ATLAS Inner Detector thermal study. The Inner Detector.

Slides:



Advertisements
Similar presentations
IBL Insertable B-Layer
Advertisements

IBL IST G&S Integration Ned Spencer, UCSC July 15, /15/11IBL IST G&S Integration1.
NA62 SILICON PIXELS DETECTOR COOLING VESSEL PROTOTYPE STATUS REPORT COOLING VESSEL PROTOTYPE STATUS REPORT 1Vittore Carassiti - INFN FECERN, 26/10/2009.
Mike Fitton Engineering Analysis Group Design and Computational Fluid Dynamic analysis of the T2K Target Neutrino Beams and Instrumentation 6th September.
Powering of the Stave modules in the GOAT-1 proposal. Vladimir Gromov, Ruud Kluit, Harry van der Graaf. NIKHEF, Amsterdam. EUDET Annual Meeting, Amsterdam,
Analysis of Simple Cases in Heat Transfer P M V Subbarao Professor Mechanical Engineering Department I I T Delhi Gaining Experience !!!
AAE450 Spring 2009 Kelly Leffel 3/26/09 Structures and Thermal Lunar Descent Phase Lander Integration Lander Thermal Control (Day) Kelly Leffel Structures.
Al 2 O 3 Post Combustion Chamber Post Combustion Chamber ANSYS Thermal Model (Embedded Fuel Grain Concept) Outer radius: 1.25” ( m) Inner radius:
The LHCb Inner Tracker LHCb: is a single-arm forward spectrometer dedicated to B-physics acceptance: (250)mrad: The Outer Tracker: covers the large.
IBL and SLHC activities at LPNHE Paris – 2013 Réunion Atlas France - 10 octobre 2012.
1 21/10/2011 GTK Microchannel Cooling coupled simulation Enrico Da Riva, Vinod Rao CERN (EN/CV/DC) 21 st October 2011 E. Da Riva, V. Rao.
Feasibility Analysis h T1 T2 T3 T4 T5 One Dimensional Transient Analysis One Dimensional Finite Difference Steady State Analysis T1 and T5 will be known.
IBL Mock Up IBL Mock Up MANUFACTURING 2011/04/29 François-Xavier NUIRY Maxence CURDY Andrea CATINACCIO CERN PH/DT/PO 1.
PAX DETECTOR THERMAL SIMULATION 1Vittore Carassiti - INFN FEFz-Juelich, 27/10/2008.
M. Gilchriese Update on Pixel Prototype Mechanics/Cooling Structures at LBNL February 1, 2008 M. Cepeda, S. Dardin, M. Garcia-Sciveres, M. Gilchriese and.
Armaflex Solutions For Heating and Plumbing. Heating and Plumbing 2 Insulation main target: Limit heat losses (energy savings) Noise control Condensation.
17/06/2010UK Valencia RAL Petals and Staves Meeting 1 DC-DC for Stave Bus Tapes Roy Wastie Oxford University.
Pixel Support Tube Requirements and Interfaces M.Olcese PST CDR: CERN Oct. 17th 2001.
1 VI Single-wall Beam Pipe tests M.OlceseJ.Thadome (with the help of beam pipe group and Michel Bosteels’ cooling group) TMB July 18th 2002.
M. Gilchriese SLHC Pixel Local Supports Based on Thermally Conducting Carbon Foam E. Anderssen, M. Cepeda, S. Dardin, M. Garcia-Sciveres, M. Gilchriese,
Armaflex Solutions High Temperature and Solar Installations.
Low mass carbon based support structures for the HL-LHC ATLAS pixel forward disks R. Bates* a, C. Buttar a, I. Bonad a, F. McEwan a, L. Cunningham a, S.
One-Dimensional Steady-State Conduction
Thermal & Mechanical Support for Diamond Pixel Modules Justin Albert Univ. of Victoria Nov. 6, 2008 ATLAS Tracker Upgrade Workshop.
Be Beam Pipe Design Knut Skarpaas VIII 6/16/06. My Background on this subject- Came to SLAC 1993 to do the mechanical design of VXD3 and it’s associated.
JCOV, 25 OCT 2001Thermal screens in ATLAS Inner Detector J.Godlewski EP/ATI  ATLAS Inner Detector layout  Specifications for thermal screens  ANSYS.
August 7, 2003K. Chow, LHC Luminosity Detector Thermal Analysis1 Analysis cases Approach: Start simple to get information— with speed with confidence that.
PHENIX Silicon Vertex Tracker. Mechanical Requirements Stability requirement, short and long25 µm Low radiation length
W.O. Miller i T i VG 1 Two Pixel Configurations Under Study First: A Monolithic Integrated Structure First: A Monolithic Integrated Structure –Axial array.
1 VI Single-wall Beam Pipe Option: status and plans M.Olcese TMB June 6th 2002.
