Example Steam enters a turbine at 1200 kPa and 350°C and it exits at 100 kPa, 150°C. The water mass flow rate through the turbine is 2 kg/s. Determine.

Slides:

Advertisements

Similar presentations

Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 5th edition by Yunus A. Çengel.

Advertisements

Refrigeration Cycles د/ محمود عبدالوهاب.

Thermodynamics Lecture Series

ME 200 L19: ME 200 L19:Conservation Laws: Cycles HW 7 Due Wednesday before 4 pm HW 8 Posted Start early Kim See’s Office ME Gatewood Wing Room

EGR 334 Thermodynamics Chapter 4: Section 10-12

Chapter 1 Basic Concepts

Chapter 4 Mass and Energy Analysis of Control Volumes (Open Systems)

Chapter 7 Entropy (Continue).

Chapter 1 VAPOR AND COMBINED POWER CYCLES

ENGR 2213 Thermodynamics F. C. Lai School of Aerospace and Mechanical

ENGR 2213 Thermodynamics F. C. Lai School of Aerospace and Mechanical Engineering University of Oklahoma.

Second Law of Thermodynamics

The Second Law of Thermodynamics

Carnot Thermodynamics Professor Lee Carkner Lecture 12.

Second Law Thermodynamics Professor Lee Carkner Lecture 11.

Chapter 6 The Second Law of Thermodynamics Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 5th edition by Yunus.

Thermodynamics Lecture Series Applied Sciences Education.

Lecture 10. Heat Engines and refrigerators (Ch. 4)

Chap. 3 (Sec. 3-5 to End of Chapter) Mass Flow Rate =  A V (kg/s) Volume Flow Rate = A V (m 3 /s) V = velocity.

Vapor and Combined Power Cycles (2)

Exergy: A measure of Work Potential

THE SECOND LAW OF THERMODYNAMICS

ME 200 L31: Review for Examination 3 ME 200 L31: Review for Examination 3 Thu 4/10/14 Examination 3 (L22 – L30) 6:30 – 7:30 PM WTHR 200, CL50 224, PHY.

The second law of thermodynamics: The heat flow statement: Heat flows spontaneously from a substance at a higher temperature to a substance at a lower.

VII. The second low of Thermodynamics

HEAT ENGINE D.A.DEGREE ENGG. & TECHNOLOGY

Cycles Contributions by:

ENGR 2213 Thermodynamics F. C. Lai School of Aerospace and Mechanical Engineering University of Oklahoma.

1 So far… We’ve developed a general energy balance We’ve developed a general material balance We’ve only actually looked at systems that are under steady.

Chapter 10 VAPOR AND COMBINED POWER CYCLES

Entropy of a Pure Substance Entropy is a thermodynamic property, the value of entropy depends on the state of the system. For example: given T & P, entropy,

The Second Law of Thermodynamics Chapter 6. The Second Law  The second law of thermodynamics states that processes occur in a certain direction, not.

ENGR 2213 Thermodynamics F. C. Lai School of Aerospace and Mechanical Engineering University of Oklahoma.

Last Time Where did all these equations come from?

Chapter 6 The Second Law of Thermodynamics Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 8th edition by Yunus.

PTT 201/4 THERMODYNAMICS SEM 1 (2013/2014) 1. Objectives Introduce the second law of thermodynamics. Identify valid processes as those that satisfy both.

Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 8th edition by Yunus A. Çengel.

Chapter 7 ENTROPY Dr. Kagan ERYURUK

ENGR 2213 Thermodynamics F. C. Lai School of Aerospace and Mechanical Engineering University of Oklahoma.

Problems 3 Dr. Kagan ERYURUK.

AH.  Define entropy to quantify the 2nd-law effects.  The increase of entropy principle.  Calculate the entropy changes  Examine isentropic processes.

Second law of thermodynamics. The Second Law of Thermodynamics.

Dr. Owen Clarkin School of Mechanical & Manufacturing Engineering Summary of Energy Topics Chapter 1: Thermodynamics / Energy Introduction Chapter 2: Systems.

