1. GA Tech Safety and Health Consultation Program Fall Protection in Construction Work Tool Box Session

2. GA Tech Safety and Health Consultation Program INTRODUCTION This training information has been prepared by the Georgia Tech Safety and Health Consultation Program with the technical collaboration of Mr. Juán C. Rodriguez and under the sponsorship of OSHA. Its content may be copied and distributed for free. The Georgia Tech’s Safety and Health Consultation Program requests it be acknowledged as the source of this information. The authors believe that all information contained in this training is accurate; however, this is not an official OSHA publication and has not been revised or approved by OSHA. The user should be aware that the recommendations provided in this training do not replace any OSHA standard or regulation. Georgia Tech Safety and Health Consultation Program Georgia Tech Research Institute 260 14 th Street, Fourth Floor Atlanta, GA 30332-0837 Voice :(404) 407-7431 FAX :(404) 407-8275 Web http://www.oshainfo.gatech.edu

3. GA Tech Safety and Health Consultation Program DUTY TO HAVE FALL PROTECTION Required beginning at 6 feet (1.8 m) or more above a lower level

4. GA Tech Safety and Health Consultation Program > 6 feet

5. GA Tech Safety and Health Consultation Program Guardrail Systems Top rail height between 39" to 45" Midrail height: 20" Posts shall not be more than 8' apart Toeboards: minimum height of 3 ½"

6. GA Tech Safety and Health Consultation Program

7. Covers for Holes Any covering material placed on the opening shall be securely affixed The word HOYO / HOLE shall be written on the surface of the cover The cover must support at least: –Twice the weight of people walking, and/or –Twice the weight of the heaviest vehicle moving over the cover

8. GA Tech Safety and Health Consultation Program Labeled and securely fastened protective cover

9. GA Tech Safety and Health Consultation Program Lifelines and Landyards Synthetic ropes and straps (webbing) may be self-retracting must be impact absorbing Strong enough to withstand a tensional force of 5000 pounds Attachment point of body harness shall be located in the center of the wearer’s back near shoulder level

10. GA Tech Safety and Health Consultation Program

11. Anchorage Points Should be higher than the worker’s position Shall not allow a fall distance of more than 6' Shall withstand a minimum force of 5000 pounds Shall not be used to anchor anything except the worker

12. GA Tech Safety and Health Consultation Program Withstand 5000 lbs

13. GA Tech Safety and Health Consultation Program Positioning Device Systems It is not a fall protection system! It shall not allow a free fall of more than 2 feet Anchorage point capable of supporting 3000 lbs Shall be inspected before being used

14. GA Tech Safety and Health Consultation Program Anchorage point shall withstand 3000 pounds

15. GA Tech Safety and Health Consultation Program Controlled Access Zones Access limited to only workers involved in the job Control lines erected not less than 6' nor more than 25' from unprotected edge Shall be durably connected on each side

16. GA Tech Safety and Health Consultation Program Controlled access zone

17. GA Tech Safety and Health Consultation Program Warning Line System Used to warn workers of an area with unprotected edges Used only when a fall protection system is infeasible or impracticable Lines shall be durably supported

18. GA Tech Safety and Health Consultation Program > 6' from edge

19. GA Tech Safety and Health Consultation Program Safety Monitoring Systems The safety monitor shall: Be on the same walking/working surface and within visual sight distance of employees Be close enough to communicate orally with employees and warn them of hazards Not have other responsibilities, except to monitor worker safety

20. GA Tech Safety and Health Consultation Program SAFETY MONITOR