Innovation Intelligence ® Section 18 Set Creation & Solver Interface

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Sets Creation Various types of sets can be created. Nodes – Nodes are grouped as a set. Shell Elem – Shell elements are grouped as a set. Solid Elem Face – The shell elements from the selected solid elements are grouped as a set. Solid Elem – Selected Solid elements are grouped as a set. RBE – Rigid Bar Elements are grouped as a set.

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Sets Creation Membrane Layer – This option is used to create membrane element sets for Abaqus. These sets can be created from volume mesh bodies. Nastran/Optistruct ASET – This option is used to create Nastran/OptiStruct ASET / ASET1.

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Sets Creation Node / Shell element / Solid element sets can be created from contact pairs. Contact pairs between the selected Master and Slave bodies within the specified tolerance will be found out and sets will be created. Sets can be transferred from source to destination body based on CAD ID (or) Persistent ID.

Innovation Intelligence ® Solver Interface

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Supported Solver Abaqus Nastran OptiStruct Permas ADVENTURECluster Marc Ansys Beasy Patran LsDyna

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Abaqus Support Analysis – Linear Static, Non-Linear, Normal Mode, Explicit, Steady State Heat Transfer. Shell and Solid Elements for Structural and Thermal Analysis. Beam, Membrane, Connector, Mass, Spring Elements. Pressure, Force, Motion, Body Force. Temperature, Flux, Convection. Constraints - *Boundary, Equation Constraint. Contact Definition. Sets. Thread Pretension. Gasket Elements, Gasket Loading and UnLoading curves. Materials, Stress-Strain-Temperature curve. Load Steps

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Nastran Support Analysis – Linear Static, Normal Mode, Thermal. 1D Elements (CBAR,PBAR,PBEAM), 2D Elements, 3D Elements. Rigid Elements (RBE2, RBE3,RBAR), Bush Element, Mass Element, Scalar Element. Pressure, Force, Gravity. Single Point and Multi Point Constraints. Cyclic Symmetry. Sub Cases. Single/Double precision support. Material and Property definitions with comment cards.

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Permas Support Analysis – Linear, Non-Linear, Normal Mode, Steady State. Membrane, Solid, Beam, Shell, Gasket, Spring, Mass Elements. Surface and Node contact definition. Thread Pretension. Pressure, Concentrated Loads, Constraints, MPC. Material and Property definition. Load History definition(NLLOAD).

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Ansys Support Shell, Solid and Beam Elements. MESH200 Element support. Pressure, Force, Body Force, Constraints. Contact Elements (TARGE170, CONTA173, CONTA174) and respective Real Constants. Mass Elements, CERIG, RBE3. Temperature, Flux and Convection. Pretension section. Material and Property.

Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved. Export This dialog allows to export the model to relevant solver for analysis. Solvers can be spawned directly from SimLab and the analysis results are loaded into SimLab. Output requests can be specified. Node and Elements Ids can be written either in ascending or descending order.