Overview WG4 Meeting - 16th October 20121M. Gomez Marzoa, E. Da Riva Maximum ΔT admissible at cooling system T_1 T_2 T_1+0.5*ΔT Stave  If T_2 – T_1 =
14th August E. Da Riva, A.L. Lamure CFD thermal simulations IBL Enrico Da Riva, Anne-Laure Lamure 14th August 2012.
SEPTEMBER 2002 Pixel Support Tube A. Smith LBNL 1 ATLAS Pixel Detector Heater Panel Testing Alexis Smith September 17, 2002.
Alpine pixel layout Integration progress Teddy Todorov For the ATLAS-LAPP group AUW Integration meeting 20/11/2012.
TC Straw man for ATLAS ID for SLHC This layout is a result of the discussions in the GENOA ID upgrade workshop. Aim is to evolve this to include list of.
Spacing of Cu clamp = 10” Clamp plate width = 2.5”, thickness = 0.375” Thickness of conductor insulation = 0.03” Thickness of coil ground wrap = 0.03”
Walter Sondheim 6/9/20081 DOE – Review of VTX upgrade detector for PHENIX Mechanics: Walter Sondheim - LANL.
IBL Mock up Mounting procedure V.2 François-Xavier Nuiry Simon Feigl
K.W. Glitza University of Wuppertal IBL Stave (Lessons for Upgrade)
GRAN SASSO’S HADRON STOP Temperature’s behaviour under specified beam conditions Barbara Calcagno.
FEM/CFD thermo-mechanical analyses on IBL Mock-up A. Sciuccati.
E. Da Riva/M. Gomez Marzoa1 WG4 Meeting - 27th June 2012 Air Cooling by means of carbon fiber structure Enrico DA RIVA (EN-CV-PJ) Manuel GOMEZ MARZOA (EN-CV-PJ)
Pixel upgrade test structure: CO 2 cooling test results and simulations Nick Lumb IPN-Lyon MEC Meeting, 10/02/2010.
Cooling of GEM detector CFD _GEM 2012/03/06 E. Da RivaCFD _GEM1.
Mechanical layout, services and integration R. Santoro On behalf of the ITS upgrade WG4.
Exercises for Q1. Insulated copper tube A thin walled 10 mm copper tube is used to transport a low-temperature refrigerant with a temperature that is.
Aluminum Alloy 6061 – Composition, Properties, Temper and Applications of 6061 Aluminum.
Thermal jumble! (Action list review) C. Marinas IFIC-Valencia DEPFET-Valencia 1 Valencia
MVD COOLING STATUS-PAST AND UPDATES PIXEL COOLING PROJECT: -STUDIES and TEST on MATERIALS (Carbon Foam) -THERMAL FEM ANALYSES and TEST on DISKS and STAVES.
G. GiraudoGSI-Darmstadt MVD updates Thermal properties improvement Thermal properties improvement Cooling circuit test (Torino) Cooling circuit.
Progress and prospects in thermo-mechanical activities at Valencia Carlos Lacasta, Arantza Oyanguren 7th International Workshop on DEPFET Detectors and.
Stave thermal analysis Cooling connections CO2 warm Test
Tutorial 2b: Thermo-physical properties
Micro Vertex Detector of PANDA Status of Strip BARREL and DISC
One-Dimensional Steady-State Conduction
MVD Mechanics update EXTERNAL FRAME: NEW DESIGN
IBL Overview Darren Leung ~ 8/15/2013 ~ UW B305.
Date of download: 10/22/2017 Copyright © ASME. All rights reserved.
Antti Onnela CERN – EP – Detector Technologies group
Modeling a PCM storage unit for solar thermal cooling in Masdar City
WG4 – Progress report R. Santoro and A. Tauro.
New Proposed Foam Developments
Hybrid Mechanical/Thermal Design ideas
The Stave Thermo-Conductivity QC Procedure Idea
Heating of ALFA detectors
دانشگاه شهیدرجایی تهران
تعهدات مشتری در کنوانسیون بیع بین المللی
Tests on a dummy facet of PIX upgrade using CO2 cooling
Thermal behavior of the LHCb PS VFE Board
Presentation transcript:

ATLAS Inner Detector thermal study

The Inner Detector

First section : the inner detector

Back out Case -40 °C 250°C

MaterialDensity (kg/m3) Specific Heat (J/(kg*K)) Thermal conductivity (W/(m*K)) PMMA (plexiglass external tube) U - profiles (except Pixel_B staves) IST Omega Carbon foam Titanium Pipe Silicon layer? Aluminium foil Aerogel Heaters 0.09 g/cm2 (approx 1250 kg/m3) Aluminium pipe

Second section: addition of the other layers

Second section:adding of the other layers First section B-layer

Thank you for your attention !

Geometry Cooling Pipes Staves Beam Pipe Nitrogen

Normal case -40 °C 100 W

Accidental Case No more cooling ?

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.