SBS / A1n DAQ Alexandre Camsonne 02/27/2013. APV25 Standard VME access ok : can configure board Check address assignment in VME64X crate Need to debug.

Slides:

Advertisements

Similar presentations

20/Oct./2000 CF IEEE NSS 2000 at Lyon,France 1 An MWPC Readout Chip for High Rate Environment Introduction ASIC Structure & Fabrication ASIC Evaluation.

Advertisements

Hall A Gmp / DVCS Fall preparation September 16 th 2014 Hall A meeting Alexandre Camsonne 1.

8th February 2011Electronics for Commissioning1 Signal characteristics. Readout & electronics overview. Plan.

Data Acquisition System for 2D X-Ray Detector Beijing Synchrotron Radiation Facility (BSRF) located at Institute of High Energy Physics is the first synchrotron.

DSP online algorithms for the ATLAS TileCal Read Out Drivers Cristobal Cuenca Almenar IFIC (University of Valencia-CSIC)

DAQ WS03 Sept 2006Jean-Sébastien GraulichSlide 1 DDAQ Trigger o Reminder: DAQ Trigger vs Particle Trigger o DAQ Trigger o Particle Trigger 1) Possible.

Who am I? ● Daniel John Kirby ● Carnegie Mellon Physics Class of 2013 ● In Hall A June-July 2012.

Outline Experiments Setup and DAQ configuration Fastbus for SBS: performance and status GEn/GMn - trigger and DAQ GEp - trigger and DAQ GEM readout Outline.

GEM Electronic System Status New releases of electronic boards: ◦ MPD v 4.0 ◦ Backplane 5 slot short (for UVa design) ◦ APV Front-End with Panasonic connector.

Hall A 12 GeV DVCS Status report December 16th 2013 Hall A collaboration meeting Alexandre Camsonne.

 Brief status update of DAQ/Trigger production hardware  Firmware development for HPS application  CLAS12 CTP ‘upgrade’ notes  Summary Status of the.

TID and TS J. William Gu Data Acquisition 1.Trigger distribution scheme 2.TID development 3.TID in test setup 4.TS development.

Trigger Supervisor (TS) J. William Gu Data Acquisition Group 1.TS position in the system 2.First prototype TS 3.TS functions 4.TS test status.

SBS/A1n DAQ status Alexandre Camsonne August 28 th 2012.

Hall A meeting October 15 th 2013 Alexandre Camsonne.

Hall A DAQ status and upgrade plans Alexandre Camsonne Hall A Jefferson Laboratory Hall A collaboration meeting June 10 th 2011.

LKr Calorimeter Control and monitoring R. Fantechi 19/02/2010 R. Fantechi.

SBS meeting VETROC application for Cerenkov triggering Alexandre Camsonne March 18 th 2015.

SBS meeting VETROC application for Cerenkov triggering Alexandre Camsonne March 18 th 2015.

25/05/2010 RD51 Collaboration Meeting Cisbani-Musico-Minutoli / Status JLab Electronics 1 Status of the APV25 electronics for the GEM tracker at JLab Evaristo.

06/07/041 F1TDC Status Update Hall D Collaboration Meeting Indiana University – Bloomington, IN May 20-22, 2004 Fernando J. Barbosa

David Abbott - JLAB DAQ group Embedded-Linux Readout Controllers (Hardware Evaluation)

March running preparation Alexandre Camsonne Hall A meeting February 28 th 2014.

Serial Data Link on Advanced TCA Back Plane M. Nomachi and S. Ajimura Osaka University, Japan CAMAC – FASTBUS – VME / Compact PCI What ’ s next?

SuperBigbite DAQ and Trigger electronics Alexandre Camsonne Hall A Jefferson Laboratory SBS Review.

Hall A DAQ meeting January 12 th Summary summary GMp /DVCS BCM / Unser Raster Summary Compton EDTM F1 TDC Halo monitor Gas Cerenkov SBS Fastbus.

12GeV Trigger Workshop Christopher Newport University 8 July 2009 R. Chris Cuevas Welcome! Workshop goals: 1.Review  Trigger requirements  Present hardware.

Costas Foudas, The Tracker Interface to TCS, The CMS Silicon Tracker FED Crates What goes in the FED Crates ? What do we do about the VME controller.

MOLLER DAQ Aug 2015 meeting Team : R. Michaels, P. M. King, M. Gericke, K. Kumar R. Michaels, MOLLER Meeting, Aug, 2015.

Sep. 17, 2002BESIII Review Meeting BESIII DAQ System BESIII Review Meeting IHEP · Beijing · China Sep , 2002.

DEPT OF MODERN PHYSICS, USTC Electronics System of MC IHEP, Beijing ___________________________________________ Muon Group, USTC, Hefei.

June 7, 2004Karen Dow CODA at Bates BLAST Data Acquisition.

SoLID review DAQ recommendations Alexandre Camsonne.

SoLiD/PVDIS DAQ Alexandre Camsonne. DAQ limitations Electronics Data transfer.

Trigger Meeting: Greg Iles5 March The APV Emulator (APVE) Task 1. –The APV25 has a 10 event buffer in de-convolution mode. –Readout of an event =

Jefferson Laboratory Hall A SuperBigBite Spectrometer Data Acquisition System Alexandre Camsonne APS DNP 2013 October 24 th 2013 Hall A Jefferson Laboratory.

Calibration of the gain and measurement of the noise for the apv25 electronics K. Gnanvo, N. Liyanage, C.Gu, K. Saenboonruang From INFN Italy: E. Cisbani,

Methods to reduce dead time and achieve higher trigger rate. Sparsification Event blocking Parallel DAQ systems SFI Sequencing.

