5 th and 8 th Mr. Luper
Keep the cylinders upright at all times In storage On carts Keep cylinders secured Mark cylinders when empty Write EMPTY Write MT
Replace cylinder cap Always when not in use When transporting Be safe when opening valves Open slowly Do not open acetylene more than half a turn ▪ Only ¼ - ½ a turn is necessary
Never hit the cylinders Do not roll cylinders along the ground Never use a cylinder as a ground when welding
Never swap regulators Oxygen belongs to oxygen Acetylene belongs to acetylene NEVER exceed 15 psi on acetylene Too much pressure is dangerous
When installing regulators Never tighten too much Remember acetylene is reverse threads Keep at 45 degree angle Always relieve bleed pressure off when finished with torch Close Valve Bleed the hoses Always back adjusting screw off
When attaching hoses Clean hoses by blowing them out Remove access dust on exterior Prevent sparks and heat Make sure that the hoses and cylinder are out of the path of sparks Never apply straight heat to either
Testing for leaks Use soapy water NEVER us a Flame or Lighter Do NOT attempt to repair leaky hoses Tape of any sort is not proper repair Hoses are best to be replaced
Oxy-Acetylene Goggles Used for cutting only Not to be used for welding Do not use the pressure from the torch to dust off Gases can ignite your clothing Use the proper tools Only use a Spark Light to ignite the torch
Always be in a well vented area Never use where there is no air movement Oil is not to be used for lubrication Reactions can cause conbustion