CS Program File Load Operation1: CS Program File Transfer You must prepare the CS program file on your HDD beforehand. Step 1. Select “Utility” Step 2. Select “File Transfer PC to PBX” Then file select dialogue box appears, select target program file. Step 3. After you decided the program file, this dialogue box appears. Program file transfer takes a few minutes by USB. When transfer finished, “completed” message appears, and program file name is registered automatically into the memory. (See Operation3)

Operation2: CS Port status change to Out of Service Open “Configuration-CSI/F Port” screen and change the status. Step 4. Click status cell of target CS port. Then, Command dialogue box appears. Step 5. Click “OUS” button for change the status. CS Program File Load Notice : Do not change CSI/F card to Out of service !

CS Program File Load Operation3: Program File View and Load (1/4) It shows the file which is available for download. Step 6. Select “Utility” Step 8. This screen gives an information as kind of files that the memory card has. The first character of the program file is “P”. Please select CS program. Step 7. Select “SD Card File View and Load” Then following screen appears.

Step 10. Click the Button. [Detail]: When you load the CS program, click this button. Then program file details is shown. Except for program file, this button is invalid. [Cancel]: Close this screen. Step 9. Select target program file. PDCSDECT: DECT-CS PCSDECT: DECT-CS PCS24G: 2.4G-CS CS Program File Load Operation3: Program File View and Load (2/4) You must select target program file from the memory. Note: File names are displayed as follows; TDA0141CE/TDA0155CE ： PDCSDECT TDA0142CE/TDA0156CE ： PCSDECT Please see the step 11 to distinguish the same name.

CS Program File Load Operation3: Program File View and Load (3/4) It shows program file header information. Step 13. Click the [View] Button. Program file header information of the target port is shown. Step 11. CS Program file header information of the SD memory card. Step 12. Select target port. It shows current available port number. [All]: Load to all available port. Note: How to distinguish different models with the same name The software version of TDA0141CE/TDA0142CE are Ver5.xxx or previous. The software version of TDA0155CE/TDA0156CE are Ver6.xxx or later.

CS Program File Load Operation3: Program File View and Load (4/4) You should compare header information of port and memory. Step 14. Click the [Load] Button. Program file load is started. The load takes a few minutes. When loading finished, “completed” message appears, and target CS port will change In-service status automatically. Step 15. Click the [Cancel] Button. This screen disappears.