Introduction to ANSYS 5.7 Part 1 Workshop Supplement

Inventory Number: First Edition ANSYS Release: 5.7 Published Date: January 30, 2001 Registered Trademarks: ANSYS ® is a registered trademark of SAS IP Inc. All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers. Disclaimer Notice: This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.” Copyright © 2001 SAS IP, Inc. Proprietary data. Unauthorized use, distribution, or duplication is prohibited. All Rights Reserved. Workshop Supplement Introduction to ANSYS Part 1

Workshop Supplement January 30, 2001 Inventory # TOC-3 Table of Contents 1.ANSYS Basics Introductory WorkshopW1-1 2.Stress Analysis A.Lathe CutterW2-1 B.2-D Corner Bracket TutorialW Thermal Analysis Axisymmetric Pipe with FinsW Thermal-Stress Analysis Axisymm. Pipe w/ Fins - SequentialW4-1 Axisymm. Pipe w/ Fins - DirectW Importing Geometry A.IGESW5-3 B.SATW5-7 C.SAT AssemblyW5-11 D.ParasolidW5-17 E.Parasolid AssemblyW Solid Modeling: Top-Down Pillow BlockW6-1 7.Solid Modeling: Importation & Clean-up Connecting Rod - Bottom-UpW7-1 Connecting Rod - Import/Clean-upW Meshing A.Pillow BlockW8-1 B.Connecting RodW8-9 C.Cotter PinW8-18 D.WheelW Select Logic A.SiloW9-1 B.Impeller ExtrusionW APDL Basics 2-D Bracket using ParametersW Loading and Solution A.3-D BracketW11-1 B.Connecting RodW11-9 C.WheelW Postprocessing A.Connecting RodW12-1 B.Spherical ShellW12-23 C.Axisymmetric Fin with Multiple Load Steps W12-39 D.Results ViewerW12-59 E.Report GeneratorW Short Topics A.Batch - Plate with Hole at CenterW13-1 B.*ASK - Plate with Hole at CenterW13-7 B.*ABBR - Plate with Hole at CenterW Mechanical Toolbar Pipe ShellW Appendix A Input Files for Workshop ExercisesA-1 * All workshops were run and verified using the first release of ANSYS 5.7