Météo-France / CNRM – T. Bergot 1) Methodology 2) The assimilation procedures at local scale 3) Results for the 2002-2003 winter season Improved Site-Specific.

Slides:



Advertisements
Similar presentations
Introduction Irina Surface layer and surface fluxes Anton
Advertisements

Some questions on convection that could be addressed through another UK field program centered at Chilbolton Dan Kirshbaum 1.
Chapter 13 – Weather Analysis and Forecasting
SEASONAL sensitivity study on COBEL-ISBA LOCAL FORECAST SYSTEM for fog and low clouds at Paris CDG airport ROQUELAURE Stevie and BERGOT Thierry Météo-France.
Introduction to data assimilation in meteorology Pierre Brousseau, Ludovic Auger ATMO 08,Alghero, september 2008.
1D Dice Experiment at Meteo-France and LES preliminary result E. Bazile, I. Beau, F. Couvreux and P. Le Moigne (CNRM/GAME) DICE Workshop Exeter October.
Training course: boundary layer IV Parametrization above the surface layer (layout) Overview of models Slab (integral) models K-closure model K-profile.
Stratus. Outline  Formation –Moisture trapped under inversion –Contact layer heating of fog –Fog induced stratus –Lake effect stratus/strato cu  Dissipation.
The Problem of Parameterization in Numerical Models METEO 6030 Xuanli Li University of Utah Department of Meteorology Spring 2005.
PBL simulated from different PBL Schemes in WRF during DICE
The Use of High Resolution Mesoscale Model Fields with the CALPUFF Dispersion Modelling System in Prince George BC Bryan McEwen Master’s project
Fog Forecasting at Roissy Airport (Paris) with 1D model Thierry Bergot and Joël Noilhan Météo-France 1) Methodology Cobel : 1D model of boundary layer.
Climate modeling Current state of climate knowledge – What does the historical data (temperature, CO 2, etc) tell us – What are trends in the current observational.
6 th SMOS Workshop, Lyngby, DK Using TMI derived soil moisture to initialize numerical weather prediction models: Impact studies with ECMWF’s.
Challenges in data assimilation for ‘high resolution’ numerical weather prediction (NWP) Today’s observations + uncertainty information Today’s forecast.
1 Intercomparison of low visibility prediction methods COST-722 (WG-i) Frédéric Atger & Thierry Bergot (Météo-France)
Are the results of PILPS or GSWP affected by the lack of land surface- atmosphere feedback? Is the use of offline land surface models in LDAS making optimal.
Introduction to Numerical Weather Prediction and Ensemble Weather Forecasting Tom Hamill NOAA-CIRES Climate Diagnostics Center Boulder, Colorado USA.
Chapter 13 – Weather Analysis and Forecasting. The National Weather Service The National Weather Service (NWS) is responsible for forecasts several times.
Claire Sarrat, Joël Noilhan, Pierre Lacarrère, Sylvie Donier et al. Atmospheric CO 2 modeling at the regional scale: A bottom – up approach applied to.
MDSS Challenges, Research, and Managing User Expectations - Weather Issues - Bill Mahoney & Kevin Petty National Center for Atmospheric Research (NCAR)
Large-Eddy Simulation of a stratocumulus to cumulus transition as observed during the First Lagrangian of ASTEX Stephan de Roode and Johan van der Dussen.
THE EFFECT OF THE SURFACE CHARACTERISTICS ON THE DICE RESULTS SEEN BY THE MESONH MODEL M. A. Jiménez, P. Le Moigne and J. Cuxart DICE workshop, October.
Mesoscale Modeling Review the tutorial at: –In class.
An Analysis of Eta Model Forecast Soundings in Radiation Fog Forecasting Steve Amburn National Weather Service, Tulsa, OK.
ATD Research Needs and Priorities Panelists Dr. Jay Boris – Navy/NRL Mr. Walter Schalk – NOAA/ARL Mr. John Pace – DoD/DTRA Ms. Jocelyn Mitchell - NuRC.
Stephan F.J. De Wekker S. Aulenbach, B. Sacks, D. Schimel, B. Stephens, National Center for Atmospheric Research, Boulder CO; T. Vukicevic,
EU COST Action 722: The Understanding of Fog Structure, Development and Forecasting Presented on behalf of the 13 participant countries 1. Background.
Land Surface Analysis SAF: Contributions to NWP Isabel F. Trigo.
Météo-France / CNRM – T. Bergot 1) Introduction 2) The methodology of the inter-comparison 3) Phase 1 : cases study Inter-comparison of numerical models.
Accounting for Uncertainties in NWPs using the Ensemble Approach for Inputs to ATD Models Dave Stauffer The Pennsylvania State University Office of the.
Fog prediction in a 3D model with parameterized microphysics Mathias D. Müller 1, Matthieu Masbou 2, Andreas Bott 2, Zavisa I. Janjic 3 1) Institute of.