CM19 Vassil Verguilov DAQ Status  Progress  DAQ  Next steps  Summary.

26/11/02CROP meeting-Nicolas Dumont Dayot 1 CROP (Crate Read Out Processor)  Specifications.  Topology.  Error detection-correction.  Treatment (ECAL/HCAL.

Electronics for HPS Proposal September 20, 2010 S. Boyarinov 1 HPS DAQ Overview Sergey Boyarinov JLAB June 17, 2014.

SBS/A1n Fast DAQ Alexandre Camsonne October 19 th 2012.

SoLID DAQ A.Camsonne SoLID collaboration meeting November 8 th 2013.

APEX DAQ rate capability April 19 th 2015 Alexandre Camsonne.

HPS TDAQ Review Sergey Boyarinov, Ben Raydo JLAB June 18, 2014.

MPD HW & firmware status UVa Back Tracker parts status SBS JLAB 1 16 December 2015 Paolo Musico and Evaristo Cisbani GEM Readout Update.

ATLAS SCT/Pixel TIM FDR/PRR28 June 2004 TIM Requirements - John Lane1 ATLAS SCT/Pixel TIM FDR/PRR 28 June 2004 Physics & Astronomy HEP Electronics John.

Level-1 Trigger Commissioning Status A.Somov Jefferson Lab Collaboration Meeting, May 10, 2010.

1 DAQ.IHEP Beijing, CAS.CHINA mail to: The Readout In BESIII DAQ Framework The BESIII DAQ system consists of the readout subsystem, the.

R. Michaels, JLAB PREX Mtg, July 2008 Compton DAQ (General) Remaining experts : Sirish Nanda, Alexandre Camsonne, me Recent Exercises Port to vxWorks 5.5.

Super BigBite DAQ & Trigger Jens-Ole Hansen Hall A Collaboration Meeting 16 December 2009.

DAQ and Trigger for HPS run Sergey Boyarinov JLAB July 11, Requirements and available test results 2. DAQ status 3. Trigger system status and upgrades.

ECAL electronics schedule JFMAMJJASONDJFMAM Prototype 2 boards Design Layout Fabrication and assembly Testing, including VFE prototype tests Production.

Gu Minhao, DAQ group Experimental Center of IHEP February 2011

CALICE Readout Board Front End FPGA

PID meeting SNATS to SCATS New front end design

14-BIT Custom ADC Board Rev. B

Counting Mode DAQ for Compton

Data Acquisition (DAQ) Status

Hall A Compton Electron detector overview

VETROC for Edet DAQ Bob Michaels (presenting) Scott Barcus Alexandre Camsonne Ben Raydo and the GRINCH group (Todd Averett et. al.) Compton Meeting.

Fernando J. Barbosa F1TDC Status Update Hall D Collaboration Meeting Indiana University – Bloomington, IN May 20-22, 2004 Fernando J.

Example of DAQ Trigger issues for the SoLID experiment

Alexandre Camsonne January 12th 2016 SoLID collaboration meeting

Alexandre Camsonne January 13th 2015

Alexandre Camsonne September 12th 2015 SoLID collaboration meeting

PID meeting Mechanical implementation Electronics architecture

August 19th 2013 Alexandre Camsonne

DAQ for SBS GEM SBS collaboration meeting August 6th 2019

Experiment DAQ and trigger GMn SBS Collaboration Meeting

Presentation transcript:

SBS / A1n DAQ Alexandre Camsonne 02/27/2013

APV25 Standard VME access ok : can configure board Check address assignment in VME64X crate Need to debug data transfer and try block transfer

Calorimeter cnugep and srcdaq configured on 36 subnetwork ( gave up with computer center to run on 88 subnetwork ) Using VME crate and one V792 for calorimeter Working on 1881 readout in case more channels needed

Fastbus 2 New TI borrowed from electronics group Old backplane TI not working, need to test them Readout of Fastbus in new TI (Sergey’s slide) Test event blocking : should improve about 30 %, need to work on new decoder : most likely ok to reach 10 KHz for A1n with 6 crates Need check board flipping for SBS ( 100 KHz L1/Fastclear and 3 KHz L2 ) Might get SFI and power supply from Bates

DAQ schemes 2 independent DAQ in parallel Pro : standard CODA, no synch issue Con : need twice more APV VME boards and need to split signal between the two 2 x electronics Split signals between the two APV signalFastbus signal APV Fastbus

DAQ schemes 1 DAQ, several Fastbus crates Pro : standard CODA, no synch issue Con : limited by front end busy when data transfer becomes negligible Fastbus APV Scatter channels To reduce readout deadtime

DAQ scheme 1 DAQ, several Fastbus crates Pro : Reduced front end dead time, only need Fastbus modules, splitting easy if use MQT by daisy chaining Con : Synchronization between boards need to be checked Fastbus APV N x Fastbus electronics Split signals between the N Read 1 / N board for each trigger

MQT Vicor power supply adapted Test without 8 V supply Works but noisy : electronics group will check it Need to make batch panel for input signals

Task list Fastbus inventory and test ( Sergey ) – SFI, GAC, ATC, 1881, 1877S, TI Test Fastbus buffering, event blocking and multicrate with new TI ( Sergey / Alexandre ) Module flipping ( Sergey / Alexandre ) Implement scaler crate and do deadtime measurement ( Alexandre ) APV work with Evaristo DAQ and test with CODA ( Alexandre ) MQT ( Electronics group )