Download presentation
Presentation is loading. Please wait.
Published byRoxanne Allen Modified over 8 years ago
1
Tools of the Biologist
2
In order to observe, discover, and explore, scientists use many different pieces of lab equipment. A.Measuring Length 1. Meter stick, Ruler Each marked line represents 1 cm. The smaller lines between cm are mm. There are 10 mm in 1 cm There are 100 cm in 1 m
3
B. Measuring Volume 1.Graduated Cylinder Used to measure exact volumes To Use: Fill to the appropriate level. Note that liquid in a glass graduate cylinder curves upward at the edges. This is called the MENISCUS. Read the volume at the bottom of the meniscus when looking at eye level.
5
12 mL 16 mL 14 mL Pay attention to the scale of the graduate cylinder (How much the lines go up by)
6
B. Measuring Volume 2. Beaker Used to measure a approximate volume To use: fill with the appropriate volume There will not be much of a meniscus Read at eye level.
7
B. Measuring Volume 3. Erlenmeyer and Florence Flasks Used to measure an approximate volume And/or to mix solutions To use: same as beaker Erlenmeyer Florence
8
B. Measuring Volume 4. Pipette Used to measure an approximate volume Measures one drop at a time To use: (to fill) submerge, gently squeeze and release (to release) carefully squeeze 1 drop at a time
9
C. Measuring Mass 4. Electronic Balance Used to measure an exact mass To use: Turn on, zero the balance, set to correct unit, carefully place sample on tray. If sample is placed in a container subtract the mass of the container from the total mass
10
D. Tools for Dissection 1. Dissecting Pan Used to hold specimens in place To use: Lay the specimen on the tray and pin to the rubber bottom
11
D. Tools for Dissection 2. Dissecting Needle (Probe) Multi-purpose tools to move parts of the specimen
12
D. Tools for Dissection 3. Scalpel Use: to make precision cuts and/or take samples
13
D. Tools for Dissection 4. Forceps Use: to grasp and manipulate parts of a specimen
14
E. Using Chemicals 1. Test Tube/Test tube rack Use: to carry out chemical reactions When not in use, put in test tube rack
15
E. Using Chemicals 1. Test Tube Holder Use: to hold and move test tubes Squeeze handle so the clamp opens Release handles so the clamp closes around test tube
16
E. Using Chemicals 1. Test Tube Brush Use: cleans inside of test tube
17
F. Observing Specimens and Samples 1. Petri Dish Use: small dish to hold samples and/or grow bacterial samples.
18
G. Safety Equipment 1. Safety Goggles Use: Place over your eyes for protection
19
G. Safety Equipment 1. Safety Gloves Use: Place over your hands for protection from heat, chemicals, body fluids, etc
20
G. Observation 1. Compound Light Microscope Use: enlargement of microscopic specimens
22
1. Compound Light Microscope -Magnifies specimen 100s of times -“Compound” means it has several lenses 2. How to Use a Microscope -Always carry the microscope by the arm while supporting the base -Position the microscope so the arm is near to you -ALWAYS START WITH THE LOWEST POWER MAGNIFICATION
23
2. How to Use a Microscope (cont) -Center the slide on the stage -Center the specimen in the field of view (remember the image is inverted) -Use the coarse adjustment to focus the slide - -Once the slide is in focus, switch to a higher power then refocus with fine adjustment -ONLY USE THE FINE ADJUSTEMENT ONCE YOU’VE SWITCHED TO THE HIGH POWER LENS – IF NOT THE SLIDE WILL CRACK
24
Making a Wet Mount Slide Wet mounts are microscope slides that contain a specimen mounted in water. A cover slip (or cover glass) is used to flatten the specimen and the water drop. 1.Obtain a clean microscope slide and cover slip. Hold cover slips only by the edges. 2.Add a small drop of water to the slide. 3.Place the specimen in the drop of water. 4.Hold the cover slip at a 45˚ angle next to the drop of water, slide it over until it hits the water. Place it onto the water. This helps prevent air bubbles.
25
Adding a Stain/Chemical to Wet Mount Slide Stains: Chemicals added to a slide in order to see parts of a specimen more clearly.
27
Adding a Stain/Chemical to Wet Mount Slide Stains: Chemicals added to a slide in order to see parts of a specimen more clearly. 1.After making a wet mount slide, place a drop of stain on one side of the cover slip 2.Gently touch the other side of the cover slip with a piece of paper towel 3.The paper towel will “pull” the stain under the coverslip
29
Human Red Blood Cells
30
Plant CellsFly Head Sperm Cells Pollen
31
Cancer CellsWhooping Cough E Coli
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.