The mesoscale meteorological models Meso-NH and AROME C.Lac (CNRM/GMME) For the Meso-NH community and the AROME team « Astronomy meets Meteorology »,
Erik Crosman 1, John Horel 1, Chris Foster 1, Erik Neemann 1 1 University of Utah Department of Atmospheric Sciences Toward Improved NWP Simulations of.
Toward a mesoscale flux inversion in the 2005 CarboEurope Regional Experiment T.Lauvaux, C. Sarrat, F. Chevallier, P. Ciais, M. Uliasz, A. S. Denning,
An air quality information system for cities with complex terrain based on high resolution NWP Viel Ødegaard, r&d department.
Large-Eddy Simulations of the Nocturnal Low-Level Jet M.A. Jiménez Universitat de les Illes Balears 4th Meso-NH user’s meeting, Toulouse April 2007.
- tBM - topographical boundary layer model Dr. O. Liechti
Forecast simulations of Southeast Pacific Stratocumulus with CAM3 and CAM3-UW. Cécile Hannay (1), Jeffrey Kiehl (1), Dave Williamson (1), Jerry Olson (1),
Evaluating forecasts of the evolution of the cloudy boundary layer using radar and lidar observations Andrew Barrett, Robin Hogan and Ewan O’Connor Submitted.
Development of a one-dimensional version of the Hirlam-model in Sweden Background: This model has been run operationally for about nine years now. Mainly.
RICO Modeling Studies Group interests RICO data in support of studies.
Ensemble Kalman Filter in a boundary layer 1D numerical model Samuel Rémy and Thierry Bergot (Météo-France) Workshop on ensemble methods in meteorology.
Treatment of Small Scale Land Surface Heterogeneity for Atmospheric Modelling (SSSAM) Günther Heinemann (1) and Michael Kerschgens (2) 1 Meteorologisches.
T. Bergot - Météo-France CNRM/GMME 1) Methodology 2) Results for Paris-CdG airport Improved site-specific numerical model of fog and low clouds -dedicated.
Do better aerosol forecasts improve weather forecasts? A regional modeling and assimilation study. Mariusz Pagowski Stuart McKeen Georg Grell Ming Hu NOAA/ESRL,
DRAFT – Page 1 – January 14, 2016 Development of a Convective Scale Ensemble Kalman Filter at Environment Canada Luc Fillion 1, Kao-Shen Chung 1, Monique.
Modeling and Evaluation of Antarctic Boundary Layer
Observed Structure of the Atmospheric Boundary Layer
MM5 studies at Wageningen University (NL) Title Jordi Vilà (Group 4) NL North sea Radar MM5 NL North sea.
Federal Department of Home Affairs FDHA Federal Office of Meteorology and Climatology MeteoSwiss Poster Presentation Working Group 3: Physical Aspects.
Terradellas, E; Bergot, T A comparison between two single-column models designed for short-term fog and low clouds forecasting Terradellas, E. and T. Bergot.
EMS LJUBLJANA, 2006 Mathias D. Müller 1, C. Schmutz 2, E. Parlow 3 An ensemble assimilation and forecast system for 1D fog prediction 1,3) Institute of.
The Arctic boundary layer: Characteristics and properties Steven Cavallo June 1, 2006 Boundary layer meteorology.
Incrementing moisture fields with satellite observations
Evaluation of cloudy convective boundary layer forecast by ARPEGE and IFS Comparisons with observations from Cabauw, Chilbolton, and Palaiseau  Comparisons.
Implementation of a boundary layer heat flux parameterization into the Regional Atmospheric Modeling System Erica McGrath-Spangler Dept. of Atmospheric.
Land-Surface evolution forced by predicted precipitation corrected by high-frequency radar/satellite assimilation – the RUC Coupled Data Assimilation System.
E. Bazile, C. Soci, F. Besson & ?? UERRA meeting Exeter, March 2014 Surface Re-Analysis and Uncertainties for.
COAMPS ® Ducting Validation Wallops-2000 William Thompson and Tracy Haack Naval Research Laboratory Marine Meteorology Division Monterey, CA COAMPS ® is.
Soil analysis scheme for AROME within SURFEX
Meso-scale Model's Results
Case study of an urban heat island in London, UK: Comparison between observations and a high resolution numerical weather prediction model Siân Lane, Janet.
Coupled atmosphere-ocean simulation on hurricane forecast
Radiation Fog Forecasting Using a 1-D Model
WMO NWP Wokshop: Blending Breakout
Development of a three-dimensional short range forecast model
Characterizing the response of simulated atmospheric boundary layers to stochastic cloud radiative forcing Robert Tardif, Josh Hacker (NCAR Research Applications.
Low cloud and poor visibility FAOR South African Weather Service
Meteorological Measurements for Improved Air Quality Modeling
Presentation transcript:

Météo-France / CNRM – T. Bergot 1) Methodology 2) The assimilation procedures at local scale 3) Results for the winter season Improved Site-Specific Numerical Prediction of Fog and Low Clouds COBEL-ISBA 1D model The local forecast method 1D-Var / Fog / Low Clouds Fog and low clouds Boundary layer parameters 4) Prospectives Operational forecast at Paris CDG international airport Predictability

Mesoscale terms : ALADIN Advections Geostrophic wind clouds Turbulent processes (stable cases) Radiative processes (IR+vis) Microphysical processes (condensation-evaporation, sedimentation) Exchanges between soil, vegetation and atmosphere ISBA COBEL

Fine mesh vertical grid  First level : 0.5m  20 levels below 200m (Bergot 1993 ; Bergot and Guedalia 1994 ;Guedalia and Bergot, 1994) Physical parameterizations  High resolution radiation scheme (232 spectral intervals)  Turbulence scheme : turbulent kinetic energy (TKE)

Initialization / forcing (every 3h) Observations ISBA offline COBEL/ISBA Local fog forecasting formation formation visibility / vertical thickness visibility / vertical thickness clearance clearance Adjustment requirements / forecast guess Mesoscale NWP model (3D)

Meteorological tower of 30m : T / Hu% Ground measurements : T / W inside the soil (between ground and –50cm) short- and long-wave radiations Airport terminal 1: T / H% Radiation fluxes Since december 2002 International Paris CDG airport

Assimilation at local scale 1) Initialisation of dry atmosphere Methodology : variational assimilation 1D-Var Data : local observations, operational 3D NWP forecast 2) Initialisation of fog / low clouds 3) Initialisation of soil parameters Define the depth of the cloudy area (minimization of the model errors on the radiative fluxes divergence) Correction of the atmospheric profiles below and inside the cloudy area (dry / moist mixed area) Soil temperature and moisture have a strong influence on the surface cooling (energy budget at the surface : spin-up problem!) Offline version of the ISBA model, driven by observed atmospheric forcings

Guess = previous COBEL-ISBA forecast (3h) Altitude « observations » = 3D NWP Aladin forecast Surface observations = local data (30m tower, 2m obs.) Winter Bias = 0.0°C Std. Dev. = 0.3°C Temperature at 1m (observation) Temperature at 1m (CI Cobel-Isba) 1D-Var : T / q surface boundary layer Temperature at 1m (initial conditions)

cloud = mixed layer (moist variables) Assimilation of radiation fluxes at 2m and 45m IR fluxes when low clouds are detected Low clouds from Aladin bias=-41.9W/m2 low clouds from local assimilation bias=-1.0W/m2 3D operational NWP models are not able to give realistic forecasts (occurrence) of low clouds! Initialisation of low clouds

Results for the winter season : occurrence of LVP conditions / 30min LVP : visi<600m and/or ceiling<200ft Forecast time (h) Hit Ratio False Alarm Rate

Results for the winter season: 2m temperature

Results for the winter season : IR radiative fluxes

winter season : summary (dec2002-avr2003) 1) Accurate forecast requires detailled Boundary Layer obs + local assimilation scheme 2) Forecast quality Poor quality of mesoscale flow from operational NWP Measurements inside surface boundary layer (nocturnal inversion) Radiation fluxes measurement at 2 levels (divergence) Assimilation scheme at local scale 1D model can be an alternative tool for forecasting local parameters Forecast is helpful during the first 6h (poor quality of mesoscale flow from NWP!) Main problem : mesoscale clouds

 Ensemble forecast Study the predictability of fog and low cloud  Statistical postprocessing of local forecast One of the major pb of fog forecasting concerns the uncertainty on input parameters (extreme sensitivity in given meteorological situations) Define a common methodology of evaluation (reliability, resolution, …) : link with WG3 Uncertainties on initial data (link with WG1 + assimilation scheme at local scale) Uncertainties on mesoscale flow (clouds, mesoscale advections) Detailed local parameters (vertical inversion, etc!) Complex data (TKE, surface fluxes, etc!)

QUESTIONS!