Use this interactive PowerPoint presentation to evaluate these aspects of Titration 1Accuracy in TitrationsAccuracy in Titrations 2Titration MethodTitration.

Slides:



Advertisements
Similar presentations
Measurements in Chemistry
Advertisements

Howden School and Technology College 7E Acids and Alkalis Curing indigestion.
TITRATION Hydrochloric acid 0.1 mol/dm 3 Sodium hydroxide solution – concentration ? To determine the concentration of a solution of sodium hydroxide by.
Key Words: Titration Accurate Titre Burette Pipette Neutralisation
Standardising potassium permanganate solution with iron(II) sulfate
 a pH value tells us how much H + is in a solution. It can be defined by: pH = - log[H + ] (log is to base 10). (Also note, square brackets are used to.
Chapter 3 – Volumetric Analysis Week 1, Lesson 1.
I’m so confident - I could explain this to someone else! I can get to the right answer but I don’t understand well enough to explain it yet. I understand.
Acid-Base Stoichiometry
Concentration equations
Measuring Volume of Liquids Most common apparatus - measuring cylinder comes in different sizes, e.g 10 ml, 25 ml, 50 ml,
Volumetric Analysis Chapter 3.
Acids and Bases - Titration
Titrimetric procedure and Acid and Base Titrations Ch 20
Quality control checking of Vitamin C concentration in fruit juice
Volumetric Analysis Apparatus. The Volumetric Flask.
Standardisation of potassium permanganate solution Ex 5
I’m so confident - I could explain this to someone else! I can get to the right answer but I don’t understand well enough to explain it yet. I understand.
Performing a titration A bluffers guide! Preparing a standard solution 4 Accurately weigh a weighing bottle, recording the mass 4 Add approximately x.
Experimental errors.
Acid Base Titrations Physical Science Keith Warne.
Topic 11: Measurement and Data Processing
Planning an experiment & writing an experimental report.
 Uncertainty and Error in Measurement ©2010 Travis Multhaupt, M.S.,
We can use titration to make soluble salt from base and an acid. An acid-alkali titration is used to find out how much acid is needed to react exactly.
Using a Graduated Cylinder Uses: 1.To measure the volume of liquids very accurately 2. To find the volume of solid objects that do not have regular dimensions.
Lab Techniques How to do a Manual Titration. Rinse the inside of the Burette Rinse the burette with 2-3 cm 3 of water then with 2-3 cm 3 the solution.
Volumetric Analysis Topic 8.4 Titration readings in a normal titration you are usually advised to carry out at least one rough and two accurate.
Titration of fats LO: To set up titration; and record all results to find out amount of bromine water needed to saturate a range of oils and fats.
Section 8.4 – pg  Experimental designs discussed so far have been QUALitative (flame test, solution colour, litmus test, conductivity, solubility)
Starter Mini-Whiteboard Quiz. Neutralisation Titration May 7 th, 2010.
After completing this topic you should be able to : State to accurately neutralise an acid using a solution containing an alkali or a carbonate requires.
Learning Objectives: To understand how to write an effective plan for a scientific investigation.
Meters, Liters, and Grams. Oh, My! T. Trimpe 2008
5.3.1 Neutralization reactions Titration Reactions.
Introduction The Equipment The Terms The Process Calculations
+ Titrations Noadswood Science, To know what titrations are and how these are useful Thursday, February 04, 2016 Titrations.
Volumetric analysis. Mole concept map For the reaction A + B  C, where A is the limiting reagent, concentration particles mass volume (gas) MOLE (A)
Titration Analysis.
© SSER Ltd. How Science Works Accuracy, Precision & Sensitivity.
Amal Almuhanna Equivalent weight: The equivalent weight of a compound can be calculated by dividing the molecular weight by the number of positive.
L4: pH scale Learning Objectives: 1.Use the pH scale to describe substances as weak or strong acids or alkalis. 2.Describe how universal indicator is used.
3.4.3 Titrations Starter: Calculate the concentrations of the following solutions a) in g/dm 3 and b) in mol/dm 3. 5g of NaOH dissolved in 1dm 3 of water.
Standardising potassium permanganate solution using oxalic acid.
READING BETWEEN THE LINES Estimate one place on non digital equipment. (rulers, graduated cylinders) 6 7 cm 6.42 cm If it is exactly on the line 6.60 cm.
Making Salts Insoluble salts – precipitation Mix two solutions together one with the cation, one with the anion. Filter, wash and dry. Soluble Na +, K.
Qualitative and Quantitative Practical Success Criteria for Qualitative Practical.
10.3 Acid- Base Stoichiometry: TITRATION. What is a titration? A procedure used to determine the concentration of a solution using a standardized solution.
Determination of the Ka value of a weak acid using the half neutralisation point method David Martin City and Islington College Students Name: …………………………………………………………………..
S2/3 Chemistry Titrations.
2015 Scientific Methods & Laboratory apparatus Grade: 6.
How much acid is there in a solution
Can you remember what an acid and an indicator are?
TITRATION OF A STRONG BASE WITH A STRONG ACID
Acids and Bases.
Equivalence point Titre Indicator Burette Pipette Volumetric flask
Acid-Base Titration Chemists often need to know the concentration of an acidic or basic solution, and to acquire this, they use an experimental procedure.
Acid and Bases. pH.
Volumetric Analysis.
Use of burette Rinse burette with the standard solution to be used.
Titrations.
Titration Ensuring good volumetric technique
Spotting Control Variables.
Put these steps in order
Titration Method Set up and clean all equipment as in the diagram.
Chapter 7 Test Remediation
Required Practical Guide Neutralisation by titration
Volumetric Analysis.
Titration Precautions
Presentation transcript:

