Magnetic field measurement of new "QM7R" (TOKIN 3581) 12/16/2008 Mika Masuzawa.

Slides:



Advertisements
Similar presentations
Q1 for JLAB’s 12 Gev/c Super High Momentum Spectrometer S.R. Lassiter, P.B. Brindza, M. J. Fowler, S.R. Milward, P. Penfold, R. Locke Q1 SHMS HMS Q2 Q3.
Advertisements

D2 conceptual design and field quality optimization Ramesh Gupta, BNL Slide No. 1 Nov. 13, 2013 D2 Conceptual Design and Field Quality.
Field measurements of QEA magnets at KEK Mika Masuzawa May 30, 2006.
HL-LHC Corrector Magnet 3D design status Giovanni Volpini on behalf of the LASA team CERN, February 25, 2014.
Magnets for the ESRF upgrade phase II
Magnetic Field Design of a Superconducting Magnet for the FFAG Accelerator T.Obana, T.Ogitsu A,T.Nakamoto A,K.Sasaki A A.Yamamoto A, M.Yoshimoto A, Y.Mori.
Solenoid Magnetic Field Measurement. MICE solenoid includes 5 coils First solenoid expected at FNAL for magnetic field measurements in April Measurements.
Magnet rotated by 5.9 degree Distance from entrance point to magnet right bottom corner m.
BROOKHAVEN SCIENCE ASSOCIATES Abstract Magnetic Specifications and Tolerances Weiming Guo, NSLS-II Project In this presentation I briefly introduced the.
1 / 19 M. Gateau CERN – Geneva – CH 14th International Magnetic Measurement Workshop September 2005, Geneva, Switzerland.
LCWS14 Benoit CURE - CERN/PH Dept.1 International Workshop on Future Linear Colliders October 2014 Organized by the Vinca Institute of Nuclear.
14 August Magnetic Field in the ATLAS Muon Spectrometer Masahiro Morii for the ATLAS Group Harvard University Laboratory for Particle Physics and.
ATF2 Magnets ATF2 Magnets KEK, 19 Dec 2006Cherrill Spencer, SLAC ATF2 Mag Design & Production 1 Design and Production Status of New ATF2 Magnets Cherrill.
Options for Final Focusing Quadrupoles Michele Modena CERN TE-MSC Many thanks for the contributions of: J. Garcia Perez, H. Gerwig, C. Lopez, C. Petrone,
115 December 2011 Holger Witte Brookhaven National Laboratory Advanced Accelerator Group Elliptical Dipole.
1 Flux concentrator for SuperKEKB Kamitani Takuya IWLC October.20.
L. Fiscarelli, S. Izquierdo Bermudez, O. Dunkel, S. Russenschuck, G. Willering, J. Feuvrier 22 nd September 2015.
SIMPLE CHARACTERIZATION METHOD OF SMALL HIGH GRADIENT PERMANENT MAGNET QUADRUPOLES Concetta Ronsivalle,Luigi Picardi, Monia Vadrucci (ENEA C.R. Frascati,
Calculation of the beam dynamics of RIKEN AVF Cyclotron E.E. Perepelkin JINR, Dubna 4 March 2008.
Analysis of MBXW and MBW Per Hagen (TE/MSC) Acknowledgements: R. Wolf (2008 analysis), G. de Rijk (ROXIE model), B. Auchmann (ROXIE support),
Simulation of direct space charge in Booster by using MAD program Y.Alexahin, A.Drozhdin, N.Kazarinov.
Magnet Measurement for the Hall A Compton Dipole Ken Baggett
1 J.DiMarco 16Nov2010 LQS01b Magnetic Measurements Results ( preliminary ) J. DiMarco 16Nov2010.
ATF2 Magnets ATF2 Magnets 27/28 Feb 2007Cherrill Spencer, SLAC. Info for QC3 machining discussion 1 Information for discussion about how to enlarge the.
Magnet Design & Construction for EMMA
EMMA injection & extraction Takeichiro Yokoi(Oxford University)
Orbit Correctors in D2 and Q4 Update J. Rysti and E. Todesco 1 4/11/2014.
Design of DC septum magnets based on measurements and 3D calculation of an R&D septum magnet for Rapid Cycle Synchrotron of J-PARC Masao Watanabe, Accelerator.
ATF2 Magnets etc. 1. Magnets 2. Power supplies 3. Magnetic field measurement 4. Movers and supports R. Sugahara May 30, 2005.
Muon Cooling Channel Superconducting Magnet Systems Muon Collider Task Force Meeting on July 31, 2006 V.S. Kashikhin.
Consolidation of the Booster Injection Quadrupole Magnets (part 2) A. Aloev 14 th February 2013.
November 19, 2008 SLAC Linear Collider Department Slide 1 ILC Superconducting Quadrupole Characterization J. C. Sheppard, Cherrill Spencer, et al. SLAC.
Cherrill Spencer, SLAC. MDI Workshop Jan '05 1 Impact of Crossing Angle Value on Magnets near the IP Overview of several unusual quadrupole designs that.
Magnet Measurement Plan APS MBA M1 R&D Magnet Joe DiMarco, et al. 26 November 2013.
Phobos Magnet Status Leslie Rosenberg & Patrick Decowski, MIT Technical Advisory Committee November 1998.
Physics Requirements Sensitivity to Manufacturing Imperfections Strategy  where to map field  measure deviation from ideal model  fit to error tables.
CERN –GSI/CEA MM preparation meeting, Magnetic Measurements WP.
HL-LHC Meeting, November 2013D2 Status and Plans – G. Sabbi 1 D2 Conceptual Design Status and Next Steps G. Sabbi, X. Wang High Luminosity LHC Annual Meeting.
ICFA mini-Workshop on Beam Commissioning for High Intensity Accelerators Yasuhiro Watanabe (J-PARC / JAEA) Tracking between bending and quadrupole families.
DDBA magnets Chris Bailey Low emittance rings Sept Frascati.
BARC First Prototype PXIE Magnets Measurements at Fermilab 9/16/2014Michael Tartaglia, TD/T&I Dept.
Li-Lens length options for pion yield (OptiM tracking) V.Nagaslaev.
Spin Tracking at the ILC Positron Source with PPS-Sim POSIPOL’11 V.Kovalenko POSIPOL’11 V. Kovalenko 1, G. Moortgat-Pick 1, S. Riemann 2, A. Ushakov 1.
April 17, Dejan TrbojevicFFAG07 -Non-Scaling FFAG gantries1 Non-Scaling FFAG Gantries Introduction: Motives: The most challenging problem in the carbon/proton.
Yingshun Zhu Design of Small Aperture Quadrupole Magnet for HEPS-TF
Magnetic measurements on MBHSP104
A new QF1 magnet for ATF3 Alexey Vorozhtsov
Cherrill Spencer, SLAC Member of ATF2 Magnet Team
Yingshun Zhu Accelerator Center, Magnet Group
TPS pulse magnet measurement
High Gradient Magnet Design for SPring-8 Upgrade Plan
Procurement, Measurement and Installation of 2 Octupoles for ATF
Alexander Kalimov, State Polytechnic University, St.-Petersburg
Cherrill Spencer, SLAC Member of ATF2 Magnet Team
CLAS12 Torus Magnetic Field Mapping
Preliminary Magnetic Analysis of the CCT Magnet for HL-LHC
Cherrill Spencer, SLAC Member of ATF2 Magnet Team
Status of ATF2 FD Magnets and Info on their FFTB supports & mover
Main magnets for PERLE Test Facility
Conceptual Design of CEPC Interaction Region Superconducting Magnets
Yingshun Zhu Accelerator Center, Magnet Group
Compact and Low Consumption Magnet Design The DESY Experience
Large aperture Q4 M. Segreti, J.M. Rifflet
HRS at small angles for e+/ e- pair for APEX
Design of Nb3Sn IR quadrupoles with apertures larger than 120 mm
November 14, 2008 The meeting on RIKEN AVF Cyclotron Upgrade Progress report on activity plan Sergey Vorozhtsov.
November 7, 2008 The meeting on RIKEN AVF Cyclotron Upgrade Progress report on activity plan Sergey Vorozhtsov.
Summary & Concluding remarks
Design of Nb3Sn IR quadrupoles with apertures larger than 120 mm
KIGAM Proton Microprobe System
Presentation transcript:

Magnetic field measurement of new "QM7R" (TOKIN 3581) 12/16/2008 Mika Masuzawa

Motivation for measuring TOKIN3581 Aperture issue of current QM7R (TOKIN3393) Beam extraction at x=22.5 mm nominally while its bore radius is 16 mm. B (field gradient and other multipole) components change drastically around the extraction position, which is not nice for delivering a stable beam. Replacement of this magnet with a magnet with larger bore is recommended (needed) if we can find one. Do we have one? TOKIN3581 is available Larger bore (r=21 mm) but the size is similar Can provide strong enough filed with a 200A power supply Field quality?? ⇒ Measurement needed.

Measurements Tokin 3581 magnet r=21 mm Length = 60 mm expected operating current = 146 A (1)Harmonic coil measurement B’L (integrated field gradient) at various currents to obtain an excitation curve (B’L [T] vs I [A]). (2)Mapping with Lakeshore Model channel Gaussmeter every 1-2 mm in X (median plane, where y=0) -42mm < x < 42 mm every 5-10 mm in Z (beam-direction) some data along z for y = +/- 2mm at x=20 mm, 22.5 mm and 25 mm To obtain the effective length, Leff [m] and to obtain 2-dim (3-dim) data for Philip & his team to evaluate multiples etc. at x~22.5 mm Note: Standardization pattern 0A ⇒ 195A ⇒ 0 ⇒ 195A ⇒ 0 ⇒ 195A ⇒ 0A ⇒ target current (146A for example)

Y X Tokin 3581 magnet L=60 mm R=21 mm 3-axis mover with linear gauge Harmonic coil system, currently being used to measure Iwashita-san’s permQ. Two systems (3-axis hall probe on 3-axis mover & Harmonic coil ) were used to evaluate Tokin 3581 magnet. 3-axis hall probe Measurement Systems

Harmonic coil measurement (2) A few percent saturation at I=146[A] (1) B’L = [T] at I = 146 [A]

Mapping results (effective length) I found the data taken by Tokin? Leff = 「 m 」 Good agreement Though no notation about which current their data were taken. Leff is a function of current (saturation).

Mapping results, evaluation at x=off center Philip’s talk

Comparison between TOKIN 3581(QM14R)&TOKIN 3393(QM7R) ParameterTOKIN 3581(QM14R) “new” QM7R TOKIN 3393(QM7R) Currently in the beamline Bore diameter [mm]4232 Core Length [mm] Magnet length [mm] Magnet width [mm] # of turns/pole2617 (Max) Current[A]245(design) (195 max for ATF2) 139 Voltage [V]9.6/magnet3.4/magnet Effective length [mm] B’L 146A ⇒ satisfies the requirement Not measured “New” one will fit in the space.