Dual Sparkle Circuit Green connections are wires – they can be any colour. Make sure all + and - connections match up. Make sure the larger battery terminal.

Slides:

Advertisements

Similar presentations

PSC 151 Laboratory Activity 9 Electric Circuits II Series and Parallel Connections.

Advertisements

The circuit shows working model of two way traffic light system .

Amplifying Signals Breadboarding: from a diagram to an actual working amplifier.

AP Electricity Quiz Review

n-bit comparator using 1-bit comparator

Wiring Color Codes for McLean County 4-H Projects.

Introducing circuits.

Register Digital Multimeter Usage Click Register to begin the course.

1 Hands-on: Heater Circuit Kit includes: 3 9 Volt batteries (for flight only) 1 Perf Board 3Ceramic Resistors (4 5W) 39 V connectors 1 White wire 1.

Dr. Jie ZouPHY Chapter 28 Direct Current Circuits.

S.MORRIS 2006 ELECTRICAL CIRCUITS More free powerpoints at

Lab #5 Overview Activity #1 - Simulation of an Op-Amp inverting amplifier Activity #2 - Build and Test the Op-Amp inverting amplifier Activity #3 - Determining.

Which free body diagram represents the moment when the proton enters the magnetic field region? 1 3 proton B Field out of screen 2 ponearth F  Construct.

1 Applied Control Systems Technology. 2 Pin configuration Applied Control Systems.

Electrical Circuits. A path where electric charges move along (through wires).

Register Digital Multimeter Usage Click Register to begin the course.

3-Way Switch Circuit Notes

Household Wiring “Alternating Current” is used in Households. This means that the current – the flow of electrons - moves one way and then reverses direction.

With a knowledge of how to connect cells in parallel and series, we can figure out how to arrange batteries to deliver a desired voltage, and in some cases,

Short circuiting a battery demo… Dangerous ? High current?

Electrical Symbols SNC 1D.

AUP2G57 configured as flip flop Dual Configurable Logic Design Contest.

Electronics Electricity, Components And Circuits.

The 3 parts of an electronic system are :

Half wave rectification By:Engr.Irshad Raheem Memon.

Warm-up 1.List some things that you already know about magnets. 2.Do you think magnets could cause any type of forces or motion? Why? 3.Based on what you.

TEKS 5.6B Demonstrate that the flow of electricity in circuits requires a complete path through which an electric current can pass and can produce light,

Operational Amplifiers Op Amps – a useful building block K. El-Ayat 11.

Class Discussion Item 2.1 Proper Car Jump Start. Schematic of a Proper Car Jump.

Which free body diagram represents the moment when the proton enters the magnetic field region? 1 3 proton B Field out of screen 2 ponearth F 

What is a circuit? A set of connected electrical components that provide one or more complete paths for the movement of charges. A set of connected electrical.

2c) Energy and Potential Difference in Circuits Part 1 Current and Charge.

Circuits Series or Parallel.

Basic Equipment and Schematic Reading. Objectives Learn the basic equipment that will be used in the Lab. Learn some of the basic symbols used on electrical.

Logo Electronics Electricity, Components And Circuits.

Name ______ 6 __ Jan. __ Lesson 4B – How Batteries Work.

Connecting the cRIO to the 12 V power source and your computer

S3 INNOVATION ELECTRONICS. LESSON TITLE: ELECTRONICS Learning Intention: To understand when to use different types of logic gates Activity: Building own.

3.13 How many output lines will a five-input decoder have?

AND Gate Inputs Output Input A (Switch) Input B (Switch) Output Y (Lamp) 0 (Open) 0 (OFF) A B Lamp.

Electricity Notes 6 - Circuits Electric Circuit – _______________________________________ All electrical circuits have 4 parts: 1.____________________________________________________.

Electric Currents Let’s Review…. An electric current is a flow of electric charges along a wire in a circuit.

Circuits. The Basics The Symbols Wire Resistor Light Bulb Plug Battery Open Switch Closed Switch Capacitor.

1.Mouths are quiet. 2.Begin the quick review section of your notes. 3.Raise your hand if you need something.

Task  You will be shown four different arrangements of light bulbs connected to batteries with conducting wires. The arrangements will vary with their.

ELECTRICAL CIRCUITS. Circuits Circuits are paths which small particles flow through to provide us with electricity for lights, appliances, and other devices.

Figure 3-9: Implementing the Load Diverter CAUTION Do NOT connect the wires to the Diversion Load Controller or the terminal block at this point. IF.

Circuit Basics & Series Circuits Aim: How are circuits designed and connected?

Glencoe Physics Chapter 23 ”Circuits and Circuit Elements"

© NTScience.co.uk 2005KS3 Unit 7j - Circuits 1 Circuits.

Logic Gates Practical Objective: to develop an understanding of logic circuits and truth tables.

Installing an Xbox 360.

The Relay based Multiplexer

Potential Divider Aims What is a potential divider

Lesson 4 Electricity Part 3.

ELECTRICAL CIRCUITS More free powerpoints at

Task You will be shown four different arrangements of light bulbs connected to batteries with conducting wires. The arrangements will vary with their.

Basic Electrical Circuits

Discrete Mathematics CS 2610

Peripheral Devices

Arduino Switch Soldering 2

Electrons in Circuits. Electrons in Circuits Parts of a circuit Battery Closed switch (allows electrons to flow) Open switch (impedes flow) Wire Resistor.

Natural Sciences and Technology Grade 6

Measuring Voltage Drop and Current

Half & Full Subtractor Half Subtractor Full Subtractor.

Half & Full Subtractor Half Subtractor Full Subtractor.

Basic Electrical Circuits

TEKS 5.6B Demonstrate that the flow of electricity in circuits requires a complete path through which an electric current can pass and can produce light,

Chapter 28 Problems 2,6,8,9,15,20,21,36,40.

Presentation transcript:

Dual Sparkle Circuit Green connections are wires – they can be any colour. Make sure all + and - connections match up. Make sure the larger battery terminal is wired to negative (-). Make sure your Sparkles are connected to the ‘D’ output and are wired in the direction shown on the Sparkle itself.

Switch Circuit Green connections are wires – they can be any colour. Make sure all + and - connections match up. Make sure the larger battery terminal is wired to negative (-). The switch output can go to any free input (A,B or C).

Blocks to create circuitsAlternate programs