Unit 61: Engineering Thermodynamics Lesson 9: Carnot Engine Cycles.

Heat Engines A gasoline engine is a form of a heat engine, e.g. a 4-stroke engine INTAKE stroke: the piston descends from the top to the bottom of the.

Example The internal energy of a closed system can be increased by adding heat or doing work. In the following example, 1 kg of saturated liquid water.

THE SECOND LAW OF THERMODYNAMICS

Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 7th edition by Yunus A. Çengel.

Second Low of Thermodynamics

Chapter: 06 The Second Law.

Power and Refrigeration Systems

LAXMI INSTITUTE OF TECHNOLOGY

An iso certified institute

ES 211: Thermodynamics Tutorial 5 & 6

The Second Law of Thermodynamics: Kelvin–Planck Statement

ES 211:Thermodynamics Tutorial 10

Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 5th edition by Yunus A. Çengel.

Chapter 7 Entropy: A Measure of Disorder

Chapter 2 Energy Transfer by Heat, Work & Mass

Z.E. Z.E. Z.E. IE 211 INTRODUCTION TO ENGINEERING THERMODYNAMICS

Chapter 11 Refrigeration Cycles Study Guide in PowerPoint to accompany Thermodynamics: An Engineering Approach, 5th edition by Yunus A. Çengel.

Chapter 6 The Second Law of Thermodynamics

Chapter 11 The Second Law of Thermodynamics

1st Law of Thermodynamics

Example 1 The internal energy of a closed system can be increased by adding heat or doing work. In the following example, 1 kg of saturated liquid water.

Thermodynamics Lecture Series

2nd Law of Thermodynamics

SECOND LAW OF THERMODYNAMICS

Presentation transcript:

Example Steam enters a turbine at 1200 kPa and 350°C and it exits at 100 kPa, 150°C. The water mass flow rate through the turbine is 2 kg/s. Determine the power produced by the turbine, in kW, and state any assumptions that you made.

Charging and Discharging Processes An insulated, freely moving piston cylinder device contains 10 kg of water, 6 kg of which is in the vapor phase. The mass of the piston is such that it maintains a constant pressure of 200 kPa. Now, steam at 0.5 Mpa and 350oC is allowed to enter the cylinder from a supply line until all the liquid has vaporized. Determine the final temperature in the cylinder and the mass of steam that entered.

Charging and Discharging Processes A 2 m3 rigid tank initially contains air at 100 kPa and 22oC. The tank is connected to a supply line through a valve. Air is flowing in the supply line at 600 kPa and 22oC. The valve is opened, and air is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. A thermometer placed in the tank indicates that the air temperature at the final state is 77oC. Determine the mass of air that entered the tank and the amount of heat transfer.

Second Law (Ch. 6) Concepts Introduction to 2nd Law Thermal Energy Reservoir – Source and Sink Heat Engines – Four Characteristics Kelvin Plank Statement of 2nd Law Refrigerators and Heat Pumps – COP Tons of Refrigeration, EER, SEER Clausius Statement of 2nd Law Perpetual Motion Reversibility

Second Law (Ch. 6) Concepts Reversibility and Examples of Irreversibilities Carnot Cycle – All Reversible Processes Carnot Principles The Quality of Energy Calculations – Heating Value

Example An automobile consumes fuel at a rate of 28 L/hr delivers 60 kW of power to the wheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, what is the efficiency of this engine?

Example A coal burning steam power plant produces a net power of 300 MW with an overall thermal efficiency of 32%. The actual air fuel ratio is 12 kg air/kg fuel and the heating value of the coal is 28,000 kJ/kg. Determine the amount of coal consumed in a 24 hr period and the rate of air flowing through the furnace.

Example A 3.5 ton A/C unit has an EER rating of 15. Determine the power consumed by the unit in KW and the amount of heat rejected to the environment over the course of 1000 hours of operation, in kJ.