Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Upgrade Bumpers on Safety Yokes for FARO Focus 3D

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Components Part #DescriptionQty V01913M Bumpon D7,9x2,24 P0163Cover Safety Yoke2 P0140Safety Yoke Sensor Side1 P0139Safety Yoke Mirror Side1 Needed Tools: Torque Screw Driver TX6 an TX10 Instructions (pages to follow) Part #DescriptionQty XP0140Trimble Safety Yoke Sensor Side1 XP0377TrimbleSafety Yoke Mirror Side1 If using Trimble TX5 scanner, use the following part #’s instead of P0140 & P0139:

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx ESD Precautions Make sure environment is ESD safe and it is recommended that you use an ESD strap during this process. ESD damage incurred while performing the following steps is not covered under warranty.

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Instructions  Remove Cover from upper screw from “Safety Yoke Mirror Side”  Remove Cover from upper screw from “Safety Yoke Sensor Side”

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Instructions  Remove 2x H0015 (M2x8) with TX6 screwdriver on top side as pictured. Screwdriver: T6  Remove 4x H0056 (M3x8) with TX10 screwdriver on bottom side as pictured. Screwdriver: T10  Remove the “Safety Yoke Mirror Side” carefully. Don’t scratch the surface when you remove the Safety Yoke!

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Instructions Note: Gluing areas must be degreased with Isopropanol first.  Mount both Bumpers V0191 on P0140 o Glue the bumpers on the Yoke as shown in picture. Note: gluing areas must be degreased with Isopropanol first.  Mount both Bumpers V0191 on P0139 o Glue the Bumpers on the Yoke as shown in picture.

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Instructions  Mount the “ P Safety Yoke Mirror Side” carefully. Be careful not to scratch the surface when removing cover. 2x H0015 M2x8 with TX6 on top side Screwdriver: T6 Torque: 0.24 Nm 2.83 In-lb 4x H0056 M3x8 with TX10 on bottom side Secure the Screws with Loctite 222 Screwdriver: T10 Torque: 1 Nm 8.85 In-lb

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Instructions  Fix Cover from upper screw from “Safety Yoke Mirror Side”  Fix Cover from upper screw from “Safety Yoke Sensor Side”  If the Cover is loose, replacement covers will need to be ordered - “Cover Safety Yoke” P0163

Revised: December 11, 2015 © 2015 FARO LM-06REF pptx Revision History 11/10/13 – Document created Date revised: 12/11/2015