Use this interactive PowerPoint presentation to evaluate these aspects of Titration 1Accuracy in TitrationsAccuracy in Titrations 2Titration MethodTitration Method 3Selecting ResultsSelecting Results 4Titration ImprovementsTitration Improvements

Accuracy in Titration I should add acid from the burette 1 cm 3 at a time. I should do as many repeats as possible to make the results more accurate. Accuracy in Titration Accuracy in Titration Titrations are always accurate so my answers will be correct. I should be very careful with my first titration so that the result is accurate. Titrations are very accurate. They could not be any more accurate.

What was saidWas it correct? (Y / N / Partly) Explanation of your answer I should be very careful with my first titration so that the result is accurate. Titrations are always accurate so my answers will be correct. I should add acid from the burette 1 cm 3 at a time. I should do as many repeats as possible to make the results more accurate. Titrations are very accurate. They could not be any more accurate. Accuracy in Titration

Titration Method It doesn’t matter if the acid or alkali goes in the burette. It doesn’t matter which indicator I use, they all change colour at the same time. Titration Method Titration Method I should wash out the flask and make sure it is dry before my next repeat. My eye level is very important when I am taking readings. I think that I should do a titration twice. This will give me an average so will be right.

What was saidWas it correct? (Y / N / Partly) Explanation of your answer My eye level is very important when I am taking readings. I should wash out the flask and make sure it is dry before my next repeat. It doesn’t matter if the acid or alkali goes in the burette. It doesn’t matter which indicator I use, they all change colour at the same time. I think that I should do a titration twice. This will give me an average so will be right. Titration Method

Selecting Results A difference of 1 cm 3 between results is close enough. I should leave the first result out of the average. Selecting Results Selecting Results Taking an average of three results would be best. Two experiments are enough. They will give me an average. I need two accurate results within 0.2 cm 3 of each other.

What was saidWas it correct? (Y / N / Partly) Explanation of your answer Two experiments are enough. They will give me an average. Taking an average of three results would be best. I should leave the first result out of the average. A difference of 1 cm3 between results is close enough. I need two accurate results within 0.2 cm3 of each other. Selecting Results

Titration Improvements It is very difficult to improve the method because the pipette and burette are so accurate. I would use a measuring cylinder next time instead of a pipette. It would be quicker. Titration Improvements Titration Improvements I should make sure that I always use two drops of indicator – not three. I should try to add the acid from the burette one drop at a time from the start. I think that next time we should use more accurate apparatus.

What was saidWas it correct? (Y / N / Partly) Explanation of your answer I should make sure that I always use two drops of indicator – not three. I would use a measuring cylinder next time instead of a pipette. It would be quicker. I should try to add the acid from the burette one drop at a time from the start. It is very difficult to improve the method because the pipette and burette are so accurate. I think that next time we should use more accurate apparatus. Titration Improvements