Skip 6 positions from the high end. Locate Pin #1 Crimp the cable with one end extending 9 1/2” to the left and 4” to the right. Separate the wires in groups of two. Trim the orange and yellow wire pair back to 4”. The same length as the blue- green pair to the right.

Attach Temperature Sensor to the long and short wires as shown. This is a bottom view. Twist and attach the long blue-green wires to the first sensor. Twist and attach the short extended blue- green wires to the second sensor.

LM35 Insert and fill with thermo- epoxy into a ring tongue terminal #8x3/8” Cover wires to add strain relief. Use a ring tongue terminal for an 8 AWG wire and a 3/8” stud. Modified to accept a TO-92 device.