light on and power off) SB-DN-1IP Programming Module Data interchange for S-BUS and TCP/IP Reset without Power off Intelligent Data Transfer Remote programming Network capacity : 254 S-BUS devices

Before Programming, Make sure that Programming module and PC are at the same IP range Ethernet Setting IP Add: Router IP: ☺ PC IP Setting Make sure Make sure that Programming module and PC are at the same IP, Example: Same and the last one not exceed 255 IP setting Communication setting Cross-ruling

* Another way to test and double check IP setting, Programmer can do as following steps: “Star”  “Run” ， input “cmd”and confirm, then input “ping X.X ” （ IP add of programming Module ）, to see the communication is ok or not. Picture 1Picture 2 Communication setting

Smart-bus Programming module is used to program all on-line devices 2.1 Software introduce

You can not find it in the device list, you can find by Step1: S-BUS software  Devices  Bus switchboard click to enter BUS switchboard Programming

Step2: select a device to view status and edit We can see the switchboard’s version, and all devices which linked to current switch. Programming

Step3: View/Edit network parameter Programming The default port : 6000 Make sure the device’s IP and PC’s are in the same network segment

Programming Step4: View/Edit configuration Switchboard ID(Device ID): separate different switchboard Subnet ID: set current S-BUS network ID. Switchboard ID( Device ID) is used for differentiate differ switches. 1port switch offers a subnet ID for all S-BUS devices which linked to its s-bus current port.

Software Smart-bus Programming software main page Menu Toolbar

1 、 Click this Button to search device Device search

1 、 Select 255 to search all on-line device 2 、 Click Search Device search

1 、 Device searched 2 、 Add all searched product list Device search

1 、 on-line device List 2 、 double click to enter setting page of that device Device search

2.2 Device IP manage Select Add manage Note: if the IP add of new added device or changed device can not meet the Project application, it maybe cause IP conflict or can not communication, so we must modify subnet ID and Device ID according the MAC address. Add Manage

2 、 Right click or double click for modify device MAC address 3 、 Set subnet ID and Device ID according the MAC address, then Save. Programmer can delete the former device in list. 2.2 Device IP manage

1 、 press this button 3second to active the IP add modification function(LED on in red from twinkle) 2 、 Select ”Modify address ”to set IP address Add Manage

3 、 Click ”indicate initial address”, add of device that LED on in red will be read 4 、 input new add, then click “Modify initial address ”, it will be saved and the LED will be twinkled Add Manage